Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 12.56 cm² — Sector area = (angle ÷ 360) × π × r² = (90 ÷ 360) × 3.14 × 4² = 0.25 × 3.14 × 16 = 12.56 cm². (3.14 cm² comes from forgetting to square the radius; 50.24 cm² comes from finding the area of the whole circle and forgetting the angle fraction; 6.28 cm² comes from using the arc length formula instead of the sector area formula.)
- (b) 4 m — The two triangles are similar, so height ÷ shadow is the same for both objects. For the post, height ÷ shadow = 1.2 ÷ 1.8. Flagpole height = 6 × (1.2 ÷ 1.8) = 4 m. A student who multiplies the flagpole's shadow by the post's height without applying the ratio gets 6 × 1.2 = 7.2 m. A student who assumes a constant DIFFERENCE between shadow and height instead of a constant ratio finds the post's shadow minus height, 1.8 − 1.2 = 0.6 m, then subtracts that from the flagpole's shadow to get 6 − 0.6 = 5.4 m.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (c) 100.5 m — The curved part of a semicircular bend is half of a full circle's circumference. The full circumference would be 2 × 3.14 × 32 = 200.96 m, and half of that is 200.96 ÷ 2 = 100.48 m, which rounds to 100.5 m. Choosing 201.0 m uses the FULL circumference, forgetting to halve it for a semicircle. Choosing 50.2 m halves the radius as well as taking a semicircle, using 3.14 × 16 = 50.24 m instead of the correct radius of 32 m. Choosing 64.0 m uses the diameter, 2 × 32 = 64, as if it were the curved length, ignoring π and the semicircle shape entirely.
- (b) £1.57 — Slice area = (90 ÷ 360) × 3.14 × 10² = 0.25 × 314 = 78.5 cm². Cost = 78.5 × £0.02 = £1.57. (£0.16 comes from forgetting to square the radius, using 0.25 × 3.14 × 10 for the area; £6.28 comes from finding the area of the whole cake and forgetting the angle fraction; £0.31 comes from using the arc length formula instead of the sector area formula.)
- (d) 12.56 cm — Arc length = (angle ÷ 360) × 2 × π × r = (72 ÷ 360) × 2 × 3.14 × 10 = 0.2 × 62.8 = 12.56 cm. (62.8 cm comes from finding the full circumference and forgetting to take the angle fraction; 6.28 cm comes from leaving out the factor of 2, using πr instead of 2πr; 25.12 cm comes from using the diameter, 20 cm, in place of the radius.)
- (c) 151,200 cm² — First find the area in m²: 4.2 × 3.6 = 15.12 m². To convert m² to cm², multiply by 10,000, since 1 m² = 100 cm × 100 cm = 10,000 cm²: 15.12 × 10,000 = 151,200 cm². 15.12 cm² gives the area in m² without converting the units at all. 1,512 cm² multiplies by 100 instead of 10,000, treating the conversion as if it were for a single length rather than an area. 15,120 cm² multiplies by 1,000 instead of 10,000.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (c) 8 cm — Area of a trapezium = (sum of parallel sides) ÷ 2 × height, so 45 = (a + 10) ÷ 2 × 5. Dividing 45 by 5 gives 9, so (a + 10) ÷ 2 = 9, meaning a + 10 = 18, so a = 18 − 10 = 8 cm. A pupil who correctly finds that the two parallel sides add up to 18 but forgets to subtract the known side of 10 cm gives the sum of both parallel sides, 18 cm, as the answer. A pupil who then adds 10 again by mistake instead of subtracting gets 18 + 10 = 28 cm. A pupil who halves the correct answer by mistake gets 8 ÷ 2 = 4 cm. The correct length of the other parallel side is 8 cm.
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
- (d) 60° — Method: the 4 cm side is next to the angle wanted and the 8 cm side is the hypotenuse, so the ratio built from them is cos θ = adjacent ÷ hypotenuse, and the angle comes from the inverse cosine. Working: cos θ = 4 ÷ 8 = 0.5, so θ = cos⁻¹(0.5). Answer: 60°. The distractors: 30° comes from using sin⁻¹(0.5), which treats the 4 cm side as the side opposite the angle when it is the side next to it; 45° comes from assuming the two acute angles of the triangle must be equal; 90° comes from writing down the right angle the question already gives instead of the angle it asks for.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
Build your own mix at the worksheet builder.