Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 450 m — To convert km to m, multiply by 1000: 0.45 × 1000 = 450 m. Multiplying by 100 instead of 1000 gives 45 m. Multiplying by 10 000 instead of 1000 gives 4500 m. Not converting at all, just relabelling the number, gives 0.45 m.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (b) second quadrant — The point (−3, 5) has a negative x-coordinate and a positive y-coordinate, and this combination lies in the second quadrant. The first quadrant needs both coordinates positive. The third quadrant needs both coordinates negative. The fourth quadrant needs a positive x-coordinate and a negative y-coordinate.
- (c) It is a parallelogram but not a rectangle — Method: match the given properties to the definition of each named quadrilateral. Working: having both pairs of opposite sides parallel and equal in length is exactly the definition of a parallelogram; since none of the angles are right angles, it cannot also be a rectangle, which needs four right angles. Options: 'must be a rectangle' wrongly assumes every parallelogram has right angles; 'must be a rhombus' wrongly assumes equal opposite sides means all four sides are equal, but only the opposite pairs are stated as equal here; 'trapezium' is wrong because a trapezium has exactly one pair of parallel sides, while this shape has two pairs, so it is a parallelogram and not a trapezium. Answer: it is a parallelogram but not a rectangle.
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (d) 7.21 units — Method: the diagonal AC is the hypotenuse of the right-angled triangle ABC, whose shorter sides are AB and BC, so Pythagoras' theorem gives its length. Working: AB runs from (0, 0) to (6, 0), so AB = 6; BC runs from (6, 0) to (6, 4), so BC = 4. Then AC² = 6² + 4² = 36 + 16 = 52, so AC = √52 = 7.2111…, which is 7.21 correct to 2 decimal places. Answer: 7.21 units. The distractors: 10.00 units comes from adding the two sides, 6 + 4, instead of adding their squares and taking the root; 4.47 units comes from subtracting the squares, √(36 − 16), which is the form of Pythagoras used to find a shorter side rather than the hypotenuse; 26.00 units comes from halving 52 in place of taking its square root.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (b) 10.5 — Method: multiply the drawing length by the scale factor to get the real length. Working: 7 cm × 1.5 = 10.5 m. A student who answers 8.5 has added the scale factor to the drawing length instead of multiplying (7 + 1.5). A student who answers 14 has rounded the scale factor up to 2 before multiplying. A student who answers 3.5 has divided the drawing length by 2 instead of multiplying it by 1.5. Answer: 10.5 m.
- (b) 6 m — Volume of a cuboid = length × width × height, so height = volume ÷ (length × width) = 360 ÷ (12 × 5) = 360 ÷ 60 = 6 m. A pupil who divides the volume by the length only gets 360 ÷ 12 = 30 m. A pupil who divides the volume by the width only gets 360 ÷ 5 = 72 m. A pupil who subtracts length × width from the volume instead of dividing gets 360 − 60 = 300 m. The correct height is 6 m.
- (d) 310 — Method: since both turns are clockwise, add both angles to the starting bearing. Working: 245° + 50° = 295°; 295° + 15° = 310°. A student who answers 295 has only added the first turn and forgotten the second one. A student who answers 180 has subtracted both turns instead of adding them. A student who answers 320 has added the two turns as 75° instead of 65° by misreading the second turn. Answer: 310°.
- (b) £26.25 — First multiply the base and height: 2.4 × 1.75 = 4.2. The area of the triangular sail is half of that: half of 4.2 is 2.1 m². Then multiply by the cost per m²: 2.1 × £12.50 = £26.25. £52.50 forgets to halve in the area formula, giving an area of 4.2 m² and doubling the true cost. £30.00 multiplies the base length by the cost per m² (2.4 × £12.50) without ever finding the area. £25.00 rounds the area to 2 m² before multiplying by the cost, losing accuracy.
- (c) 56.52 cm² — Sector area = (45 ÷ 360) × 3.14 × 12² = 0.125 × 3.14 × 144 = 56.52 cm². (4.71 cm² comes from forgetting to square the radius; 452.16 cm² comes from finding the area of the whole circle and forgetting the angle fraction; 9.42 cm² comes from using the arc length formula instead of the sector area formula.)
- (c) 100.5 m — The curved part of a semicircular bend is half of a full circle's circumference. The full circumference would be 2 × 3.14 × 32 = 200.96 m, and half of that is 200.96 ÷ 2 = 100.48 m, which rounds to 100.5 m. Choosing 201.0 m uses the FULL circumference, forgetting to halve it for a semicircle. Choosing 50.2 m halves the radius as well as taking a semicircle, using 3.14 × 16 = 50.24 m instead of the correct radius of 32 m. Choosing 64.0 m uses the diameter, 2 × 32 = 64, as if it were the curved length, ignoring π and the semicircle shape entirely.
Build your own mix at the worksheet builder.