Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 17.71 m — The perimeter is the two long sides (5 m + 5 m = 10 m) plus the one remaining short side (3 m) plus the curved semicircular edge. The 3 m side is the diameter of the semicircle, so its radius is 3 ÷ 2 = 1.5 m and the curved length is half the circumference: (1/2) × 2 × 3.14 × 1.5 = 4.71 m. Total: 10 + 3 + 4.71 = 17.71 m.
- (d) 2π cm — Arc length is the fraction θ/360 of the full circumference, 2πr. Substitute θ = 60 and r = 6: 60 out of 360 is one sixth, and the full circumference is 2π × 6 = 12π. One sixth of 12π is 2π, so the arc length is 2π cm. Choosing 12π cm uses the full circumference without scaling it down by the fraction θ/360 first. Choosing 6π cm applies the SECTOR AREA formula, (θ/360) × πr², instead of the arc length formula — that calculation actually gives 6π, which is the area in cm², not a length. Choosing π cm uses πr instead of 2πr, missing the factor of 2 in the circumference formula.
- (d) 80° — The four angles of any quadrilateral add up to 360°. Three of the angles add up to 100 + 85 + 95 = 280°, so the fourth angle is 360 − 280 = 80°. "70°" comes from using 350° as the total instead of 360°, an easy slip on the quadrilateral angle sum. "280°" comes from stopping at the sum of the three given angles and writing that total down as the answer, instead of subtracting it from 360°. "260°" comes from subtracting only the one angle 100° from 360°, instead of subtracting all three given angles.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (a) 33 — Method: total crates = (number of floor positions that actually have crates on them) × (the stack height). Working: there are 4 × 3 = 12 floor positions in the whole arrangement, but one corner position is left empty, leaving 11 filled positions; each filled position is stacked 3 crates high, so 11 × 3 = 33. Answer: 33. The distractors: 36 comes from forgetting to remove the empty corner and using all 12 positions (12 × 3). 35 comes from removing only one crate for the empty corner instead of the full stack of 3 (36 − 1). 11 comes from counting the filled floor positions and stopping there, forgetting that each one carries a stack 3 crates high.
- (a) 62.8 cm — The ribbon goes once around the circular cross-section, so its length equals the circumference: 2πr = 2 × 3.14 × 10 = 62.8 cm.
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (b) 113.04 cm² — Sector area is (angle ÷ 360) × π × radius², and radius means the RADIUS, not the diameter: here the diameter is 24 cm, so the radius is 12 cm. The fraction is 90 ÷ 360 = 1/4, and 12² = 144, so the area is 0.25 × 3.14 × 144 = 113.04 cm². Using the diameter itself as if it were the radius gives 0.25 × 3.14 × 576 = 452.16 cm². Using the arc-length formula, 2 × π × radius, instead of the area formula gives 0.25 × 2 × 3.14 × 12 = 18.84 cm². Using the radius instead of its square gives 0.25 × 3.14 × 12 = 9.42 cm².
- (a) 376.8 cm³ — Volume of a cone = (1/3)πr²h. Substitute r = 6 and h = 10: (1/3) × 3.14 × 6² × 10 = (1/3) × 3.14 × 36 × 10 = (1/3) × 1130.4 = 376.8 cm³.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (b) 8.5 m — First apply the scale to convert the plan length to a real length in centimetres: 3.4 × 250 = 850 cm. Then convert centimetres to metres by dividing by 100: 850 ÷ 100 = 8.5, so the wall is 8.5 m long. Choosing 850 m applies the scale correctly but forgets to convert the answer from centimetres into metres. Choosing 0.85 m divides by 1000 instead of 100, confusing the centimetre-to-metre conversion with a metre-to-kilometre one. Choosing 3.4 m ignores the scale factor completely and just restates the plan length as if it were already the real length.
- (a) 3.75 km — To convert metres to kilometres, divide by 1000: 3750 ÷ 1000 = 3.75 km. Dividing by 100 instead of 1000 gives 37.5 km. Dividing by 10 instead of 1000 gives 375 km. Dividing by 10 000 instead of 1000 gives 0.375 km.
Build your own mix at the worksheet builder.