Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A ramp rises at 30° to the horizontal. Its sloping surface is 4.8 m long. Safety rules say the vertical rise of a ramp must be no more than 2.5 m. Work out how far below that limit the rise of this ramp is.
- 2.Point C is at (2, 3). It is rotated 90° clockwise about the origin. Work out the coordinates of the image of point C.
- 3.Two similar triangles have lengths in the ratio 3 : 4. The perimeter of the smaller triangle is 24 cm. Work out the perimeter of the larger triangle.
- 4.In triangle ABC the angle at A and the angle at C are equal. The side AB is extended beyond B, and the exterior angle formed at B measures 98°. Work out the size of the angle at A.
- 5.A roof has two triangular sections, P and Q. Section P has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them. Section Q has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them, arranged the same way round. A roofer wants to cut identical triangular felt panels for both sections without measuring Section Q separately. Which condition confirms that the two sections are congruent?
- 6.A tile manufacturer cuts a hexagonal tile so that all six sides measure exactly 4 cm, but a check shows only two pairs of the six interior angles are equal to each other, not all six angles. The customer's order specifies regular hexagonal tiles. Based on the check, is this tile a regular hexagon?
- 7.A tap fills a tank at a rate of 18 litres per minute. The tank holds 0.45 m³. Work out how long the tap takes to fill the tank.
- 8.Triangle T has a vertex at (2, 1). It is enlarged by a scale factor of 3, centre (0, 0). Work out the coordinates of the image of this vertex.
- 9.A landscaper marks out two triangular flower beds using stakes and a tape measure. Bed 1 has two edges of 5 m and 7 m, meeting at a corner with a marked angle of 60° between them. Bed 2 has edges of 5 m and 7 m, meeting at a corner also marked at 60° between them. The landscaper wants to check the two beds will be exactly the same size and shape using only these three measurements. Which condition proves the two beds are congruent?
- 10.A straight line passes through points A, B and C, with B between A and C. A fourth point D is not on the line. Angle ABD = 132°. Work out the size of angle DBC.
- 11.Triangle T has a vertex at (8, 4). It is enlarged by a scale factor of 1/2, centre (2, 4). Work out the coordinates of the image of this vertex.
- 12.Triangle DEF is isosceles, with DE = DF. Angle E = 58°. Give a reason why angle F = 58°.
- 13.A solid has 6 faces and 8 vertices. Using the formula F + V − E = 2, work out how many edges it has.
- 14.Triangle ABC has AB = 10 cm, BC = 7 cm and angle A = 40°. Triangle DEF has DE = 10 cm, EF = 7 cm and angle D = 40°. Sam says the two triangles are congruent by SAS. Which statement about Sam's claim is correct?
- 15.A triangle has a base of 8 cm and a perpendicular height of 5 cm. Work out its area.
Answer key
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (b) (3, −2) — A 90° clockwise rotation about the origin maps (x, y) to (y, −x): (2, 3) → (3, −2). A pupil who uses the rule for a 90° anticlockwise rotation instead, (x, y) → (−y, x), gets (−3, 2). A pupil who uses the rule for a 180° rotation, (x, y) → (−x, −y), gets (−2, −3). A pupil who swaps the coordinates but forgets to change any sign gets (3, 2). The correct image is (3, −2).
- (c) 32 cm — Method: a perimeter is lengths added together, so it scales by the length scale factor itself, which is 4 ÷ 3 going from the smaller triangle to the larger one — not by its square. Working: 24 ÷ 3 = 8, and 8 × 4 = 32. Answer: 32 cm. The distractors: 18 cm comes from multiplying by 3 ÷ 4, scaling from the larger triangle down to the smaller one; 25 cm comes from adding the difference between the parts of the ratio, 4 − 3 = 1, to the perimeter; 8 cm comes from dividing by 3 and stopping there, before multiplying by 4.
- (a) 49° — Method: an exterior angle of a triangle equals the sum of the two interior angles that are not next to it, which here are the angles at A and at C; since those two are equal, the exterior angle is twice the angle at A. Working: 2 × angle A = 98, so angle A = 98 ÷ 2 = 49. Answer: 49°. The distractors: 82° is the interior angle at B, 180 − 98, given in place of the angle at A; 41° comes from finding that interior angle of 82° and halving it, 82 ÷ 2, instead of halving the exterior angle; 98° comes from taking the exterior angle to be equal to the angle at A on its own, with no halving at all.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (d) No — angles must be equal too — A regular polygon must have both all sides equal and all angles equal. This tile has all six sides equal, but its interior angles are not all equal, so it fails the angle condition and is not regular — 'No — angles must be equal too' is correct. 'Yes — all sides are equal' is wrong because equal sides alone are not enough; a shape can have equal sides but unequal angles, as here. 'Yes — six equal sides means regular' is wrong for the same reason: equal sides do not automatically guarantee equal angles. 'No — hexagons can't be regular' is wrong because regular hexagons certainly exist (six equal sides and six equal 120° angles); it is this particular tile that fails to be regular, not hexagons in general.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (b) 48° — Angles on a straight line add up to 180°, so angle ABD + angle DBC = 180°. 180° − 132° = 48°, so angle DBC = 48°. A student who uses angles around a point (360°) instead of a straight line (180°) finds 360° − 132° = 228°. A student who halves angle ABD by mistake, thinking DBC must be half of ABD, gets 132° ÷ 2 = 66°.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (d) Base angles of an isosceles triangle are equal — DE = DF, so triangle DEF is isosceles with DE and DF as the two equal sides. The base angles opposite those equal sides, angle E and angle F, are therefore equal to each other. Angle F = 58°. A student who instead quotes 'Angles in a triangle sum to 180°' has picked a true fact about triangles, but that fact finds a missing angle from the other two — it does not explain why two angles are equal to each other. A student who quotes 'Angles on a straight line sum to 180°' has confused this with a straight-line angle fact, but no straight line of angles is described in this triangle.
- (d) 12 — Method: rearrange F + V − E = 2 so that E is on its own: E = F + V − 2. Working: E = 6 + 8 − 2 = 12. A student who answers 14 has added F and V but forgotten to subtract 2 at all. A student who answers 16 has added 2 instead of subtracting it. A student who answers 10 has subtracted 2 twice by mistake. Answer: 12 edges.
- (d) Wrong - the given angle is not the included angle — Sides AB and BC meet at vertex B, so the included angle needed for SAS is angle B, not angle A — the information given is SSA. SSA does not prove congruence: with AB = 10 cm, BC = 7 cm and angle A = 40° there are two different triangles that fit, one with angle C ≈ 74.6° and one with angle C ≈ 105.4°, so Sam's triangles need not be the same shape and size at all. Sam is not correct just because two sides and an angle are equal, since the angle must be the one INCLUDED between those two sides. The condition is not ASA either, because ASA needs two angles, and only one angle is given here. It is also not true that nothing matches — the stated lengths and angle DO match between the two triangles; the problem is which angle was given, not whether the values agree.
- (c) 20 cm² — The area of a triangle is half of base × height. First, base × height = 8 × 5 = 40. Half of 40 is 20 cm². 40 cm² forgets to halve and just gives base × height. 13 cm² adds the base and height together instead of multiplying them. 80 cm² doubles base × height instead of halving it.
Build your own mix at the worksheet builder.