Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 282.6 cm³ — Volume of a cylinder = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. (94.2 cm³ comes from using πrh and forgetting to square the radius; 90 cm³ comes from using r²h and leaving π out altogether; 1130.4 cm³ comes from using the diameter, 6 cm, in place of the radius.)
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (c) Reflex — Method: compare the measured angle to the key boundaries of 90 degrees, 180 degrees and 360 degrees. Working: 254 degrees is greater than 180 degrees but less than 360 degrees, so it lies in the reflex range. A student who answers obtuse knows the angle is bigger than 90 degrees but has not realised it is also bigger than 180 degrees; they may have worked with the smaller angle at the same point, 360 - 254 = 106 degrees, instead of the reading given. A student who answers acute has misread the scale and taken the reading as 54 degrees rather than 254 degrees. A student who answers right has guessed a commonly recognised angle type without comparing the size properly. Answer: reflex.
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (d) 1 kg — First find the total mass in grams: 4 × 250 = 1000 g. Then convert to kilograms by dividing by 1000: 1000 ÷ 1000 = 1 kg. Finding the correct total in grams but forgetting to divide by 1000 gives 1000 kg. Adding the number of packs to the pack mass instead of multiplying, 4 + 250 = 254 g, gives 0.254 kg. Dividing the pack mass by the number of packs instead of multiplying, 250 ÷ 4 = 62.5 g, gives 0.0625 kg.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (d) 8.75 cm — The scale factor of the enlargement is 11.2 ÷ 3.2 = 3.5. Applying this to the second line, 2.5 × 3.5 = 8.75 cm. The distractor 10.50 cm comes from adding the difference between the first line's two lengths (11.2 − 3.2 = 8) to the second line's original length, 2.5 + 8 = 10.5. The distractor 0.71 cm comes from using the scale factor the wrong way round, 2.5 × (3.2 ÷ 11.2) = 0.71 (to 2 d.p.). The distractor 8.70 cm comes from directly subtracting 11.2 − 2.5 = 8.7, muddling the two different lines instead of scaling the second one.
- (d) 80° — The four angles of any quadrilateral add up to 360°. Three of the angles add up to 100 + 85 + 95 = 280°, so the fourth angle is 360 − 280 = 80°. "70°" comes from using 350° as the total instead of 360°, an easy slip on the quadrilateral angle sum. "280°" comes from stopping at the sum of the three given angles and writing that total down as the answer, instead of subtracting it from 360°. "260°" comes from subtracting only the one angle 100° from 360°, instead of subtracting all three given angles.
- (c) 27.7 cm — Arc length = (150 ÷ 360) × 2 × 3.14 × 6 = (5 ÷ 12) × 37.68 = 15.7 cm. The perimeter of a sector also includes the two straight radii, so perimeter = 15.7 + 6 + 6 = 27.7 cm. (15.7 cm comes from stopping after the arc length and forgetting the two straight edges; 21.7 cm comes from adding only one radius instead of two; 31.4 cm comes from doubling the arc length instead of adding the two straight edges.)
- (c) √3/2 — Method: sin 60° comes from half of an equilateral triangle. Cut an equilateral triangle of side 2 down its middle: each half is right-angled, with hypotenuse 2 and base 1, and Pythagoras gives its height as √3 because 2² − 1² = 3. Working: sine is the opposite side over the hypotenuse, the side opposite the 60° angle is the height √3, and the hypotenuse is 2, so sin 60° = √3 ÷ 2. Answer: sin 60° = √3/2. Swapping sine for cosine at this angle gives cos 60° = 1/2; taking the value from the other special triangle, the right-angled isosceles one, gives sin 45° = √2/2; and reading the tangent row instead of the sine row gives tan 60° = √3.
- (c) 117° — Co-interior (also called allied) angles between parallel lines add up to 180°. Angle PXY and angle XYS are co-interior angles, so angle PXY + angle XYS = 180°. 180° − 63° = 117°, so angle XYS = 117°. A student who mistakes co-interior angles for alternate angles, which are equal rather than supplementary, answers 63° instead. A student who treats the two angles as complementary, subtracting from 90° instead of 180°, gets 90° − 63° = 27°. A student who assumes the transversal meets the parallel lines at right angles answers 90°.
Build your own mix at the worksheet builder.