Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 28 cm — Method: the perimeter is the total distance round the outside, and a rhombus has four sides of equal length, so the perimeter is 4 × the side length. Working: 4 × 7 = 28. Answer: 28 cm. The distractors: 14 cm comes from 2 × 7, adding only one pair of sides and forgetting that a rhombus has two pairs; 49 cm comes from working out 7 × 7, which is the calculation for the area of a square rather than a distance round the outside; 11 cm comes from adding the side length to the number of sides, 7 + 4, instead of multiplying them.
- (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
- (b) RHS - right angle, hypotenuse and one side equal — A right angle, the hypotenuse (13 cm) and one other side (5 cm) are equal in both triangles, so this is RHS. SAS would need the equal angle to be the one INCLUDED between the two equal sides, but the right angle at B is not between AB and the hypotenuse AC — it is opposite the hypotenuse instead, so SAS does not apply directly here. SSS needs all three sides, but only two sides are stated. ASA needs two angles, but only one angle (the right angle) is given.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (b) tan 90° — Method: write each ratio as one side of a right-angled triangle divided by another, and look for the one whose bottom line can be zero. Working: sine and cosine are both a side divided by the hypotenuse, and a hypotenuse is never zero, so sin 90° = 1 and cos 90° = 0 are both perfectly good values — a value of zero is still a value. Tangent is the opposite side divided by the adjacent side. As the angle opens out towards 90° the adjacent side shrinks to nothing, and a division by zero has no result, while at the other end of the row the adjacent side is the long one and tan 0° = 0. Answer: tan 90°.
- (b) £5.00 — Perimeter of the kite = 25 + 25 + 40 + 40 = 130 cm = 1.3 m. The frame is sold only in whole metres, so 2 m must be bought. Cost = 2 × £2.50 = £5.00. A student who buys the exact 1.3 m instead of rounding up to whole metres gets 1.3 × £2.50 = £3.25. A student who never converts the perimeter from centimetres to metres and costs 130 × £2.50 gets £325.00.9 m, which rounds up to 3 whole metres, costing 3 × £2.50 = £7.50.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (d) 300 cm³ — Method: the volume of a cuboid is length × width × height. Working: 2 × 10 = 20, then 20 × 15 = 300. Answer: 300 cm³. The distractors: 27 cm³ comes from adding the three edges, 2 + 10 + 15, instead of multiplying them; 400 cm² comes from working out the surface area, 2 × (2 × 10 + 2 × 15 + 10 × 15) = 400, which answers a different question and carries a different unit; 150 cm³ comes from multiplying 10 × 15 and leaving the 2 cm edge out of the calculation altogether.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
- (a) 106° — Angle AOC and angle AOD share the arm OA and together they make up the straight line CD, so they add up to 180°: angle AOD = 180° − 74° = 106°. 74° comes from treating AOC and AOD as vertically opposite angles, which are equal — but they are adjacent angles on a straight line, not vertically opposite. 16° comes from subtracting 74° from 90°, treating the angles as complementary. 148° comes from doubling 74° instead of subtracting it from 180°.
- (d) 6 — The plan view shows every square of the base footprint, whether or not there is a taller stack above it — the base layer alone already covers a 3 by 2 rectangle of cubes, which is 6 squares. The extra cube on top of a corner cube sits directly above a square that is already counted, so it adds no NEW square to the plan — height does not show up in a plan view, only footprint does. "7" comes from wrongly counting the extra cube as an additional square. "5" comes from missing one square of the base rectangle, perhaps forgetting a corner. "3" comes from counting only one row of the base rectangle and forgetting that the base is two rows deep.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (b) Hexagon — Cutting straight across a prism, at right angles to its length, always gives a cross-section that is the same shape as its end faces. The end faces of a hexagonal prism are hexagons (6-sided), so the cross-section is a hexagon. Choosing Pentagon comes from miscounting the sides of the hexagonal end as five instead of six. Choosing Rectangle comes from cutting along the LENGTH of the prism instead of across it, which gives a rectangular face, not the cross-section asked for. Choosing Triangle comes from confusing a hexagonal prism with a triangular prism.
Build your own mix at the worksheet builder.