Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) £33.60 — The area of the parallelogram flower bed is base × height = 3.5 × 2 = 7 m². The cost is 7 × £4.80 = £33.60. £16.80 comes from using the triangle formula instead of the parallelogram formula: 3.5 × 2 = 7, and half of 7 is 3.5 m², then 3.5 × £4.80 = £16.80. £26.40 comes from adding the base and height, 3.5+2 = 5.5, instead of multiplying them, then multiplying by £4.80. £7.00 correctly finds the area, 7 m², but forgets to multiply it by the cost per m².
- (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
- (d) 1 — At 45° the right-angled isosceles triangle has both shorter sides equal, so tan 45° = opposite ÷ adjacent = 1 ÷ 1 = 1. 0 is the value of tan 0° (mixing up the two angles). √3 is the value of tan 60°. √3/3 (equivalent to 1/√3) is the value of tan 30°.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (c) 2 — A cylinder has 3 faces in total: 1 curved surface and 2 flat circular faces, the base and the lid. The label covers only the curved surface, leaving the base and the lid uncovered — that is 2 faces. A candidate who forgets one of the two flat faces answers 1. A candidate who mistakenly splits the curved surface into two separate uncovered faces and then adds the 2 flat faces answers 4. A candidate who assumes the label covers the whole tin answers 0. The number of faces not covered by the label is 2.
- (c) tan θ = opposite/adjacent — The tangent ratio is defined as tan θ = opposite/adjacent, so this is the ratio that connects the opposite and adjacent sides. "sin θ = opposite/adjacent" wrongly labels this ratio as sine, when sine actually connects the opposite side and the hypotenuse. "cos θ = opposite/adjacent" wrongly labels it as cosine, when cosine connects the adjacent side and the hypotenuse. "tan θ = adjacent/opposite" uses the correct ratio name but has the opposite and adjacent sides the wrong way round.
- (c) I is the same distance from all three sides. — The angle bisector from A is the locus of points equidistant from sides AB and AC, and the angle bisector from B is the locus of points equidistant from sides AB and BC. Point I lies on both bisectors, so I is equidistant from AB and AC, and also equidistant from AB and BC — meaning I is the same distance from all three sides. (Being the same distance from all three vertices instead describes the circumcentre, found from the perpendicular bisectors of the sides, not the angle bisectors; I being the midpoint of AB confuses the angle bisector construction with the perpendicular bisector of a side; I lying on side AC is wrong because the angle bisectors meet inside the triangle, not on one of its sides.)
- (d) An obtuse angle — Method: compare the angle with the two markers that separate the angle names, a right angle at 90° and a straight line at 180°. Working: 108° is greater than 90° and smaller than 180°, so it lies between the right angle and the straight line. Answer: an obtuse angle. The distractors: an acute angle is one below 90°, and is chosen by a candidate who checks only that 108° is less than 180°; a reflex angle is one above 180°, and is chosen by a candidate who checks only that 108° is more than 90° and then takes the largest category; a right angle is exactly 90°, and is chosen by reading 108° as near enough to 90° instead of comparing it properly.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (b) 140 cm² — Method: the area of a trapezium is the mean of the two parallel sides multiplied by the perpendicular height. Working: (16 + 24) ÷ 2 = 20, then 20 × 7 = 140. Answer: 140 cm². The distractors: 280 cm² comes from multiplying the sum of the parallel sides by the height, (16 + 24) × 7, and forgetting to halve; 168 cm² comes from using only the longer parallel side, 24 × 7, as though the shape were a rectangle; 47 cm comes from adding all three given lengths, 16 + 24 + 7, which gives a length rather than an area.
- (c) 155° — Turning clockwise adds to the bearing. Starting on a bearing of 065° and turning clockwise through 90° gives 065° + 90° = 155°. A candidate who instead subtracts, working out 90° − 65° = 25°, has performed the wrong operation, giving 025°. A candidate who turns anticlockwise instead of clockwise works out 065° − 90°, which gives a negative number, and adding 360° to fix this gives 335° — the bearing for turning the other way. A candidate who thinks turning does not change the bearing at all keeps the answer as 065°. The new bearing, turning clockwise, is 155°.
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (d) 5 — Method: since the triangles are congruent by SAS, the corresponding sides AB and DE must be equal, because both are the side next to the given right angle that is not BC or EF. Working: AB = DE gives 2x + 3 = 13, so 2x = 10, so x = 5. Options: 10 comes from dropping the coefficient of x and solving x + 3 = 13 instead of 2x + 3 = 13; 4 comes from matching AB to the wrong side, EF, giving 2x + 3 = 11, so 2x = 8, so x = 4; 8 comes from a sign error, solving 2x − 3 = 13 instead of 2x + 3 = 13, giving 2x = 16, so x = 8. Answer: 5.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (d) 5 — A square-based pyramid has four vertices at the corners of the square base, plus one more vertex at the apex where the four triangular faces meet: 4 + 1 = 5 vertices. Choosing 8 counts the edges instead of the vertices. Choosing 4 counts only the base corners and forgets the apex at the top. Choosing 6 is the vertex count of a triangular prism, not a square-based pyramid.
Build your own mix at the worksheet builder.