Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 62° — Co-interior (allied) angles on parallel lines sum to 180°, so the co-interior angle is 180° − 118° = 62°. 118° comes from treating the angles as corresponding angles, which are equal, instead of co-interior angles, which sum to 180°. 59° comes from halving the given angle. 236° comes from doubling the given angle.
- (a) 24 — The display is 4 tins wide, 3 tins high and 2 tins deep, and every position in that block is filled, so the total number of tins is the product of all three measurements: 4 × 3 × 2 = 24. "12" comes from multiplying only the width and height shown in the front elevation (4 × 3), forgetting the depth entirely. "9" comes from adding the three measurements (4 + 3 + 2) instead of multiplying them. "6" comes from multiplying only the height and depth (3 × 2), forgetting the width shown by the front elevation.
- (c) AB means the segment or its length, shown by context — Method: recall the standard convention for a two-letter label such as AB. Working: AB names the segment AND its length; the sentence around it shows which is meant — 'draw AB' means the segment, 'AB = 5 cm' means the length. Options: 'a different symbol is needed' and 'must be written as |AB|' both describe stricter rules than the convention GCSE actually uses; 'AB can only mean the segment' ignores that the same label is also used for the length. Answer: AB means the segment or its length, shown by context.
- (c) Rectangle — A rectangle has two pairs of parallel sides and four right angles, but does not require all sides to be equal — this matches exactly, so Rectangle is correct. A square also has four right angles and parallel sides, but additionally requires all four sides to be equal, which contradicts 'not all the same length', so it is wrong. A rhombus has two pairs of parallel sides and all four sides equal, but its angles are not generally 90° unless it is also a square, so it does not match the right-angle condition here. A kite has no pairs of parallel sides at all, so it does not match the first condition given.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (d) (6, 2) — Applying the first vector: (2, 1) + (5, −3) = (7, −2), which is the warehouse. Applying the second vector: (7, −2) + (−1, 4) = (6, 2), the delivery address. '(7, −2)' stops at the warehouse and forgets the second flight. '(8, −6)' comes from adding (1, −4) instead of (−1, 4) for the second vector, getting both signs wrong. '(11, −3)' comes from swapping the components of the second vector to (4, −1) before adding.
- (c) It is a parallelogram but not a rectangle — Method: match the given properties to the definition of each named quadrilateral. Working: having both pairs of opposite sides parallel and equal in length is exactly the definition of a parallelogram; since none of the angles are right angles, it cannot also be a rectangle, which needs four right angles. Options: 'must be a rectangle' wrongly assumes every parallelogram has right angles; 'must be a rhombus' wrongly assumes equal opposite sides means all four sides are equal, but only the opposite pairs are stated as equal here; 'trapezium' is wrong because a trapezium has exactly one pair of parallel sides, while this shape has two pairs, so it is a parallelogram and not a trapezium. Answer: it is a parallelogram but not a rectangle.
- (c) 15/17 — Method: cos θ = adjacent ÷ hypotenuse, so find the hypotenuse with Pythagoras' theorem first and then decide which short side is next to θ. Working: the hypotenuse is √(8² + 15²) = √(64 + 225) = √289 = 17 cm. The angle θ is opposite the 8 cm side, so the side next to it is the 15 cm side, and cos θ = 15 ÷ 17. Answer: 15/17. The distractors: 8/17 is sin θ, opposite over hypotenuse, used in place of the cosine; 8/15 is tan θ, opposite over adjacent; 17/15 comes from writing the cosine ratio upside down, as hypotenuse over adjacent.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
- (d) Similar, by SAS — Method: read off whether the given sides are equal or only in the same ratio, and where the given angle sits. Sides in proportion point to similarity; sides equal in length would be needed for congruence. Working: AB ÷ DE = AC ÷ DF gives two pairs of corresponding sides in the same ratio, and the equal angle at A and D lies between AB and AC in the first triangle and between DE and DF in the second, so it is the included angle. Two pairs of sides in proportion with the included angle equal is the SAS condition for similarity. Answer: similar, by SAS. The distractors: 'Similar, by AA' quotes a condition that needs two pairs of equal angles, while only one pair is given here; 'Congruent, by SAS' reads AB ÷ DE = AC ÷ DF as AB = DE and AC = DF, turning a statement about proportion into one about equal lengths; 'Congruent, by SSS' makes that same misreading and adds an assumption that the third pair of sides is equal too, which nothing in the question says.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (b) An angle between 90° and 180° — Method: angle names are fixed by two markers, a right angle at 90° and a straight line at 180°. An obtuse angle is one that has opened past the right angle but has not reached the straight line. Working: an obtuse angle is greater than 90° and smaller than 180°. Answer: an angle between 90° and 180°. The distractors: an angle between 0° and 90° is the definition of an acute angle, chosen by a candidate who remembers the wrong side of the right-angle marker; an angle between 180° and 360° is the definition of a reflex angle, chosen by a candidate who knows the angle is past 90° and then takes the largest category; an angle of exactly 90° is the right angle itself, which is the marker an obtuse angle has passed rather than the obtuse angle.
- (c) 27 cm² — Area of a rectangle = length × width = 4.5 × 6 = 27 cm². A pupil who adds the two sides instead of multiplying gets 4.5 + 6 = 10.5 cm². A pupil who works out the perimeter instead of the area gets 2 × (4.5 + 6) = 21 cm². A pupil who rounds 4.5 up to 5 before multiplying gets 5 × 6 = 30 cm². The correct area is 27 cm².
- (c) 58° — In an isosceles triangle, the base angles opposite the equal sides are equal. Since DE = DF, angle F is the base angle equal to angle E, so angle F = 58°.
Build your own mix at the worksheet builder.