Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (c) 1 — Method: the instruction states that a curved surface counts as a face, so count the surfaces of the sphere on that basis. Working: a sphere has exactly one continuous curved surface and no flat surfaces at all. A student who answers 0 has ignored the instruction and refused to count the curved surface. A student who answers 2 has confused the sphere with a cylinder, which has two flat circular faces. A student who answers 3 has imagined extra hidden surfaces that do not exist. Answer: 1 face.
- (b) AB = DE — RHS needs a right angle, the hypotenuse, and one OTHER side to be equal; the right angles and hypotenuses are already equal, so a matching pair of the remaining sides, AB = DE, completes RHS. Angle A = angle D is an extra ANGLE fact, not the extra SIDE fact that RHS specifically requires. AC being parallel to DF says nothing about either triangle's side lengths, so it cannot complete a congruence condition. Being drawn the same way up is about orientation on the page, not about any measurement, so it proves nothing about congruence.
- (a) 12 cm — Area of a parallelogram = base × perpendicular height, so height = area ÷ base = 96 ÷ 8 = 12 cm. A student who adds the area and base instead of dividing gets 96 + 8 = 104 cm. A student who multiplies the area and base instead of dividing gets 96 × 8 = 768 cm. A student who uses the triangle area formula, area = 1/2 × base × height, instead of the parallelogram formula solves 96 = 1/2 × 8 × h and gets h = 24 cm.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (b) 2 — A rhombus has two lines of symmetry — along each of its two diagonals.
- (d) 0 — A vertex is a sharp corner point where edges meet. A cylinder has two curved, circular edges but no sharp corner points at all, so it has 0 vertices, making that the correct answer. '2' wrongly treats the two circular edges themselves as vertices, but an edge is not the same as a vertex. '4' overcounts by treating each circular edge as if it had two end-vertices, which does not apply to a continuous curved edge. '1' wrongly imagines the curved surface itself forming a single corner point, which it does not.
- (b) Draw wider arcs from each crossing point, meeting above. — Once the two arcs cross the line at points either side of P, compasses are opened to a radius greater than before and arcs are drawn from each of those two points so that they meet above (or below) the line; joining that meeting point to P gives the perpendicular. (Joining the two crossing points with a straight line only retraces part of the original line, since both points already lie on it; drawing a circle centred at P through both crossing points does not locate any new point needed for the perpendicular; drawing an arc centred at P through only one crossing point repeats the first step instead of moving on to the second pair of arcs.)
- (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
- (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
- (d) Wrong - the given angle is not the included angle — Sides AB and BC meet at vertex B, so the included angle needed for SAS is angle B, not angle A — the information given is SSA. SSA does not prove congruence: with AB = 10 cm, BC = 7 cm and angle A = 40° there are two different triangles that fit, one with angle C ≈ 74.6° and one with angle C ≈ 105.4°, so Sam's triangles need not be the same shape and size at all. Sam is not correct just because two sides and an angle are equal, since the angle must be the one INCLUDED between those two sides. The condition is not ASA either, because ASA needs two angles, and only one angle is given here. It is also not true that nothing matches — the stated lengths and angle DO match between the two triangles; the problem is which angle was given, not whether the values agree.
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
Build your own mix at the worksheet builder.