Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A cylinder has a radius of 3 cm and a height of 10 cm. Using π = 3.14, work out the volume of the cylinder. Give your answer to the nearest whole number of cubic centimetres.
- 2.A quadrilateral has vertices A(1, 1), B(5, 1), C(6, 4) and D(2, 4). By comparing the y-coordinates of A, B and of D, C, write down whether the sides AB and DC are parallel, and give a reason for your answer.
- 3.Every point on a circle is exactly the same distance from one particular point. Write down the name of that point.
- 4.A ramp rises at 30° to the horizontal. Its sloping surface is 4.8 m long. Safety rules say the vertical rise of a ramp must be no more than 2.5 m. Work out how far below that limit the rise of this ramp is.
- 5.A rectangular garden bed measures 5 m by 3 m. A semicircular flower border is attached along one of the 3 m-wide ends, on the outside of the rectangle, so that the 3 m side is the diameter of the semicircle. Work out the total perimeter of the combined shape (the two long sides, the one remaining short side, and the curved edge). Use π = 3.14.
- 6.A square-based pyramid is cut by a flat plane parallel to its base, partway up between the base and the apex. What shape is the cross-section?
- 7.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 8.Which of the following is NOT one of the four basic conditions used to prove two triangles are congruent?
- 9.A radar station is at the origin of a grid, where each unit represents 1 km. A boat is detected at the point (7, 24). Work out the boat's distance from the station, then work out how many hours it will take the boat to reach the station travelling directly towards it at 5 km per hour.
- 10.A gardener wants to plant a tree so that it is the same distance from two straight garden walls that meet at a corner, and also the same distance from two ornamental posts standing 4 m apart. Which construction locates this point?
- 11.Write down the column vector that describes a translation of 5 units to the left and 3 units down.
- 12.A sprinkler waters a sector-shaped patch of a garden with radius 8 m and angle 90°. Work out the perimeter of the watered sector, to 1 decimal place. (Use π = 3.14.)
- 13.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 14.Two similar triangular tiles have lengths in the ratio 3 : 5. The longest side of the smaller tile is 9 cm. Work out the length of the longest side of the larger tile.
- 15.A parallelogram has an area of 54 cm² and a base of 9 cm. Work out its perpendicular height.
Answer key
- (d) 283 cm³ — Volume of a cylinder = πr²h. Using π = 3.14: V = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6, which rounds to 283 cm³. A pupil who uses the diameter, 6 cm, instead of the radius gets 3.14 × 6² × 10 = 1130.4 ≈ 1130 cm³. A pupil who forgets to square the radius gets 3.14 × 3 × 10 = 94.2 ≈ 94 cm³. A pupil who uses the circumference formula 2πr instead of πr² gets 2 × 3.14 × 3 × 10 = 188.4 ≈ 188 cm³. The correct volume is 283 cm³.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (d) The centre — Method: sort the four names by what kind of object each one is, because only one of them names a single point rather than a line or a curve. Working: a chord is a straight line joining two points on the circle; a diameter is the special chord that runs right across the circle through the middle, so it too is a line; an arc is a piece of the circle's own curve. That leaves one name, and it belongs to the point from which every radius is drawn, which is why every point on the circle is the same distance from it. Answer: The centre. The distractors: The chord is picked by a candidate who reads 'the same distance' as a line of fixed length rather than as a point; The diameter is picked by a candidate who names the line that passes through the point instead of the point itself; The arc is picked by a candidate who hunts for a part of the circle's own curve rather than for a point inside it.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (c) 17.71 m — The perimeter is the two long sides (5 m + 5 m = 10 m) plus the one remaining short side (3 m) plus the curved semicircular edge. The 3 m side is the diameter of the semicircle, so its radius is 3 ÷ 2 = 1.5 m and the curved length is half the circumference: (1/2) × 2 × 3.14 × 1.5 = 4.71 m. Total: 10 + 3 + 4.71 = 17.71 m.
- (c) Square — Because the cut is parallel to the square base, it produces a shape that is similar to the base — the same shape, scaled down — so it is also a square, with four equal sides, smaller than the base. A candidate who looks at the sloped triangular faces instead of at the horizontal cut answers triangle. A candidate who pictures a slanted cut, which would shorten one pair of sides, answers trapezium, but a cut parallel to the base scales all four sides by the same amount. A candidate who counts an extra side, perhaps including an edge of the base, answers pentagon. The cross-section is a square.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (c) SSA — Method: recall the four basic congruence criteria for triangles and compare them with each option. Working: the four basic conditions are SSS, SAS, ASA and RHS. SSA (two sides and a non-included angle) is not one of them, because knowing two sides and an angle that is not between them does not always fix a unique triangle. Options: SSS, ASA and RHS are each genuine congruence conditions, so none of them is the correct answer to 'which is NOT'. Answer: SSA.
- (c) 5 hours — The distance from the origin to (7, 24) is √(7² + 24²) = √(49 + 576) = √625 = 25 km. Travelling at 5 km per hour, the time taken is 25 ÷ 5 = 5 hours. 25 hours mistakes the distance itself for the time, forgetting to divide by the speed. 125 hours comes from multiplying the distance by the speed, 25 × 5, instead of dividing. 0.2 hours comes from dividing the speed by the distance, 5 ÷ 25, the wrong way round.
- (a) where the angle bisector meets the posts' perpendicular bisector — Being equidistant from the two walls means lying on the angle bisector of the corner; being equidistant from the two posts means lying on the perpendicular bisector of the 4 m segment joining them. A single point satisfying both conditions is wherever those two loci cross. "where the angle bisector meets the line joining the posts" uses the straight line between the posts instead of its perpendicular bisector — a point on that line is not generally equidistant from both posts. "the perpendicular bisector of the posts, alone" satisfies only the posts condition, ignoring the walls entirely. "the angle bisector of the corner, alone" satisfies only the walls condition, ignoring the posts entirely.
- (d) $\binom{−5}{−3}$ — Left is a negative horizontal move and down is a negative vertical move, so the vector is $\binom{−5}{−3}$. $\binom{5}{−3}$ comes from treating 'left' as a positive move. $\binom{−5}{3}$ comes from treating 'down' as a positive move. $\binom{−3}{−5}$ comes from swapping the horizontal and vertical components.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (c) 15 cm — Method: going from the smaller tile to the larger one, every length is multiplied by the scale factor 5 ÷ 3. Working: 9 ÷ 3 = 3, and 3 × 5 = 15. Answer: 15 cm. The distractors: 11 cm comes from adding the difference between the parts of the ratio, 5 − 3 = 2, to the 9 cm side, treating a ratio as a gap rather than a multiplier; 45 cm comes from multiplying by 5 and forgetting to divide by 3; 27 cm comes from multiplying by 3, which is the part of the ratio belonging to the smaller tile.
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
Build your own mix at the worksheet builder.