Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A water tank holds 2.5 m³. Work out this volume in cm³.
- 2.Work out the exact value of sin 30° + cos 60°.
- 3.A drone starts at the point (2, −3) on a coordinate grid. It flies by the vector and then by the vector . Write down the column vector that would take the drone straight back to its starting point.
- 4.A square tile has sides of length 6 cm. Work out the area of the tile.
- 5.Work out the length of the straight line segment joining the points (2, −4) and (−3, −4).
- 6.A straight transversal crosses a pair of parallel lines. At one crossing point, the angle between the transversal and a parallel line is 118°. Work out the size of the co-interior (allied) angle at the other crossing point.
- 7.The column vector r has top number 2 and bottom number 6. Which of these column vectors is parallel to r?
- 8.Each of these has an exact value. Write down the one whose value is the greatest.
- 9.How many vertices does a cylinder have?
- 10.A cylinder has a radius of 3 cm and a height of 10 cm. Using π = 3.14, work out the volume of the cylinder. Give your answer to the nearest whole number of cubic centimetres.
- 11.Two angles lie on a straight line. One angle is 37°. Work out the size of the other angle.
- 12.Two angles lie on a straight line. One angle is 118°. Which reason correctly explains why the other angle is 62°?
- 13.The vector describes a translation. A student writes it as by mistake. Write down what error the student has made.
- 14.Vector A is and vector B is . Write down how vector B compares to vector A.
- 15.Priya says: 'To find the arc length of a sector, you divide the circumference by the angle in degrees.' Which statement about Priya's method is correct?
Answer key
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
- (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (c) 36 cm² — Method: the area of a square is its side length multiplied by itself. Working: 6 × 6 = 36. Answer: 36 cm². The distractors: 24 cm comes from working out the perimeter, 4 × 6, which is a length and not an area; 12 cm comes from doubling the side, 6 × 2, instead of squaring it; 18 cm² comes from halving the product, (6 × 6) ÷ 2, using the rule for the area of a triangle.
- (b) 5 — Method: the two points have the same y-coordinate, so the segment joining them runs horizontally and its length is the gap between the two x-coordinates; a length is a distance, so it is never negative. Working: the x-coordinates are 2 and −3, so the gap is 2 − (−3) = 2 + 3 = 5. Both points have y = −4, so there is no vertical part to add on. Answer: 5. The distractors: 1 comes from dropping the minus sign on −3 and working out 3 − 2 instead; 0 comes from subtracting the y-coordinates, which are equal, in place of the x-coordinates; 6 comes from counting the grid lines from −3 across to 2 inclusive, which counts one more than the number of gaps between them.
- (c) 62° — Co-interior (allied) angles on parallel lines sum to 180°, so the co-interior angle is 180° − 118° = 62°. 118° comes from treating the angles as corresponding angles, which are equal, instead of co-interior angles, which sum to 180°. 59° comes from halving the given angle. 236° comes from doubling the given angle.
- (a) (3, 9) — Two column vectors are parallel only when one is the other multiplied by a single scalar — both numbers scaled by the same factor with the same sign. r has top:bottom ratio 2:6, which simplifies to 1:3. (3, 9) has ratio 3:9, also 1:3, so (3, 9) = 1.5 × r: it is parallel to r. (6, 2) swaps the top and bottom numbers of r, giving ratio 6:2 (3:1), which is not the same ratio. (2, 3) halves only the bottom number of r, giving ratio 2:3, not 1:3. (−2, 6) changes the sign of only the top number of r, giving ratio −2:6, which no longer matches 2:6 throughout.
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (d) 0 — A vertex is a sharp corner point where edges meet. A cylinder has two curved, circular edges but no sharp corner points at all, so it has 0 vertices, making that the correct answer. '2' wrongly treats the two circular edges themselves as vertices, but an edge is not the same as a vertex. '4' overcounts by treating each circular edge as if it had two end-vertices, which does not apply to a continuous curved edge. '1' wrongly imagines the curved surface itself forming a single corner point, which it does not.
- (d) 283 cm³ — Volume of a cylinder = πr²h. Using π = 3.14: V = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6, which rounds to 283 cm³. A pupil who uses the diameter, 6 cm, instead of the radius gets 3.14 × 6² × 10 = 1130.4 ≈ 1130 cm³. A pupil who forgets to square the radius gets 3.14 × 3 × 10 = 94.2 ≈ 94 cm³. A pupil who uses the circumference formula 2πr instead of πr² gets 2 × 3.14 × 3 × 10 = 188.4 ≈ 188 cm³. The correct volume is 283 cm³.
- (a) 143° — Angles on a straight line add up to 180°. Set up 37° + x = 180°. Subtract: x = 180° − 37° = 143°. 53° comes from using 90° as the total, as if the two angles made a right angle, instead of the 180° of a straight line.
- (b) angles on a straight line add up to 180° — 118° and 62° add up to 180°, matching the fact that angles on a straight line always add up to 180° — that is the reason the second angle is 62°. Angles round a point add up to 360° is a different fact, used for angles surrounding a single point, not two angles on a line. Vertically opposite angles are equal would make the second angle 118° too, not 62°. Angles in a triangle add up to 180° is a true fact, but it applies to the three angles inside a triangle, not two angles on a straight line.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (d) B is the reverse of A — Every component of vector B is the negative of the matching component of vector A (−2 is the negative of 2, and 5 is the negative of −5), so B undoes the translation that A performs — B is the reverse of A. 'B is the same as A' ignores that both signs have flipped. 'B is twice A' confuses a sign change with a scale-factor change; the sizes of the components have not changed, only their signs. 'B is unrelated to A in direction' misses that the two vectors are directly linked, just in opposite directions.
- (a) Wrong: multiply by angle ÷ 360, not divide by it. — The arc length is the fraction angle ÷ 360 of the circumference, and that fraction is MULTIPLIED by the circumference — it is never divided by the angle itself. So Priya's method, dividing by the angle, is wrong, and the correct statement names both the fraction and the multiplication. Saying she is correct accepts her wrong division. Saying the arc length is the full circumference multiplied by the angle in degrees, with no division at all, drops the 360 that turns the angle into a fraction. Saying the arc length is the radius multiplied by the angle in degrees swaps the circumference for the radius, which is a different and, in degrees, incorrect formula.
Build your own mix at the worksheet builder.