Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (c) 52° — When two straight lines cross, the angles opposite each other at the crossing point are vertically opposite and are equal. Ray OQ is opposite ray OP and ray OS is opposite ray OR, so angle QOS is vertically opposite angle POR. Therefore angle QOS = 52°.
- (c) Dodecagon — Deca- means 10, so Decagon names a 10-sided polygon, two sides short of this one, so it is wrong. Hendeca- means 11, one side short of 12, so Hendecagon is also wrong. Icosa- means 20, double the number of sides given here, so Icosagon is wrong too. Dodeca- means 12, so Dodecagon correctly names this polygon.
- (b) 3 — Method: the scale factor is a length of the second triangle divided by the corresponding length of the first, and corresponding means shortest paired with shortest. Working: the shortest side of the first triangle is 3 cm and the shortest side of the second is 9 cm, so the scale factor is 9 ÷ 3 = 3. Answer: 3. The distractors: 1/3 comes from dividing 3 by 9, which is the scale factor from the second triangle back to the first; 6 comes from subtracting, 9 − 3, treating the scale factor as a difference rather than a multiplier; 1.8 comes from dividing 9 by 5, pairing the second triangle's shortest side with the first triangle's longest side.
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
- (d) 1250 g — There are 1000 g in a kilogram, so 1.25 kg = 1.25 × 1000 = 1250 g. Multiplying by 100 instead of 1000 gives 125 g. Converting only the whole 1 kg and forgetting the extra 0.25 kg gives 1000 g. Treating the 0.25 kg as 25 g instead of 250 g, a quarter of 1000, gives 1025 g.
- (b) The arcs only meet exactly on AB, not above or below it. — With a radius of exactly half of AB, the arc centred at A and the arc centred at B each reach precisely to the midpoint of AB, so they meet only at that one point, on the line AB itself — there are no two intersection points above and below the line to join, so the perpendicular bisector cannot be drawn. (The claim that this radius is always too short to draw any arc is wrong, since a radius equal to half of AB is a perfectly valid, positive length for a compass arc; the claim that the radius must equal the full length of AB is wrong — a longer radius than half of AB would also work, it does not have to equal AB exactly; the claim that the arcs would not cross line AB at all is wrong, since they do cross it — that is exactly the problem, they meet only on it.)
- (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) 33 — Method: total crates = (number of floor positions that actually have crates on them) × (the stack height). Working: there are 4 × 3 = 12 floor positions in the whole arrangement, but one corner position is left empty, leaving 11 filled positions; each filled position is stacked 3 crates high, so 11 × 3 = 33. Answer: 33. The distractors: 36 comes from forgetting to remove the empty corner and using all 12 positions (12 × 3). 35 comes from removing only one crate for the empty corner instead of the full stack of 3 (36 − 1). 11 comes from counting the filled floor positions and stopping there, forgetting that each one carries a stack 3 crates high.
- (a) the lens-shaped region where the two circles overlap — The region within 30 km of the ship is a circle of radius 30 km around the ship; the region within 20 km of the lighthouse is a circle of radius 20 km around the lighthouse. Since 30 + 20 = 50 km is more than the 40 km between them, and 30 − 20 = 10 km is less than 40 km, the two circles genuinely overlap, in a lens-shaped region where both conditions hold at once. "the whole smaller circle, since it fits inside the larger one" would only be true if the 40 km distance between the centres were small enough for one circle to swallow the other, which it is not here. "no overlap — 30 km and 20 km don't add to 40 km" wrongly assumes the two radii must add up to exactly the distance between the centres for an overlap to exist; any total greater than that distance is enough. "a straight strip, exactly halfway between the two" confuses this with an equidistant locus, which is a different problem from the one asked here.
- (a) Triangular prism — Count the given properties against each solid. A triangular prism has 5 faces (2 triangular ends + 3 rectangular sides), 9 edges and 6 vertices — this matches exactly, so the solid is a triangular prism. A square-based pyramid also has 5 faces, but 8 edges and 5 vertices, and only one face is a square rather than three rectangles — the edge and vertex counts don't match. A cuboid has 6 faces, 12 edges and 8 vertices, none of which match the numbers given. A tetrahedron has 4 faces, all triangles, with 6 edges and 4 vertices — too few faces, and no rectangular faces at all.
- (a) where the angle bisector meets the posts' perpendicular bisector — Being equidistant from the two walls means lying on the angle bisector of the corner; being equidistant from the two posts means lying on the perpendicular bisector of the 4 m segment joining them. A single point satisfying both conditions is wherever those two loci cross. "where the angle bisector meets the line joining the posts" uses the straight line between the posts instead of its perpendicular bisector — a point on that line is not generally equidistant from both posts. "the perpendicular bisector of the posts, alone" satisfies only the posts condition, ignoring the walls entirely. "the angle bisector of the corner, alone" satisfies only the walls condition, ignoring the posts entirely.
Build your own mix at the worksheet builder.