Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (a) 113.04 cm³ — Method: the volume of a sphere is (4 ÷ 3) × π × r³. Cube the radius, multiply by π, then multiply by 4 and divide by 3. Working: r³ = 3³ = 27, then 3.14 × 27 = 84.78, then 84.78 × 4 = 339.12 and 339.12 ÷ 3 = 113.04. Answer: 113.04 cm³. The distractors: 84.78 cm³ comes from stopping at πr³ and leaving out the four thirds; 37.68 cm³ comes from squaring the radius instead of cubing it, (4 ÷ 3) × 3.14 × 9; 28.26 cm³ comes from using πr², the area of a circle, and labelling it as a volume.
- (a) £4.20 — 350 g is 3.5 lots of 100 g, since 350 ÷ 100 = 3.5, so the cost is 3.5 × £1.20 = £4.20. Multiplying the mass in grams directly by the price, without dividing by 100 first, gives £420.00. Working out 100 ÷ 350 instead of 350 ÷ 100 inverts the ratio and gives about £0.34. Rounding 350 g down to 300 g gives 3 × £1.20 = £3.60.
- (d) Yes, because 45 ÷ 360 = 1/8, and this fraction applies to any radius. — Priti is correct: 45 ÷ 360 = 1/8, and because sector area = (angle ÷ 360) × full circle area, this fraction depends only on the angle, not on the radius, so it holds for every circle. (The statement giving 45 ÷ 360 = 1/6 comes from an arithmetic slip when simplifying the fraction; the statement that the fraction depends on the radius is wrong because the radius cancels out of the angle fraction in the sector-area formula; the statement adding that it only works for this particular radius is wrong because the 1/8 fraction is true for every radius, not a special case.)
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
- (a) 8π cm — Circumference = 2πr. Substitute r = 4: circumference = 2 × π × 4 = 8π cm. Using r in place of 2r (halving the formula) gives 4π cm. Using the area formula πr² in place of the circumference formula gives π × 4² = 16π cm. Multiplying 2 × 4 without including π at all gives 8 cm.
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (a) 615.44 cm² — Method: the surface area of a sphere is 4πr². Square the radius, multiply by π, then multiply by 4. Working: r² = 7² = 49, then 3.14 × 49 = 153.86, then 4 × 153.86 = 615.44. Answer: 615.44 cm². The distractors: 153.86 cm² comes from stopping at πr², which is the area of a flat circle of radius 7 cm and leaves out the factor of 4 that a curved surface needs; 87.92 cm² comes from 4 × 3.14 × 7, using the radius itself where the formula asks for its square; 1436.03 cm³ comes from working out the volume of the ball with (4 ÷ 3) × π × r³ instead of its surface area, which is a different measure and carries a cubic unit.
- (d) 4.6 cm — Method: BC is opposite the 30° angle and AC is next to it, so the ratio that links the two is tan θ = opposite ÷ adjacent. Working: tan 30° = BC ÷ 8, so BC = 8 × tan 30° = 4.6188…, which is 4.6 to 1 decimal place. Answer: 4.6 cm. The distractors: 13.9 cm comes from dividing by tan 30° instead of multiplying by it; 4.0 cm comes from using sin 30°, which treats the 8 cm side as the hypotenuse when it is the side next to the 30° angle; 6.9 cm comes from using cos 30° in place of tan 30°, which gives the wrong pair of sides.
- (c) 151,200 cm² — First find the area in m²: 4.2 × 3.6 = 15.12 m². To convert m² to cm², multiply by 10,000, since 1 m² = 100 cm × 100 cm = 10,000 cm²: 15.12 × 10,000 = 151,200 cm². 15.12 cm² gives the area in m² without converting the units at all. 1,512 cm² multiplies by 100 instead of 10,000, treating the conversion as if it were for a single length rather than an area. 15,120 cm² multiplies by 1,000 instead of 10,000.
- (c) Reflex — Method: compare the measured angle to the key boundaries of 90 degrees, 180 degrees and 360 degrees. Working: 254 degrees is greater than 180 degrees but less than 360 degrees, so it lies in the reflex range. A student who answers obtuse knows the angle is bigger than 90 degrees but has not realised it is also bigger than 180 degrees; they may have worked with the smaller angle at the same point, 360 - 254 = 106 degrees, instead of the reading given. A student who answers acute has misread the scale and taken the reading as 54 degrees rather than 254 degrees. A student who answers right has guessed a commonly recognised angle type without comparing the size properly. Answer: reflex.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (b) 12.56 cm² — Sector area = (angle ÷ 360) × π × r² = (90 ÷ 360) × 3.14 × 4² = 0.25 × 3.14 × 16 = 12.56 cm². (3.14 cm² comes from forgetting to square the radius; 50.24 cm² comes from finding the area of the whole circle and forgetting the angle fraction; 6.28 cm² comes from using the arc length formula instead of the sector area formula.)
- (c) tan θ = opposite/adjacent — The tangent ratio is defined as tan θ = opposite/adjacent, so this is the ratio that connects the opposite and adjacent sides. "sin θ = opposite/adjacent" wrongly labels this ratio as sine, when sine actually connects the opposite side and the hypotenuse. "cos θ = opposite/adjacent" wrongly labels it as cosine, when cosine connects the adjacent side and the hypotenuse. "tan θ = adjacent/opposite" uses the correct ratio name but has the opposite and adjacent sides the wrong way round.
- (a) 17 cm — Convert the real distance to centimetres first: 3.4 km = 340 000 cm. Then divide by the scale factor, 20 000, since the map is 20 000 times smaller than real life: 340 000 ÷ 20 000 = 17, so the map distance is 17 cm. Choosing 1700 cm divides by 200 instead of 20 000, losing two zeros from the scale factor (340 000 ÷ 200 = 1700). Choosing 170 cm divides by 2 000 instead of 20 000, losing one zero from the scale factor (340 000 ÷ 2 000 = 170). Choosing 0.17 cm divides by 2 000 000 instead of 20 000, adding two extra zeros to the scale factor (340 000 ÷ 2 000 000 = 0.17).
Build your own mix at the worksheet builder.