Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 10 — Corresponding angles are equal, so 5x + 4 = 3x + 24. Subtracting 3x from both sides gives 2x + 4 = 24, then subtracting 4 gives 2x = 20, so x = 10. 14 comes from adding the constants, 4 + 24, instead of subtracting them when rearranging. 19 comes from treating the angles as co-interior (summing to 180°): 5x + 4 + 3x + 24 = 180 gives 8x = 152, so x = 19. 20 correctly reaches 2x = 20 but stops without dividing by 2.
- (c) The midpoint of AB — M is a single point lying exactly halfway along the straight line AB, so 'the midpoint of AB' correctly describes it. 'The vertex of AB' is wrong because a vertex is a corner point where two edges or lines meet, which does not apply to a point on a single straight line. 'A perpendicular of AB' is wrong because perpendicular describes two lines meeting at right angles, not a single point. 'A plane of AB' is wrong because a plane is a flat two-dimensional surface, not a point.
- (b) SAS (two sides and the included angle) — PQ = ST and QR = TU are two pairs of matching sides, and the angle between them (angle Q and angle T) is 90° in both triangles — two sides and the angle between them are equal, so the triangles are congruent by SAS, using only the measurements given. RHS needs the hypotenuses to be known equal; here only the two legs are given, so you would first have to work out each hypotenuse by Pythagoras' theorem — extra working the question rules out. SSS has the same problem: the third side of each triangle is not given, only calculable. ASA needs two angles and the side between them, but here it is two sides and the angle between them that are given, not two angles.
- (c) A↔N, B↔L, C↔M (ABC≅NLM) — Matching equal side lengths: AB (8 cm) equals NL (8 cm), BC (10 cm) equals LM (10 cm), and CA (6 cm) equals MN (6 cm). This gives the correspondence A with N, B with L, and C with M, so triangle ABC is congruent to triangle NLM, making 'A↔N, B↔L, C↔M (ABC≅NLM)' correct. 'A↔L, B↔M, C↔N (ABC≅LMN)' simply matches the vertices in the order they are written without checking the side lengths: AB (8 cm) would need to equal LM (10 cm), which is false. 'A↔M, B↔N, C↔L (ABC≅MNL)' also fails this check, since AB (8 cm) would need to equal MN (6 cm), which is false. 'A↔N, B↔M, C↔L (ABC≅NML)' gets A correct but swaps B and C, so AB (8 cm) would need to equal NM (6 cm), which is also false.
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (a) Kite — Method: check each named quadrilateral's properties against the three facts given, one at a time. Working: a kite has two pairs of adjacent sides equal (not opposite pairs), one pair of opposite angles equal (the two angles where an unequal pair of sides meet), and exactly one line of symmetry — matching all three facts. Options: a rhombus does have equal adjacent sides, but all four of its sides are equal, both pairs of its opposite angles are equal, and it has two lines of symmetry rather than exactly one; a parallelogram has its opposite sides equal rather than adjacent pairs, both pairs of opposite angles equal, and no line of symmetry at all; a trapezium does not generally have any pair of equal adjacent sides or a line of symmetry. Answer: kite.
- (a) A flat surface extending infinitely in two directions — Method: recall the precise geometric meaning of 'plane', versus 'line', 'point' and 'face'. Working: a plane is a flat, two-dimensional surface extending infinitely in every direction within it. Options: 'a straight line extending in one direction' describes a line, not a plane; 'a single fixed position with no size' describes a point; 'a flat, bounded face on a 3D shape' describes a face, a bounded piece of a plane, not the plane itself, which has no boundary. Answer: a flat surface extending infinitely in two directions.
- (c) 36 cm² — Method: the area of a square is its side length multiplied by itself. Working: 6 × 6 = 36. Answer: 36 cm². The distractors: 24 cm comes from working out the perimeter, 4 × 6, which is a length and not an area; 12 cm comes from doubling the side, 6 × 2, instead of squaring it; 18 cm² comes from halving the product, (6 × 6) ÷ 2, using the rule for the area of a triangle.
- (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
- (a) 180 cm³ — Method: the volume of a right prism is the area of its cross-section multiplied by its length, and the area of a triangle is half the base multiplied by the perpendicular height. Working: the cross-section has area (6 × 5) ÷ 2 = 15 cm², and 15 × 12 = 180. Answer: 180 cm³. The distractors: 360 cm³ comes from taking the cross-section as 6 × 5 = 30 and never halving it, which measures the rectangle around the triangular face rather than the face itself; 66 cm³ comes from adding the base and the perpendicular height and halving, (6 + 5) ÷ 2 = 5.5, which is the trapezium rule used where the triangle rule is needed, and then multiplying by the 12 cm length; 15 cm³ comes from working out the triangular cross-section correctly and stopping there, so the 12 cm length is never used and an area is handed in as a volume.
- (c) 1 — Method: a right angle measures 90°, the three angles of any triangle add up to 180°, and a right-angled triangle is defined as a triangle that contains a right angle. Working: taking one right angle out of the total leaves 180° − 90° = 90° to be shared between the other two angles, so both of those must be acute; a second right angle would use the whole of that remaining 90° and leave nothing at all for the third angle, which is impossible. The definition therefore fixes the count at exactly one. Answer: 1. The distractors: 2 comes from counting the two sides that form the right angle instead of counting the angles themselves; 3 comes from reading the name as a description of the whole triangle, so that all three of its angles are taken to be right angles, which would need an angle sum of 3 × 90° = 270°; 0 comes from over-applying the angle sum — a candidate who works out that 90° + 90° = 180° leaves nothing for a third angle can conclude from that alone that no triangle may contain a right angle at all.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
- (c) SAS - two sides and the included angle equal — Two sides (AB and BC) and the angle between them (angle B) are equal in both triangles, so this is SAS. SSS would need all three sides given, but only two sides are stated. ASA needs two angles and the side between them, but only one angle is given. AAS needs two angles and a side, but again only one angle is given here.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
Build your own mix at the worksheet builder.