Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A roof truss is shaped like an isosceles triangle resting on a horizontal ceiling joist. The truss's sloping edges are equal in length, and the angle at its apex is 40°. The ceiling joist continues in a straight line beyond the foot of the truss. Work out the angle between the truss's sloping edge and the extended joist, on the outside of the truss.
- 2.The diagram shows a cuboid. Work out the area of its front elevation, in square centimetres.
- 3.An angle is measured with a protractor as 47°. What type of angle is this?
- 4.A trundle wheel has a diameter of 0.5 m. It is rolled along the ground and makes 20 complete turns. Using π = 3.14, work out the total distance rolled, in metres.
- 5.A sector has an angle of 45°. Priti says: 'The area of the sector is one eighth of the area of the full circle, whatever the radius is.' Is Priti correct?
- 6.e is the column vector with top number 5 and bottom number k. f is the column vector with top number 15 and bottom number 6. Given that f is 3 times e, work out the value of k.
- 7.A hexagonal prism lies on a table. A flat cut is made straight across it, at right angles to its length (so the cut is parallel to the two identical end faces). What shape is the cross-section?
- 8.Write down the exact value of tan 45°.
- 9.In kite WXYZ, WX = WZ and XY = ZY (so at each of X and Z, one side from each of the two unequal pairs meets). Angle X = 100°. Work out angle Z.
- 10.A parallelogram has an area of 96 cm² and a base of 8 cm. Work out the perpendicular height of the parallelogram.
- 11.The sum of the interior angles of a polygon is 1980°. Work out the number of sides of the polygon.
- 12.Triangle T has a vertex at (8, 4). It is enlarged by a scale factor of 1/2, centre (2, 4). Work out the coordinates of the image of this vertex.
- 13.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 14.A trapezium has parallel sides of 5.6 cm and 8.4 cm, and a perpendicular height of 4 cm. Work out the area of the trapezium.
- 15.Write down which quadrant contains the point (−3, 5) when plotted on a coordinate grid.
Answer key
- (a) 110° — The truss is isosceles, so its two base angles are equal; since the three angles of the triangle add up to 180° and the apex is 40°, each base angle is (180 − 40) ÷ 2 = 70°. The angle between the sloping edge and the joist, extended beyond the base of the truss, sits on a straight line with that 70° base angle, and angles on a straight line add up to 180°, so the required angle is 180 − 70 = 110°. "70°" comes from stopping after finding the base angle and giving it directly, without also using the straight-line fact to find the angle on the OUTSIDE of the truss. "140°" comes from doubling the base angle instead of using the straight-line fact. "20°" comes from taking half of the apex angle (40° ÷ 2), mistaking it for the required angle instead of properly using the triangle's angle sum.
- (c) 24 cm² — Method: the front elevation of a cuboid is a rectangle formed by the cuboid's length and its height, so its area is length × height. Working: 6 cm × 4 cm = 24 cm². Answer: 24 cm². The distractors: 12 cm² comes from using width × height (3 × 4) instead of length × height, mistaking the side elevation's dimensions for the front's. 18 cm² comes from using length × width (6 × 3), which gives the area of the plan view instead of the front elevation. 20 cm² comes from finding the perimeter of the front face instead of its area: 2 × (6 + 4) = 20.
- (b) Acute — An acute angle is any angle less than 90°. Since 47° is less than 90°, it is acute. An obtuse angle is between 90° and 180°, which 47° is not. A reflex angle is greater than 180°, which is far too big for 47°. A right angle is exactly 90°, not 47°. The angle is acute.
- (a) 31.4 — Method: first find the circumference of one turn using π × diameter, then multiply by the number of turns. Working: circumference = 3.14 × 0.5 = 1.57 m; total distance = 1.57 × 20 = 31.4 m. A student who answers 15.7 has mistakenly halved the diameter again before multiplying, using 0.25 m instead of 0.5 m. A student who answers 3.14 has simply written down π itself, without completing the circumference or multiplying by the number of turns. A student who answers 62.8 has mistakenly doubled the diameter to 1 m before multiplying, treating the given length as a radius. Answer: 31.4 m.
- (d) Yes, because 45 ÷ 360 = 1/8, and this fraction applies to any radius. — Priti is correct: 45 ÷ 360 = 1/8, and because sector area = (angle ÷ 360) × full circle area, this fraction depends only on the angle, not on the radius, so it holds for every circle. (The statement giving 45 ÷ 360 = 1/6 comes from an arithmetic slip when simplifying the fraction; the statement that the fraction depends on the radius is wrong because the radius cancels out of the angle fraction in the sector-area formula; the statement adding that it only works for this particular radius is wrong because the 1/8 fraction is true for every radius, not a special case.)
- (d) 2 — Method: if f is 3 times e, then each part of f equals 3 times the matching part of e. Working: using the bottom numbers, 6 = 3 × k, so k = 2. Answer: k = 2. A candidate who multiplies instead of dividing, working out 6 × 3, gets 18. A candidate who uses the top numbers' ratio instead, 15 ÷ 5, and gives that ratio as k gets 3. A candidate who adds instead of using the multiple relationship, working out 6 + 3, gets 9.
- (b) Hexagon — Cutting straight across a prism, at right angles to its length, always gives a cross-section that is the same shape as its end faces. The end faces of a hexagonal prism are hexagons (6-sided), so the cross-section is a hexagon. Choosing Pentagon comes from miscounting the sides of the hexagonal end as five instead of six. Choosing Rectangle comes from cutting along the LENGTH of the prism instead of across it, which gives a rectangular face, not the cross-section asked for. Choosing Triangle comes from confusing a hexagonal prism with a triangular prism.
- (d) 1 — At 45° the right-angled isosceles triangle has both shorter sides equal, so tan 45° = opposite ÷ adjacent = 1 ÷ 1 = 1. 0 is the value of tan 0° (mixing up the two angles). √3 is the value of tan 60°. √3/3 (equivalent to 1/√3) is the value of tan 30°.
- (a) 100° — In a kite, the pair of angles between the unequal sides are equal to each other. Angle X and angle Z are both between one side from the WX/WZ pair and one side from the XY/ZY pair, so angle Z = angle X = 100°.
- (a) 12 cm — Area of a parallelogram = base × perpendicular height, so height = area ÷ base = 96 ÷ 8 = 12 cm. A student who adds the area and base instead of dividing gets 96 + 8 = 104 cm. A student who multiplies the area and base instead of dividing gets 96 × 8 = 768 cm. A student who uses the triangle area formula, area = 1/2 × base × height, instead of the parallelogram formula solves 96 = 1/2 × 8 × h and gets h = 24 cm.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (b) 28 cm² — Area of a trapezium = (sum of parallel sides) ÷ 2 × height. Sum of parallel sides = 5.6 + 8.4 = 14 cm. Half of that is 14 ÷ 2 = 7 cm. Area = 7 × 4 = 28 cm². A pupil who forgets to halve gets 14 × 4 = 56 cm². A pupil who uses only the longer parallel side, as if this were a rectangle, gets 8.4 × 4 = 33.6 cm². A pupil who subtracts the parallel sides instead of adding them gets (8.4 − 5.6) ÷ 2 × 4 = 1.4 × 4 = 5.6 cm². The correct area is 28 cm².
- (b) second quadrant — The point (−3, 5) has a negative x-coordinate and a positive y-coordinate, and this combination lies in the second quadrant. The first quadrant needs both coordinates positive. The third quadrant needs both coordinates negative. The fourth quadrant needs a positive x-coordinate and a negative y-coordinate.
Build your own mix at the worksheet builder.