Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) SAS, vertically opposite angle included — AE equals CE and BE equals DE give two pairs of equal sides, and angle AEB equals angle CED because they are vertically opposite angles formed where AC and BD cross; vertically opposite angles are always equal without needing to be measured. This included angle sits between the two known sides in each triangle, giving SAS, so 'SAS, vertically opposite angle included' is correct. 'ASA, vertically opposite angle at E' is wrong because ASA needs two pairs of equal angles with the side between them, but only one angle is known in each triangle here, and the two other known facts are sides, not angles. 'SSS, three equal side pairs' is wrong because only two pairs of sides are given; there is no third pair of equal sides. 'Cannot prove — no angle measured' is wrong because vertically opposite angles are always equal automatically when two straight lines cross, so no separate measurement is needed.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (c) 62° — Co-interior (allied) angles on parallel lines sum to 180°, so the co-interior angle is 180° − 118° = 62°. 118° comes from treating the angles as corresponding angles, which are equal, instead of co-interior angles, which sum to 180°. 59° comes from halving the given angle. 236° comes from doubling the given angle.
- (c) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides.
- (d) £50 — Area = 1/2 × (3.5 + 6.5) × 4 = 1/2 × 10 × 4 = 20 m². Cost = 20 × £2.50 = £50. (£100 comes from forgetting to halve the trapezium area, giving 40 m² instead of 20 m²; £65 comes from using only the longer parallel side, 6.5 × 4 = 26 m², instead of the trapezium formula; £35 comes from adding all three given lengths, 3.5 + 6.5 + 4, and treating that total as the area in square metres.)
- (d) XP is the shortest distance from X to the line — The perpendicular from a point to a line always gives the shortest possible distance to that line — joining X to any other point on the line forms the hypotenuse of a right-angled triangle with XP as one of the shorter sides, and a hypotenuse is always longer than either of the other two sides. So XP is shorter than the distance to every other point on the line. "XP is the longest distance from X to the line" reverses this relationship. "XP equals every other distance from X to the line" would only be true if X were equidistant from every point on the line, which is impossible for a point and a straight line. "XP cannot be compared without knowing the line's length" is false — the shortest-distance fact holds whatever the line's length, since only the local right angle matters.
- (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (d) 1 — An isosceles trapezium has one line of symmetry, running through the midpoints of the two parallel sides. 0 would be true for a scalene trapezium, whose non-parallel sides are unequal, but this trapezium's non-parallel sides are equal, so it is symmetrical. 2 is the number of lines of symmetry of a rectangle, not a trapezium. 4 comes from wrongly applying the 'number of sides equals number of lines of symmetry' rule, which only holds for REGULAR polygons — a trapezium is not regular.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
- (c) 5√3 m — The cable, the pole and the ground form a right-angled triangle: the ground distance (5 m) is adjacent to the 60° angle, and the height of the pole is opposite it, so height = 5 × tan 60° = 5 × √3 = 5√3 m. 5√3/2 m comes from using sin 60° = √3/2 instead of tan 60°. 5/√3 m comes from using tan 30° = 1/√3, the reciprocal-angle value, instead of tan 60°. 10√3 m comes from doubling the correct height by mistake.
- (b) AB = DE — RHS needs a right angle, the hypotenuse, and one OTHER side to be equal; the right angles and hypotenuses are already equal, so a matching pair of the remaining sides, AB = DE, completes RHS. Angle A = angle D is an extra ANGLE fact, not the extra SIDE fact that RHS specifically requires. AC being parallel to DF says nothing about either triangle's side lengths, so it cannot complete a congruence condition. Being drawn the same way up is about orientation on the page, not about any measurement, so it proves nothing about congruence.
- (a) 62° — Angle KPQ and angle MQP are co-interior (allied) angles between parallel lines, so they add up to 180°: angle MQP = 180° − 118° = 62°. 118° comes from treating the angles as equal, as if this were a corresponding or alternate angle pair, instead of using the co-interior rule. 90° comes from wrongly assuming the crossing line meets JK and LM at right angles. 59° comes from halving 118° instead of subtracting it from 180°.
- (a) 6 cm — Method: a diameter runs right across a circle through its centre, so it is made of two radii laid end to end, which gives diameter = 2 × radius. Working: the radius is 3 cm, so the diameter is 2 × 3 = 6 cm. Answer: 6 cm. The distractors: 1.5 cm comes from dividing by 2 instead of multiplying by it, which is the relationship applied in the wrong direction; 3 cm comes from copying the radius straight down, treating the two words as names for the same measurement; 5 cm comes from adding 2 to the radius instead of multiplying the radius by 2.
Build your own mix at the worksheet builder.