Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (d) Yes, because 45 ÷ 360 = 1/8, and this fraction applies to any radius. — Priti is correct: 45 ÷ 360 = 1/8, and because sector area = (angle ÷ 360) × full circle area, this fraction depends only on the angle, not on the radius, so it holds for every circle. (The statement giving 45 ÷ 360 = 1/6 comes from an arithmetic slip when simplifying the fraction; the statement that the fraction depends on the radius is wrong because the radius cancels out of the angle fraction in the sector-area formula; the statement adding that it only works for this particular radius is wrong because the 1/8 fraction is true for every radius, not a special case.)
- (c) 151,200 cm² — First find the area in m²: 4.2 × 3.6 = 15.12 m². To convert m² to cm², multiply by 10,000, since 1 m² = 100 cm × 100 cm = 10,000 cm²: 15.12 × 10,000 = 151,200 cm². 15.12 cm² gives the area in m² without converting the units at all. 1,512 cm² multiplies by 100 instead of 10,000, treating the conversion as if it were for a single length rather than an area. 15,120 cm² multiplies by 1,000 instead of 10,000.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
- (b) 21 — Both legs of the journey are on the same bearing, 070°, so the ship travels in one straight line the whole way and the distances simply add: 12 + 9 = 21 km. A candidate who subtracts instead of adding gets 12 − 9 = 3 km. A candidate who multiplies the two distances gets 12 × 9 = 108. A candidate who assumes the ship changed direction and treats the two legs as the sides of a right-angled triangle works out √(12² + 9²) = √225 = 15 km — but the bearing does not change, so there is no triangle and no hypotenuse to find. Because the ship stays on one straight line, the total distance is 21 km.
- (c) It is a parallelogram but not a rectangle — Method: match the given properties to the definition of each named quadrilateral. Working: having both pairs of opposite sides parallel and equal in length is exactly the definition of a parallelogram; since none of the angles are right angles, it cannot also be a rectangle, which needs four right angles. Options: 'must be a rectangle' wrongly assumes every parallelogram has right angles; 'must be a rhombus' wrongly assumes equal opposite sides means all four sides are equal, but only the opposite pairs are stated as equal here; 'trapezium' is wrong because a trapezium has exactly one pair of parallel sides, while this shape has two pairs, so it is a parallelogram and not a trapezium. Answer: it is a parallelogram but not a rectangle.
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (c) 27.7 cm — Arc length = (150 ÷ 360) × 2 × 3.14 × 6 = (5 ÷ 12) × 37.68 = 15.7 cm. The perimeter of a sector also includes the two straight radii, so perimeter = 15.7 + 6 + 6 = 27.7 cm. (15.7 cm comes from stopping after the arc length and forgetting the two straight edges; 21.7 cm comes from adding only one radius instead of two; 31.4 cm comes from doubling the arc length instead of adding the two straight edges.)
- (a) £157.00 — Area covered = (angle ÷ 360) × π × r² = (90 ÷ 360) × 3.14 × 400 = 0.25 × 1256 = 314 km². Charge = 314 × £0.50 = £157.00. (£7.85 comes from forgetting to square the radius, using 0.25 × 3.14 × 20 = 15.7 km² and then charging that; £628.00 comes from finding the area of a full circle, 3.14 × 400 = 1256 km², and forgetting the angle fraction before charging; £15.70 comes from using the arc length formula, 0.25 × 2 × 3.14 × 20 = 31.4, in place of the area, and charging that.)
- (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
Build your own mix at the worksheet builder.