Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 3028 cm² — Split the window into a rectangle and a semicircle. Rectangle area = 40 × 60 = 2400 cm². The semicircle has radius 40 ÷ 2 = 20 cm, so its area = 0.5 × 3.14 × 20² = 628 cm². Total area = 2400 + 628 = 3028 cm². A student who uses a full circle instead of a semicircle on top of the rectangle gets 3.14 × 20² = 1256 cm² for the circle, plus 2400 cm² for the rectangle, totalling 3656 cm². A student who uses the rectangle's full width (40 cm) as the radius instead of halving it gets 0.5 × 3.14 × 40² = 2512 cm² for the semicircle, plus 2400 cm² for the rectangle, totalling 4912 cm².
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (d) 46.2 cm — The perimeter of a sector is the arc length plus its two straight radii. The circumference is 2 × 3.14 × 10 = 62.8 cm, and the arc is 150 ÷ 360 of that: 62.8 × 150 ÷ 360 = 26.2 cm (1 d.p.). Adding the two radii, 26.2 + 10 + 10 = 46.2 cm. Giving just the arc length, without adding the straight edges, gives 26.2 cm. Adding only ONE radius instead of two gives 36.2 cm. Using 150 ÷ 180 instead of 150 ÷ 360 for the fraction gives an arc of 52.3 cm and a perimeter of 72.3 cm.
- (c) 450 m — To convert km to m, multiply by 1000: 0.45 × 1000 = 450 m. Multiplying by 100 instead of 1000 gives 45 m. Multiplying by 10 000 instead of 1000 gives 4500 m. Not converting at all, just relabelling the number, gives 0.45 m.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (a) 8.1 m — Multiply the length on the plan by the scale factor: 4.5 × 1.8 = 8.1, so the real length is 8.1 m. Choosing 6.3 m adds the two numbers instead of multiplying them (4.5 + 1.8 = 6.3). Choosing 2.5 m divides the plan length by the scale factor the wrong way round (4.5 ÷ 1.8 = 2.5) instead of multiplying. Choosing 9.0 m rounds the scale factor up to 2 before multiplying (4.5 × 2 = 9.0), losing the accuracy the 1.8 was giving.
- (c) √3/2 — Method: sin 60° comes from half of an equilateral triangle. Cut an equilateral triangle of side 2 down its middle: each half is right-angled, with hypotenuse 2 and base 1, and Pythagoras gives its height as √3 because 2² − 1² = 3. Working: sine is the opposite side over the hypotenuse, the side opposite the 60° angle is the height √3, and the hypotenuse is 2, so sin 60° = √3 ÷ 2. Answer: sin 60° = √3/2. Swapping sine for cosine at this angle gives cos 60° = 1/2; taking the value from the other special triangle, the right-angled isosceles one, gives sin 45° = √2/2; and reading the tangent row instead of the sine row gives tan 60° = √3.
- (a) 615.44 cm² — Method: the surface area of a sphere is 4πr². Square the radius, multiply by π, then multiply by 4. Working: r² = 7² = 49, then 3.14 × 49 = 153.86, then 4 × 153.86 = 615.44. Answer: 615.44 cm². The distractors: 153.86 cm² comes from stopping at πr², which is the area of a flat circle of radius 7 cm and leaves out the factor of 4 that a curved surface needs; 87.92 cm² comes from 4 × 3.14 × 7, using the radius itself where the formula asks for its square; 1436.03 cm³ comes from working out the volume of the ball with (4 ÷ 3) × π × r³ instead of its surface area, which is a different measure and carries a cubic unit.
- (d) 1 kg — First find the total mass in grams: 4 × 250 = 1000 g. Then convert to kilograms by dividing by 1000: 1000 ÷ 1000 = 1 kg. Finding the correct total in grams but forgetting to divide by 1000 gives 1000 kg. Adding the number of packs to the pack mass instead of multiplying, 4 + 250 = 254 g, gives 0.254 kg. Dividing the pack mass by the number of packs instead of multiplying, 250 ÷ 4 = 62.5 g, gives 0.0625 kg.
- (c) 11.0 cm — Arc length = (angle ÷ 360) × 2 × π × r = (90 ÷ 360) × 2 × 3.14 × 7 = 0.25 × 43.96 = 10.99 cm, which rounds to 11.0 cm. (44.0 cm comes from finding the full circumference, 2 × 3.14 × 7 = 43.96 cm, and forgetting the angle fraction; 5.5 cm comes from leaving out the factor of 2, using π × r instead of 2 × π × r, giving 0.25 × 3.14 × 7 = 5.495 cm; 22.0 cm comes from using the diameter, 14 cm, in place of the radius, giving 0.25 × 2 × 3.14 × 14 = 21.98 cm.)
- (d) 6.4 cm — The scale factor from the larger sign to the smaller sign is 4 ÷ 9, so the smaller side is 14.4 × 4 ÷ 9 = 6.4 cm. The distractor 32.4 cm comes from using the ratio the wrong way round, 14.4 × 9 ÷ 4 = 32.4. The distractor 9.4 cm comes from subtracting the difference between the ratio numbers (9 − 4 = 5) from the given length, 14.4 − 5 = 9.4. The distractor 3.6 cm comes from dividing the given length by 4 only, 14.4 ÷ 4 = 3.6, without also using the other ratio number.
- (c) 7.1 cm — Method: a shorter side is opposite the 45° angle and the hypotenuse is known, so sin θ = opposite ÷ hypotenuse gives that side directly. Working: sin 45° = x ÷ 10, so x = 10 × sin 45° = 7.071…, which is 7.1 to 1 decimal place. Answer: 7.1 cm. The distractors: 5.0 cm comes from halving the hypotenuse, which is the rule for the side opposite a 30° angle and not a 45° one; 14.1 cm comes from dividing by sin 45° instead of multiplying by it, which makes a shorter side longer than the hypotenuse; 10.0 cm comes from taking tan 45° = 1 and concluding that the shorter side matches the hypotenuse.
- (d) 7.21 units — Method: the diagonal AC is the hypotenuse of the right-angled triangle ABC, whose shorter sides are AB and BC, so Pythagoras' theorem gives its length. Working: AB runs from (0, 0) to (6, 0), so AB = 6; BC runs from (6, 0) to (6, 4), so BC = 4. Then AC² = 6² + 4² = 36 + 16 = 52, so AC = √52 = 7.2111…, which is 7.21 correct to 2 decimal places. Answer: 7.21 units. The distractors: 10.00 units comes from adding the two sides, 6 + 4, instead of adding their squares and taking the root; 4.47 units comes from subtracting the squares, √(36 − 16), which is the form of Pythagoras used to find a shorter side rather than the hypotenuse; 26.00 units comes from halving 52 in place of taking its square root.
Build your own mix at the worksheet builder.