Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (b) 60 cm² — Method: the area of a triangle is half the base multiplied by the perpendicular height, and here the perpendicular height is the 12 cm, not the sloping side. Working: 10 × 12 = 120, then 120 ÷ 2 = 60. Answer: 60 cm². The distractors: 65 cm² comes from using the sloping side of 13 cm as the height, (10 × 13) ÷ 2; 120 cm² comes from using the right two lengths but forgetting to halve, 10 × 12; 78 cm² comes from taking 13 cm and 12 cm as the base and the height and ignoring BC altogether, (13 × 12) ÷ 2.
- (a) 49 cm² — The area of a square is side × side = 7 × 7 = 49 cm². 28 cm² is the perimeter of the square (4 × 7), not its area. 14 cm² adds just two of the sides together. 21 cm² multiplies the side length by 3 instead of squaring it.
- (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (d) points the same distance from A as from B — The perpendicular bisector of AB is, by definition, the locus of every point equidistant from A and B — any point on it forms two congruent right-angled triangles with A and B, which is exactly the property the construction guarantees. "points as far from A as the length AB" describes a circle centred at A with radius AB, not a bisector. "the single point exactly halfway along AB" names only the midpoint, one point, not the whole locus the construction produces. "points twice as far from A as from B" describes a different curve entirely, not a straight line construction.
- (b) 3 — A cuboid with all different edge lengths has three planes of symmetry: one parallel to each pair of opposite faces, cutting the solid exactly in half. Choosing 9 is the number of planes of symmetry a CUBE has (where all edges are equal) — this cuboid's edges are all different, so it has fewer. Choosing 1 counts only one of the three planes and forgets the other two, each parallel to a different pair of faces. Choosing 6 double-counts each of the three planes, as if counting each one from both sides.
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (d) Similar, by SAS — Method: read off whether the given sides are equal or only in the same ratio, and where the given angle sits. Sides in proportion point to similarity; sides equal in length would be needed for congruence. Working: AB ÷ DE = AC ÷ DF gives two pairs of corresponding sides in the same ratio, and the equal angle at A and D lies between AB and AC in the first triangle and between DE and DF in the second, so it is the included angle. Two pairs of sides in proportion with the included angle equal is the SAS condition for similarity. Answer: similar, by SAS. The distractors: 'Similar, by AA' quotes a condition that needs two pairs of equal angles, while only one pair is given here; 'Congruent, by SAS' reads AB ÷ DE = AC ÷ DF as AB = DE and AC = DF, turning a statement about proportion into one about equal lengths; 'Congruent, by SSS' makes that same misreading and adds an assumption that the third pair of sides is equal too, which nothing in the question says.
- (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (d) A rectangle — Method: to find the plan view, work out the outline traced when looking straight down onto the solid from directly above, not the outline shown in the angled sketch. Working: this solid has two identical flat round ends joined by one curved surface, and it is lying on its side rather than standing upright; viewed from above, the curved surface gives two straight edges running the full length of the solid, the width of the round ends apart, and each flat round end — seen edge-on from directly above — also becomes a straight edge of that same width, with no curve remaining. Four straight edges, with opposite sides equal and meeting at right angles, form a rectangle. Answer: a rectangle. The distractors: a circle comes from picturing the solid as if it were standing upright on one of its flat ends, giving the plan of an upright version instead of working out the plan of the solid as it actually lies. An oval comes from copying the foreshortened shape of a round end as it is drawn in the angled sketch, instead of working out the true shape seen from directly above, which has no such foreshortening. A rectangle with rounded ends comes from carrying the curve of the round ends over into the plan view, when in fact a flat round end viewed edge-on from directly above shows no curve at all, only a straight edge.
- (c) base angles of an isosceles triangle are equal — Because AB = AC, triangle ABC is isosceles, and the base angles of an isosceles triangle — the two angles opposite the equal sides — are always equal, which is why angle C equals angle B, 70°. Angles in a triangle adding up to 180° is a true fact about the triangle as a whole, but it is not the reason two specific angles are equal to each other. Corresponding angles are equal is a fact about parallel lines cut by a transversal, which does not apply inside a single triangle like this. Vertically opposite angles are equal is a fact about two lines crossing, not about a triangle's base angles.
- (d) 60 — Method: write the two supplementary angles as x and 2x, since one is twice the other, and solve x + 2x = 180. Working: 3x = 180, so x = 60. Answer: the smaller angle is 60°. A candidate who gives the larger angle, 2x, instead of the smaller angle gets 120. A candidate who uses a complementary sum of 90° instead of a supplementary sum of 180° gets 30. A candidate who divides 180 by 2 instead of by 3 gets 90.
- (b) 32 cm² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the height. Add the parallel sides: 6 + 10 = 16. Multiply by the height: 16 × 4 = 64. Half of 64 is 32 cm². 64 cm² forgets to halve and just gives (6+10)×4. 8 cm² averages the two parallel sides, (6+10)÷2 = 8, but forgets to multiply by the height. 20 cm² treats it as a triangle using only the longer parallel side as the base: half of 10 × 4.
Build your own mix at the worksheet builder.