Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 5 cm — Volume of a cylinder = πr²h, so r² = V ÷ (πh) = 942 ÷ (3.14 × 12) = 942 ÷ 37.68 = 25, and r = √25 = 5 cm. A pupil who finds r² = 25 but forgets to take the square root gives 25 cm. A pupil who forgets to divide by π, using r² = 942 ÷ 12 = 78.5, gets r = √78.5 ≈ 8.9 cm. A pupil who forgets to divide by the height, using r² = 942 ÷ 3.14 = 300, gets r = √300 ≈ 17.3 cm. The correct radius is 5 cm.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (d) 60° — Method: the 4 cm side is next to the angle wanted and the 8 cm side is the hypotenuse, so the ratio built from them is cos θ = adjacent ÷ hypotenuse, and the angle comes from the inverse cosine. Working: cos θ = 4 ÷ 8 = 0.5, so θ = cos⁻¹(0.5). Answer: 60°. The distractors: 30° comes from using sin⁻¹(0.5), which treats the 4 cm side as the side opposite the angle when it is the side next to it; 45° comes from assuming the two acute angles of the triangle must be equal; 90° comes from writing down the right angle the question already gives instead of the angle it asks for.
- (d) 15° — Sector area = (angle ÷ 360) × π × r², so 4.71 = (angle ÷ 360) × 3.14 × 36 = (angle ÷ 360) × 113.04. Dividing gives angle ÷ 360 = 4.71 ÷ 113.04 = 1/24, so angle = 360 ÷ 24 = 15°. (90° comes from forgetting to square the radius, using (angle ÷ 360) × 3.14 × 6 = 18.84 in place of 113.04; 3.75° comes from using the diameter, 12 cm, in place of the radius, giving (angle ÷ 360) × 3.14 × 144 = 452.16; 45° comes from using the arc length formula, (angle ÷ 360) × 2 × 3.14 × 6 = 37.68, instead of the sector area formula.)
- (d) 12.56 cm — Arc length = (angle ÷ 360) × 2 × π × r = (72 ÷ 360) × 2 × 3.14 × 10 = 0.2 × 62.8 = 12.56 cm. (62.8 cm comes from finding the full circumference and forgetting to take the angle fraction; 6.28 cm comes from leaving out the factor of 2, using πr instead of 2πr; 25.12 cm comes from using the diameter, 20 cm, in place of the radius.)
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (d) (11, 0.75) — Add the moves to the starting point one component at a time. x: 12.5 + (−3.75) + 2.25 = 11; y: −4.25 + 6.5 + (−1.5) = 0.75, giving (11, 0.75). (8.75, 2.25) stops after the first move only and never applies the second vector. (6.5, 3.75) comes from subtracting the second vector instead of adding it. (0.75, 11) comes from swapping the final x-coordinate and y-coordinate.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (c) 9.9 cm — Method: the 7 cm side is opposite the 45° angle and the hypotenuse is wanted, so use sin θ = opposite ÷ hypotenuse and rearrange it for the hypotenuse. Working: sin 45° = 7 ÷ h, so h = 7 ÷ sin 45° = 9.899…, which is 9.9 to 1 decimal place. Answer: 9.9 cm. The distractors: 5.0 cm comes from multiplying by sin 45° instead of dividing by it; 14.0 cm comes from doubling the 7 cm side, which is the rule for a side opposite 30° and not one opposite 45°; 7.0 cm comes from reading the two equal sides of a 45° right-angled triangle as including the hypotenuse, when the equal pair is the two shorter sides.
- (d) 1535 cm² — The wiper sweeps out a sector of radius 40 cm, the blade length, through an angle of 110°. Sector area is angle ÷ 360 × π × radius²: 110 ÷ 360 × 3.14 × 1600 = 1535.1 cm², which rounds to 1535 cm². Forgetting to square the radius, using radius instead of radius², gives 38 cm². Using 110 ÷ 180 instead of 110 ÷ 360 for the fraction gives 3070 cm². Treating the 40 cm blade length as a diameter, so using a radius of 20 cm, gives 384 cm².
- (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
- (a) 8π cm — Circumference = 2πr. Substitute r = 4: circumference = 2 × π × 4 = 8π cm. Using r in place of 2r (halving the formula) gives 4π cm. Using the area formula πr² in place of the circumference formula gives π × 4² = 16π cm. Multiplying 2 × 4 without including π at all gives 8 cm.
- (d) 10.3 m — By Pythagoras' theorem, the hypotenuse = √(5² + 9²) = √(25 + 81) = √106 = 10.29...≈ 10.3 m. "106 m" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "14 m" comes from adding the two shorter sides, 5 + 9, instead of using Pythagoras' theorem at all. "10.2 m" comes from rounding 10.29...m down to 10.2 instead of correctly rounding it up to 10.3.
Build your own mix at the worksheet builder.