Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (c) 2 hours 15 minutes — Divide the total minutes by 60: 135 ÷ 60 = 2 remainder 15, so that is 2 hours 15 minutes. Treating 100 minutes as one hour, a metric-style mistake, gives 135 − 100 = 35, so 1 hour 35 minutes. Subtracting 60 twice to reach the 15 minutes left over, but losing count and recording only one of the two hours removed, gives 1 hour 15 minutes. Writing 135 ÷ 60 = 2.25 and then reading the '25' as minutes, instead of converting the 0.25 of an hour into 15 minutes, gives 2 hours 25 minutes.
- (c) 155° — Turning clockwise adds to the bearing. Starting on a bearing of 065° and turning clockwise through 90° gives 065° + 90° = 155°. A candidate who instead subtracts, working out 90° − 65° = 25°, has performed the wrong operation, giving 025°. A candidate who turns anticlockwise instead of clockwise works out 065° − 90°, which gives a negative number, and adding 360° to fix this gives 335° — the bearing for turning the other way. A candidate who thinks turning does not change the bearing at all keeps the answer as 065°. The new bearing, turning clockwise, is 155°.
- (a) 188.4 cm² — Curved surface area of a cone = πrl. With r = 6 cm, l = 10 cm and π = 3.14, curved surface area = 3.14 × 6 × 10 = 188.4 cm². A student who uses the cylinder's curved surface area formula, 2πrl, instead of the cone's gets 2 × 3.14 × 6 × 10 = 376.8 cm². A student who uses the circle-area formula πr² instead of πrl gets 3.14 × 36 = 113.04 cm². A student who multiplies r × l but leaves out π entirely gets 6 × 10 = 60 cm².
- (c) 1.44 m³ — The cross-section is a triangle, so its area = base × height ÷ 2. Base × height = 1.2 × 0.8 = 0.96 m², and half of that is 0.96 ÷ 2 = 0.48 m². The volume of the prism = cross-sectional area × length = 0.48 × 3 = 1.44 m³. A pupil who forgets to halve when finding the triangle's area gets 1.2 × 0.8 × 3 = 2.88 m³. A pupil who ignores the height altogether, treating the cross-section as base × length, gets 1.2 × 3 = 3.6 m³. A pupil who correctly finds the cross-sectional area but forgets to multiply by the length of the bed stops at 0.48 m³. The correct volume of soil is 1.44 m³.
- (b) trapezium — A quadrilateral with exactly one pair of parallel sides is a trapezium; field ABCD has AB parallel to DC and no other pair of parallel sides, so trapezium is correct. Parallelogram requires BOTH pairs of opposite sides to be parallel, but the plan says only AB and DC are parallel. Rhombus requires all four sides to be equal in length, which is not stated here. A kite is defined by two pairs of adjacent equal sides, not by having a pair of parallel sides, so it does not match this description either.
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (b) 56.52 cm — Arc length = (216 ÷ 360) × 2 × 3.14 × 15 = 0.6 × 94.2 = 56.52 cm. (28.26 cm comes from leaving out the factor of 2, using πr instead of 2πr; 94.2 cm comes from finding the full circumference and forgetting the angle fraction; 113.04 cm comes from using the diameter, 30 cm, instead of the radius.)
- (d) 1 kg — First find the total mass in grams: 4 × 250 = 1000 g. Then convert to kilograms by dividing by 1000: 1000 ÷ 1000 = 1 kg. Finding the correct total in grams but forgetting to divide by 1000 gives 1000 kg. Adding the number of packs to the pack mass instead of multiplying, 4 + 250 = 254 g, gives 0.254 kg. Dividing the pack mass by the number of packs instead of multiplying, 250 ÷ 4 = 62.5 g, gives 0.0625 kg.
- (b) Acute — An acute angle is any angle less than 90°. Since 47° is less than 90°, it is acute. An obtuse angle is between 90° and 180°, which 47° is not. A reflex angle is greater than 180°, which is far too big for 47°. A right angle is exactly 90°, not 47°. The angle is acute.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (c) 11.0 cm — Arc length = (angle ÷ 360) × 2 × π × r = (90 ÷ 360) × 2 × 3.14 × 7 = 0.25 × 43.96 = 10.99 cm, which rounds to 11.0 cm. (44.0 cm comes from finding the full circumference, 2 × 3.14 × 7 = 43.96 cm, and forgetting the angle fraction; 5.5 cm comes from leaving out the factor of 2, using π × r instead of 2 × π × r, giving 0.25 × 3.14 × 7 = 5.495 cm; 22.0 cm comes from using the diameter, 14 cm, in place of the radius, giving 0.25 × 2 × 3.14 × 14 = 21.98 cm.)
- (b) circumference — The distance all the way around the outside edge of a circle is called the circumference. The diameter is a straight line across the circle through the centre, so it is a length through the circle, not around it. The radius is a straight line from the centre to the edge, again a length across, not around. The area is the amount of surface inside the circle, a region, not a length at all.
- (c) $\binom{2}{7}$ — First find the character's position after the first move: (−5 + 6, 2 + (−9)) = (1, −7). The second move takes it from (1, −7) to (3, 0), so subtract the current position from the target: (3 − 1, 0 − (−7)) = $\binom{2}{7}$. $\binom{8}{−2}$ works from the starting point (−5, 2) and ignores the first move — (3 − (−5), 0 − 2) = $\binom{8}{−2}$. $\binom{−2}{−7}$ subtracts the wrong way round, current position minus target, instead of target minus current position — (1 − 3, −7 − 0) = $\binom{−2}{−7}$. $\binom{4}{−7}$ adds the target's coordinates to the current position instead of subtracting — (1 + 3, −7 + 0) = $\binom{4}{−7}$.
Build your own mix at the worksheet builder.