Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 143° — Angles on a straight line add up to 180°. Set up 37° + x = 180°. Subtract: x = 180° − 37° = 143°. 53° comes from using 90° as the total, as if the two angles made a right angle, instead of the 180° of a straight line.
- (c) £7.85 — Arc length = (90 ÷ 360) × 2 × 3.14 × 10 = 0.25 × 62.8 = 15.7 cm. Cost = 15.7 × £0.50 = £7.85. (£31.40 comes from finding the full circumference and forgetting the angle fraction; £15.70 comes from using the diameter, 20 cm, in place of the radius; £157.00 comes from multiplying the arc length by the radius instead of by the cost per centimetre.)
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (a) 75° — The three angles in the triangle formed by the two supports and the ground add up to 180°. Two of the angles are 34° and 71°, so the third angle is 180 − 34 − 71 = 75, which is 75°. 105° comes from adding the two given angles together instead of subtracting them from 180° (34 + 71 = 105). 146° comes from computing 180 − 34 = 146 and forgetting to also subtract 71°. 37° comes from subtracting the two given angles from each other instead of using the triangle's angle sum (71 − 34 = 37).
- (b) 8 cm — Area = base × height, so height = area ÷ base = 136 ÷ 17 = 8 cm. (16 cm comes from using the triangle formula, thinking area = 1/2 × base × height and so height = 2 × area ÷ base; 2312 cm comes from multiplying the area by the base instead of dividing; 119 cm comes from subtracting the base from the area instead of dividing the area by the base.)
- (d) 2π cm — Arc length is the fraction θ/360 of the full circumference, 2πr. Substitute θ = 60 and r = 6: 60 out of 360 is one sixth, and the full circumference is 2π × 6 = 12π. One sixth of 12π is 2π, so the arc length is 2π cm. Choosing 12π cm uses the full circumference without scaling it down by the fraction θ/360 first. Choosing 6π cm applies the SECTOR AREA formula, (θ/360) × πr², instead of the arc length formula — that calculation actually gives 6π, which is the area in cm², not a length. Choosing π cm uses πr instead of 2πr, missing the factor of 2 in the circumference formula.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (d) 42.4 cm² — Sector area = (angle ÷ 360) × π × r². First, 60 ÷ 360 = 1/6. Next, π × r² = 3.14 × 81 = 254.34 cm². So the area = (1/6) × 254.34 = 42.39 cm², which rounds to 42.4 cm². (4.7 cm² comes from forgetting to square the radius: using π × r = 3.14 × 9 = 28.26, then (1/6) × 28.26 = 4.71 cm²; 254.3 cm² comes from finding the area of the whole circle, 254.34 cm², and forgetting the angle fraction; 9.4 cm² comes from using the arc length formula instead: 2 × π × r = 2 × 3.14 × 9 = 56.52 cm, then (1/6) × 56.52 = 9.42 cm.)
- (b) £1.57 — Slice area = (90 ÷ 360) × 3.14 × 10² = 0.25 × 314 = 78.5 cm². Cost = 78.5 × £0.02 = £1.57. (£0.16 comes from forgetting to square the radius, using 0.25 × 3.14 × 10 for the area; £6.28 comes from finding the area of the whole cake and forgetting the angle fraction; £0.31 comes from using the arc length formula instead of the sector area formula.)
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (a) 8π cm — Circumference = 2πr. Substitute r = 4: circumference = 2 × π × 4 = 8π cm. Using r in place of 2r (halving the formula) gives 4π cm. Using the area formula πr² in place of the circumference formula gives π × 4² = 16π cm. Multiplying 2 × 4 without including π at all gives 8 cm.
- (d) 8.75 cm — The scale factor of the enlargement is 11.2 ÷ 3.2 = 3.5. Applying this to the second line, 2.5 × 3.5 = 8.75 cm. The distractor 10.50 cm comes from adding the difference between the first line's two lengths (11.2 − 3.2 = 8) to the second line's original length, 2.5 + 8 = 10.5. The distractor 0.71 cm comes from using the scale factor the wrong way round, 2.5 × (3.2 ÷ 11.2) = 0.71 (to 2 d.p.). The distractor 8.70 cm comes from directly subtracting 11.2 − 2.5 = 8.7, muddling the two different lines instead of scaling the second one.
Build your own mix at the worksheet builder.