Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (b) 28 cm² — Area of a trapezium = (sum of parallel sides) ÷ 2 × height. Sum of parallel sides = 5.6 + 8.4 = 14 cm. Half of that is 14 ÷ 2 = 7 cm. Area = 7 × 4 = 28 cm². A pupil who forgets to halve gets 14 × 4 = 56 cm². A pupil who uses only the longer parallel side, as if this were a rectangle, gets 8.4 × 4 = 33.6 cm². A pupil who subtracts the parallel sides instead of adding them gets (8.4 − 5.6) ÷ 2 × 4 = 1.4 × 4 = 5.6 cm². The correct area is 28 cm².
- (c) 2 hours 15 minutes — Divide the total minutes by 60: 135 ÷ 60 = 2 remainder 15, so that is 2 hours 15 minutes. Treating 100 minutes as one hour, a metric-style mistake, gives 135 − 100 = 35, so 1 hour 35 minutes. Subtracting 60 twice to reach the 15 minutes left over, but losing count and recording only one of the two hours removed, gives 1 hour 15 minutes. Writing 135 ÷ 60 = 2.25 and then reading the '25' as minutes, instead of converting the 0.25 of an hour into 15 minutes, gives 2 hours 25 minutes.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
- (d) Yes, because 45 ÷ 360 = 1/8, and this fraction applies to any radius. — Priti is correct: 45 ÷ 360 = 1/8, and because sector area = (angle ÷ 360) × full circle area, this fraction depends only on the angle, not on the radius, so it holds for every circle. (The statement giving 45 ÷ 360 = 1/6 comes from an arithmetic slip when simplifying the fraction; the statement that the fraction depends on the radius is wrong because the radius cancels out of the angle fraction in the sector-area formula; the statement adding that it only works for this particular radius is wrong because the 1/8 fraction is true for every radius, not a special case.)
- (d) £100.48 — Area of the rug = (angle ÷ 360) × π × r² = (180 ÷ 360) × 3.14 × 16 = 0.5 × 50.24 = 25.12 m². Cost = 25.12 × £4 = £100.48. (£200.96 comes from finding the area of a full circle, 3.14 × 16 = 50.24 m², and forgetting the angle fraction before costing it; £25.12 comes from forgetting to square the radius, using 0.5 × 3.14 × 4 = 6.28 m², and then costing that; £50.24 comes from using the arc length formula, 0.5 × 2 × 3.14 × 4 = 12.56, in place of the area, and costing that.)
- (c) 117° — Co-interior (also called allied) angles between parallel lines add up to 180°. Angle PXY and angle XYS are co-interior angles, so angle PXY + angle XYS = 180°. 180° − 63° = 117°, so angle XYS = 117°. A student who mistakes co-interior angles for alternate angles, which are equal rather than supplementary, answers 63° instead. A student who treats the two angles as complementary, subtracting from 90° instead of 180°, gets 90° − 63° = 27°. A student who assumes the transversal meets the parallel lines at right angles answers 90°.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (a) 376.8 cm³ — Volume of a cone = (1/3)πr²h. Substitute r = 6 and h = 10: (1/3) × 3.14 × 6² × 10 = (1/3) × 3.14 × 36 × 10 = (1/3) × 1130.4 = 376.8 cm³.
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (a) 150° — The arc length is the same fraction of the circumference as the angle is of 360°. The full circumference is 2 × 3.14 × 6 = 37.68 cm, so the angle is 15.7 ÷ 37.68 × 360 = 150°. Treating the 6 cm as a diameter instead of a radius gives a circumference of 18.84 cm and an angle of 300°. Using π = 3 instead of the given 3.14 gives a circumference of 36 cm and an angle of 157°. Treating the fraction 15.7 ÷ 37.68 as being out of 100 rather than 360 gives about 42°.
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (c) 9.9 cm — Method: the 7 cm side is opposite the 45° angle and the hypotenuse is wanted, so use sin θ = opposite ÷ hypotenuse and rearrange it for the hypotenuse. Working: sin 45° = 7 ÷ h, so h = 7 ÷ sin 45° = 9.899…, which is 9.9 to 1 decimal place. Answer: 9.9 cm. The distractors: 5.0 cm comes from multiplying by sin 45° instead of dividing by it; 14.0 cm comes from doubling the 7 cm side, which is the rule for a side opposite 30° and not one opposite 45°; 7.0 cm comes from reading the two equal sides of a 45° right-angled triangle as including the hypotenuse, when the equal pair is the two shorter sides.
- (d) 38 m² — The two fences meet at a right angle, so the rope sweeps a quarter of a circle: 90 ÷ 360 = 1/4. Grazing area = (90 ÷ 360) × 3.14 × 7² = 0.25 × 153.86 = 38.465 m², which rounds to 38 m². (5 m² comes from forgetting to square the rope length; 154 m² comes from finding the area of a full circle and forgetting the angle fraction; 11 m² comes from using the arc length formula instead of the sector area formula.)
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
Build your own mix at the worksheet builder.