Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 151 cm³ — Volume of the cone = 1/3 × 3.14 × 3² × 10 = 94.2 cm³. Volume of the hemisphere = 1/2 × (4/3 × 3.14 × 3³) = 1/2 × 113.04 = 56.52 cm³. Total volume = 94.2 + 56.52 = 150.72 cm³, which rounds to 151 cm³. A student who uses a full sphere instead of a hemisphere gets 94.2 + 113.04 = 207.24 cm³, rounding to 207. A student who uses a cylinder instead of a cone for the base, forgetting the 1/3, gets 3.14 × 3² × 10 = 282.6 cm³, plus the hemisphere's 56.52 cm³, totalling 339.12 cm³, rounding to 339.
- (b) y-axis — A point lies on the y-axis when its x-coordinate is 0; here the x-coordinate of (0, −5) is 0, so it lies on the y-axis. "x-axis" would need the y-coordinate to be 0 instead, which is not the case here. "the origin" is the single point (0, 0), not a whole axis, and this point is not (0, 0). "both axes" would only be true for the origin itself, where both coordinates are 0.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (c) 52° — When two straight lines cross, the angles opposite each other at the crossing point are vertically opposite and are equal. Ray OQ is opposite ray OP and ray OS is opposite ray OR, so angle QOS is vertically opposite angle POR. Therefore angle QOS = 52°.
- (b) 9π cm² — Sector area is the fraction θ/360 of the full circle's area, πr². Substitute θ = 40 and r = 9: 40 out of 360 is one ninth, and the full circle's area is π × 9² = 81π. One ninth of 81π is 9π, so the sector area is 9π cm². Choosing 2π cm² is this sector's ARC LENGTH, not its area — a different formula and a different quantity. Choosing 81π cm² is the area of the WHOLE circle, forgetting to scale down by the sector's angle. Choosing 18π cm² is the CIRCUMFERENCE of the whole circle, 2π × 9, mixed up with an area.
- (b) 23 — If every position were filled to the full height of 3, the total would be 2 × 4 × 3 = 24 crates. One corner position has only 2 crates instead of 3, one crate short of full height there, so the actual total is 24 − 1 = 23. "24" comes from using the full height everywhere and forgetting the one incomplete corner. "22" comes from removing 2 crates for the incomplete corner instead of the 1 that is actually missing (3 − 2 = 1, not 2). "21" comes from removing all 3 crates at that corner, as though the position were completely empty rather than 2 crates short.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
- (d) 80° — The four angles of any quadrilateral add up to 360°. Three of the angles add up to 100 + 85 + 95 = 280°, so the fourth angle is 360 − 280 = 80°. "70°" comes from using 350° as the total instead of 360°, an easy slip on the quadrilateral angle sum. "280°" comes from stopping at the sum of the three given angles and writing that total down as the answer, instead of subtracting it from 360°. "260°" comes from subtracting only the one angle 100° from 360°, instead of subtracting all three given angles.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (c) 17.71 m — The perimeter is the two long sides (5 m + 5 m = 10 m) plus the one remaining short side (3 m) plus the curved semicircular edge. The 3 m side is the diameter of the semicircle, so its radius is 3 ÷ 2 = 1.5 m and the curved length is half the circumference: (1/2) × 2 × 3.14 × 1.5 = 4.71 m. Total: 10 + 3 + 4.71 = 17.71 m.
- (b) No, it needs one more square — A closed cube has exactly 6 faces, so its net must be made of exactly 6 identical squares, arranged so each one unfolds to a separate face with none overlapping. This net has only 5 squares, so it is one square short and cannot be folded into a closed cube. Choosing 'Yes, it folds into a cube' ignores that a cube needs 6 faces, not 5. Choosing 'No, it has one square too many' miscounts in the wrong direction — 5 is one too FEW, not one too many. Choosing 'Yes, but only if two squares overlap' is not a valid net: a net's faces must not overlap when folded.
- (d) a² + b² = c² — Pythagoras' theorem states that the square of the hypotenuse equals the sum of the squares of the other two sides, so a² + b² = c². "a + b = c" adds the sides directly without squaring them at all. "a² − b² = c²" subtracts the squares instead of adding them. "a² + b² = c" adds the squares correctly but forgets to square the hypotenuse on the other side of the equation.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (b) Acute — An acute angle is any angle less than 90°. Since 47° is less than 90°, it is acute. An obtuse angle is between 90° and 180°, which 47° is not. A reflex angle is greater than 180°, which is far too big for 47°. A right angle is exactly 90°, not 47°. The angle is acute.
Build your own mix at the worksheet builder.