Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A solid cone has a base radius of 6 cm and a vertical height of 10 cm. Work out the volume of the cone. Use π = 3.14 and give your answer correct to 1 decimal place.
- 2.Two identical ladders lean against the same vertical wall from opposite sides, each making an angle of 58.2° with the ground. The two ladders and the ground form a triangle. Work out the size of the angle between the two ladders at the top, where they meet.
- 3.Two triangles are congruent to each other. What does this tell you about their angles and sides?
- 4.The diagram shows the plan, front elevation and side elevation of a solid. Which solid could this be?
- 5.A round cake has a radius of 10 cm. Icing costs £0.02 per square centimetre. One slice of the cake is a sector with an angle of 90°. Using π = 3.14, work out the cost of icing the top of that slice, to the nearest penny.
- 6.A rectangular garden bed measures 5 m by 3 m. A semicircular flower border is attached along one of the 3 m-wide ends, on the outside of the rectangle, so that the 3 m side is the diameter of the semicircle. Work out the total perimeter of the combined shape (the two long sides, the one remaining short side, and the curved edge). Use π = 3.14.
- 7.A rectangular name card has a perimeter of 30 cm. The card is 9 cm long. Work out the width of the card.
- 8.Point B is at (3, 5). It is reflected in the line y = 2. Work out the coordinates of the image of point B.
- 9.A landscaper marks out two triangular flower beds using stakes and a tape measure. Bed 1 has two edges of 5 m and 7 m, meeting at a corner with a marked angle of 60° between them. Bed 2 has edges of 5 m and 7 m, meeting at a corner also marked at 60° between them. The landscaper wants to check the two beds will be exactly the same size and shape using only these three measurements. Which condition proves the two beds are congruent?
- 10.In triangle ABC the angle at A is 90° and BC = 10 cm. For the angle at B, sin B = 3/5. Work out the length of AC.
- 11.A circle has circumference 31.4 cm. Using π = 3.14, work out the radius of the circle.
- 12.A cylindrical candle and a cone-shaped candle have the same base radius and the same height. State the cone's volume as a fraction of the cylinder's volume.
- 13.A robotic arm's tip starts at the point (12.5, −4.25) on a grid measured in centimetres. It moves by the vector to pick up a component, then by the vector to place it. Work out the coordinates of the tip after both moves.
- 14.Write down which one of these statements about quadrilaterals is true.
- 15.A polygon has one more side than a heptagon. What is the polygon called?
Answer key
- (a) 376.8 cm³ — Volume of a cone = (1/3)πr²h. Substitute r = 6 and h = 10: (1/3) × 3.14 × 6² × 10 = (1/3) × 3.14 × 36 × 10 = (1/3) × 1130.4 = 376.8 cm³.
- (d) 63.6 — Method: the three angles inside the triangle formed by the two ladders and the ground add up to 180°. Working: 180 − 58.2 − 58.2 = 63.6. Answer: 63.6°. A candidate who assumes the top angle equals the base angles gives 58.2. A candidate who subtracts only one base angle from 180°, working out 180 − 58.2, gets 121.8. A candidate who doubles the base angle instead of subtracting it twice from 180°, working out 2 × 58.2, gets 116.4.
- (d) All angles equal and all sides equal — Congruent triangles are identical in both shape and size, so every corresponding angle is equal and every corresponding side is equal, so 'all angles equal and all sides equal' is correct. 'All angles equal, sides may differ' describes 'similar' triangles, which have equal angles but sides in the same ratio rather than necessarily equal, not congruent ones. 'All sides equal, angles may differ' is not geometrically possible for triangles, since equal sides throughout force the angles to match too. 'Same area, angles and sides may differ' is wrong because equal area alone does not guarantee congruence; two triangles can share an area with completely different shapes.
- (a) A cuboid — Method: work out which solid has flat faces only, no curved surfaces and no point where edges meet, since only that gives rectangles for all three views. Working: a solid whose plan, front elevation and side elevation are all rectangles has three pairs of flat rectangular faces meeting at right angles — that is a cuboid. Answer: a cuboid. The distractors: a cylinder is wrong because its plan view (from above) is a circle, not a rectangle. A cone is wrong because its plan view is a circle and its front and side elevations are triangles. A square-based pyramid is wrong because its front and side elevations come to a point at the apex, giving triangles rather than rectangles, even though its plan view could be a square.
- (b) £1.57 — Slice area = (90 ÷ 360) × 3.14 × 10² = 0.25 × 314 = 78.5 cm². Cost = 78.5 × £0.02 = £1.57. (£0.16 comes from forgetting to square the radius, using 0.25 × 3.14 × 10 for the area; £6.28 comes from finding the area of the whole cake and forgetting the angle fraction; £0.31 comes from using the arc length formula instead of the sector area formula.)
- (c) 17.71 m — The perimeter is the two long sides (5 m + 5 m = 10 m) plus the one remaining short side (3 m) plus the curved semicircular edge. The 3 m side is the diameter of the semicircle, so its radius is 3 ÷ 2 = 1.5 m and the curved length is half the circumference: (1/2) × 2 × 3.14 × 1.5 = 4.71 m. Total: 10 + 3 + 4.71 = 17.71 m.
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
- (b) (3, −1) — Method: find the distance from the point to the mirror line, then place the image the same distance on the other side of the line. Working: B is 5 − 2 = 3 units above the line y = 2, so its image is 3 units below the line, at y = 2 − 3 = −1, giving (3, −1); the x-coordinate does not change, since the mirror line is horizontal. Options: (3, −5) comes from reflecting in the x-axis (y = 0) instead of the line y = 2; (−3, 5) comes from reflecting in the y-axis instead of a horizontal line; (3, −4) comes from doubling the distance from the line instead of reflecting it, giving 2 − 2×3 = −4. Answer: (3, −1).
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (b) 6 cm — Method: the right angle is at A, so BC is the hypotenuse and AC is the side opposite the angle at B; sin B = opposite ÷ hypotenuse therefore gives AC ÷ BC = 3/5. Working: AC ÷ 10 = 3/5, so AC = 10 × 3 ÷ 5 = 6. Answer: 6 cm. The distractors: 8 cm is AB, the side next to the angle at B, which is what cos B = 4/5 produces — the right method used on the wrong side; 3 cm comes from reading the 3 in the ratio as a length and never scaling it up to the 10 cm hypotenuse; 30 cm comes from multiplying by 3 and forgetting to divide by 5.
- (c) 5 cm — Diameter = circumference ÷ π, so 31.4 ÷ 3.14 = 10 cm, and the radius is half the diameter, so 10 ÷ 2 = 5 cm. 10 cm is the diameter itself, given as the radius by forgetting the final halving step. 15.7 cm comes from halving the circumference, 31.4 ÷ 2 = 15.7, and stopping there, treating half the circumference as the radius without ever dividing by π. 2.5 cm comes from halving the correct radius again, effectively dividing by 2 twice instead of once.
- (c) One third of the cylinder's volume — Volume of a cylinder = base area × height. Volume of a cone = 1/3 × base area × height. For the same base radius and height, the cone's volume is exactly one third of the cylinder's, so it uses less wax. A student who thinks the cone is half the cylinder's volume has confused it with a different solid's ratio. A student who thinks the two volumes are the same has ignored the 1/3 factor in the cone formula entirely. A student who thinks the cone is two thirds of the cylinder's volume has the right idea that it is a fraction, but the wrong fraction.
- (d) (11, 0.75) — Add the moves to the starting point one component at a time. x: 12.5 + (−3.75) + 2.25 = 11; y: −4.25 + 6.5 + (−1.5) = 0.75, giving (11, 0.75). (8.75, 2.25) stops after the first move only and never applies the second vector. (6.5, 3.75) comes from subtracting the second vector instead of adding it. (0.75, 11) comes from swapping the final x-coordinate and y-coordinate.
- (a) Every square is a rectangle — Method: test each statement against the definitions. A rectangle is a quadrilateral with four right angles and opposite sides equal; a square is a quadrilateral with four right angles and all four sides equal; a rhombus is a quadrilateral with all four sides equal. Working: a square has four right angles and its opposite sides are equal, so every square meets the definition of a rectangle and the statement that every square is a rectangle is true. Answer: every square is a rectangle. The distractors: the claim that every rectangle is a square reverses the inclusion, and fails for any rectangle whose length and width differ; the claim that every rhombus is a rectangle treats four equal sides as enough, and drops the right-angle condition — a tilted rhombus has no right angles; the claim that every rectangle is a rhombus reads 'opposite sides equal' as though it meant 'all four sides equal'.
- (c) octagon — A heptagon has 7 sides. One more than 7 is 8, and the polygon with 8 sides is an octagon. hexagon (6 sides) comes from subtracting one instead of adding one. heptagon (7 sides) is just the number of sides already given in the question, not one more than that. nonagon (9 sides) comes from adding two instead of one.
Build your own mix at the worksheet builder.