Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (b) £26.25 — First multiply the base and height: 2.4 × 1.75 = 4.2. The area of the triangular sail is half of that: half of 4.2 is 2.1 m². Then multiply by the cost per m²: 2.1 × £12.50 = £26.25. £52.50 forgets to halve in the area formula, giving an area of 4.2 m² and doubling the true cost. £30.00 multiplies the base length by the cost per m² (2.4 × £12.50) without ever finding the area. £25.00 rounds the area to 2 m² before multiplying by the cost, losing accuracy.
- (b) 12.56 cm² — Sector area = (angle ÷ 360) × π × r² = (90 ÷ 360) × 3.14 × 4² = 0.25 × 3.14 × 16 = 12.56 cm². (3.14 cm² comes from forgetting to square the radius; 50.24 cm² comes from finding the area of the whole circle and forgetting the angle fraction; 6.28 cm² comes from using the arc length formula instead of the sector area formula.)
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (a) 376.8 cm³ — Volume of a cone = (1/3)πr²h. Substitute r = 6 and h = 10: (1/3) × 3.14 × 6² × 10 = (1/3) × 3.14 × 36 × 10 = (1/3) × 1130.4 = 376.8 cm³.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (b) 4 m — The two triangles are similar, so height ÷ shadow is the same for both objects. For the post, height ÷ shadow = 1.2 ÷ 1.8. Flagpole height = 6 × (1.2 ÷ 1.8) = 4 m. A student who multiplies the flagpole's shadow by the post's height without applying the ratio gets 6 × 1.2 = 7.2 m. A student who assumes a constant DIFFERENCE between shadow and height instead of a constant ratio finds the post's shadow minus height, 1.8 − 1.2 = 0.6 m, then subtracts that from the flagpole's shadow to get 6 − 0.6 = 5.4 m.
- (b) 21 — Both legs of the journey are on the same bearing, 070°, so the ship travels in one straight line the whole way and the distances simply add: 12 + 9 = 21 km. A candidate who subtracts instead of adding gets 12 − 9 = 3 km. A candidate who multiplies the two distances gets 12 × 9 = 108. A candidate who assumes the ship changed direction and treats the two legs as the sides of a right-angled triangle works out √(12² + 9²) = √225 = 15 km — but the bearing does not change, so there is no triangle and no hypotenuse to find. Because the ship stays on one straight line, the total distance is 21 km.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (b) 18 — Method: convert the real length to centimetres, then divide by the scale factor to shrink it down to the model's size. Working: 4.32 m = 432 cm; 432 cm / 24 = 18 cm. A student who answers 432 has converted the units correctly but forgotten to divide by the scale factor at all. A student who answers 10368 has multiplied by the scale factor instead of dividing (432 x 24). A student who answers 1.8 has converted the metres to centimetres by multiplying by 10 instead of 100, getting 43.2 cm, and then divided by 24. Answer: 18 cm.
- (d) 283 cm³ — Volume of a cylinder = πr²h. Using π = 3.14: V = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6, which rounds to 283 cm³. A pupil who uses the diameter, 6 cm, instead of the radius gets 3.14 × 6² × 10 = 1130.4 ≈ 1130 cm³. A pupil who forgets to square the radius gets 3.14 × 3 × 10 = 94.2 ≈ 94 cm³. A pupil who uses the circumference formula 2πr instead of πr² gets 2 × 3.14 × 3 × 10 = 188.4 ≈ 188 cm³. The correct volume is 283 cm³.
- (c) 3π cm — Circumference = πd. With d = 3 cm, circumference = π × 3 = 3π cm. A student who uses the radius (1.5 cm) instead of the diameter in the formula gets 1.5π cm.
- (c) AB means the segment or its length, shown by context — Method: recall the standard convention for a two-letter label such as AB. Working: AB names the segment AND its length; the sentence around it shows which is meant — 'draw AB' means the segment, 'AB = 5 cm' means the length. Options: 'a different symbol is needed' and 'must be written as |AB|' both describe stricter rules than the convention GCSE actually uses; 'AB can only mean the segment' ignores that the same label is also used for the length. Answer: AB means the segment or its length, shown by context.
- (b) 8.64 m — The real length is 240 times the model length: 3.6 × 240 = 864 cm. Converting to metres, 864 cm ÷ 100 = 8.64 m. The distractor 864 m comes from finding the length correctly in centimetres but forgetting to convert to metres. The distractor 0.0864 m comes from dividing by 100 a second time, converting 864 cm to metres twice over (864 ÷ 10 000) instead of once. The distractor 86.4 m comes from converting centimetres to metres by dividing by 10 instead of 100.
Build your own mix at the worksheet builder.