Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (b) 8.5 m — First apply the scale to convert the plan length to a real length in centimetres: 3.4 × 250 = 850 cm. Then convert centimetres to metres by dividing by 100: 850 ÷ 100 = 8.5, so the wall is 8.5 m long. Choosing 850 m applies the scale correctly but forgets to convert the answer from centimetres into metres. Choosing 0.85 m divides by 1000 instead of 100, confusing the centimetre-to-metre conversion with a metre-to-kilometre one. Choosing 3.4 m ignores the scale factor completely and just restates the plan length as if it were already the real length.
- (d) 2π cm — Arc length is the fraction θ/360 of the full circumference, 2πr. Substitute θ = 60 and r = 6: 60 out of 360 is one sixth, and the full circumference is 2π × 6 = 12π. One sixth of 12π is 2π, so the arc length is 2π cm. Choosing 12π cm uses the full circumference without scaling it down by the fraction θ/360 first. Choosing 6π cm applies the SECTOR AREA formula, (θ/360) × πr², instead of the arc length formula — that calculation actually gives 6π, which is the area in cm², not a length. Choosing π cm uses πr instead of 2πr, missing the factor of 2 in the circumference formula.
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (d) a² + b² = c² — Pythagoras' theorem states that the square of the hypotenuse equals the sum of the squares of the other two sides, so a² + b² = c². "a + b = c" adds the sides directly without squaring them at all. "a² − b² = c²" subtracts the squares instead of adding them. "a² + b² = c" adds the squares correctly but forgets to square the hypotenuse on the other side of the equation.
- (a) 24 — The display is 4 tins wide, 3 tins high and 2 tins deep, and every position in that block is filled, so the total number of tins is the product of all three measurements: 4 × 3 × 2 = 24. "12" comes from multiplying only the width and height shown in the front elevation (4 × 3), forgetting the depth entirely. "9" comes from adding the three measurements (4 + 3 + 2) instead of multiplying them. "6" comes from multiplying only the height and depth (3 × 2), forgetting the width shown by the front elevation.
- (b) 18 — Method: convert the real length to centimetres, then divide by the scale factor to shrink it down to the model's size. Working: 4.32 m = 432 cm; 432 cm / 24 = 18 cm. A student who answers 432 has converted the units correctly but forgotten to divide by the scale factor at all. A student who answers 10368 has multiplied by the scale factor instead of dividing (432 x 24). A student who answers 1.8 has converted the metres to centimetres by multiplying by 10 instead of 100, getting 43.2 cm, and then divided by 24. Answer: 18 cm.
- (c) 282.6 cm³ — Volume of a cylinder = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. (94.2 cm³ comes from using πrh and forgetting to square the radius; 90 cm³ comes from using r²h and leaving π out altogether; 1130.4 cm³ comes from using the diameter, 6 cm, in place of the radius.)
- (c) 27 cm² — Area of a rectangle = length × width = 4.5 × 6 = 27 cm². A pupil who adds the two sides instead of multiplying gets 4.5 + 6 = 10.5 cm². A pupil who works out the perimeter instead of the area gets 2 × (4.5 + 6) = 21 cm². A pupil who rounds 4.5 up to 5 before multiplying gets 5 × 6 = 30 cm². The correct area is 27 cm².
- (b) 10.5 — Method: multiply the drawing length by the scale factor to get the real length. Working: 7 cm × 1.5 = 10.5 m. A student who answers 8.5 has added the scale factor to the drawing length instead of multiplying (7 + 1.5). A student who answers 14 has rounded the scale factor up to 2 before multiplying. A student who answers 3.5 has divided the drawing length by 2 instead of multiplying it by 1.5. Answer: 10.5 m.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (c) 5 cm — Volume of a cylinder = πr²h, so r² = V ÷ (πh) = 942 ÷ (3.14 × 12) = 942 ÷ 37.68 = 25, and r = √25 = 5 cm. A pupil who finds r² = 25 but forgets to take the square root gives 25 cm. A pupil who forgets to divide by π, using r² = 942 ÷ 12 = 78.5, gets r = √78.5 ≈ 8.9 cm. A pupil who forgets to divide by the height, using r² = 942 ÷ 3.14 = 300, gets r = √300 ≈ 17.3 cm. The correct radius is 5 cm.
- (b) 4 m — The two triangles are similar, so height ÷ shadow is the same for both objects. For the post, height ÷ shadow = 1.2 ÷ 1.8. Flagpole height = 6 × (1.2 ÷ 1.8) = 4 m. A student who multiplies the flagpole's shadow by the post's height without applying the ratio gets 6 × 1.2 = 7.2 m. A student who assumes a constant DIFFERENCE between shadow and height instead of a constant ratio finds the post's shadow minus height, 1.8 − 1.2 = 0.6 m, then subtracts that from the flagpole's shadow to get 6 − 0.6 = 5.4 m.
- (d) 6.4 cm — The scale factor from the larger sign to the smaller sign is 4 ÷ 9, so the smaller side is 14.4 × 4 ÷ 9 = 6.4 cm. The distractor 32.4 cm comes from using the ratio the wrong way round, 14.4 × 9 ÷ 4 = 32.4. The distractor 9.4 cm comes from subtracting the difference between the ratio numbers (9 − 4 = 5) from the given length, 14.4 − 5 = 9.4. The distractor 3.6 cm comes from dividing the given length by 4 only, 14.4 ÷ 4 = 3.6, without also using the other ratio number.
Build your own mix at the worksheet builder.