Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) points the same distance from A as from B — The perpendicular bisector of AB is, by definition, the locus of every point equidistant from A and B — any point on it forms two congruent right-angled triangles with A and B, which is exactly the property the construction guarantees. "points as far from A as the length AB" describes a circle centred at A with radius AB, not a bisector. "the single point exactly halfway along AB" names only the midpoint, one point, not the whole locus the construction produces. "points twice as far from A as from B" describes a different curve entirely, not a straight line construction.
- (c) RHS applies: the right angle, hypotenuse and one matching side are all equal — Both triangles are right-angled, and the hypotenuses (AC and DF) are equal, and one further pair of matching sides (AB and DE) are equal. This matches the Right angle-Hypotenuse-Side condition, which needs only these three facts, not a third side.
- (d) An obtuse angle — Method: compare the angle with the two markers that separate the angle names, a right angle at 90° and a straight line at 180°. Working: 108° is greater than 90° and smaller than 180°, so it lies between the right angle and the straight line. Answer: an obtuse angle. The distractors: an acute angle is one below 90°, and is chosen by a candidate who checks only that 108° is less than 180°; a reflex angle is one above 180°, and is chosen by a candidate who checks only that 108° is more than 90° and then takes the largest category; a right angle is exactly 90°, and is chosen by reading 108° as near enough to 90° instead of comparing it properly.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (b) 50° — Method: the three angles of a triangle add up to 180°, and the two angles opposite the equal sides are equal, so subtract the given angle from 180° and halve the remainder. Working: 180° − 80° = 100°, and 100° ÷ 2 = 50°. Answer: 50°. The distractors: 100° comes from subtracting from 180° and forgetting to halve, so it is the two equal angles together; 40° comes from halving the 80° that is given rather than halving what is left of the 180°; 80° comes from assuming that the two base angles must match the angle between the equal sides.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
- (d) The centre — Method: sort the four names by what kind of object each one is, because only one of them names a single point rather than a line or a curve. Working: a chord is a straight line joining two points on the circle; a diameter is the special chord that runs right across the circle through the middle, so it too is a line; an arc is a piece of the circle's own curve. That leaves one name, and it belongs to the point from which every radius is drawn, which is why every point on the circle is the same distance from it. Answer: The centre. The distractors: The chord is picked by a candidate who reads 'the same distance' as a line of fixed length rather than as a point; The diameter is picked by a candidate who names the line that passes through the point instead of the point itself; The arc is picked by a candidate who hunts for a part of the circle's own curve rather than for a point inside it.
- (c) (4, 3) — Method: the midpoint of a segment is the mean of its two end points, so its x-coordinate is the mean of the two x-coordinates and its y-coordinate is the mean of the two y-coordinates. Working: for x, (1 + 7) ÷ 2 = 8 ÷ 2 = 4. For y, (3 + 3) ÷ 2 = 6 ÷ 2 = 3. The midpoint is therefore (4, 3). Answer: (4, 3). The distractors: (3, 3) comes from halving the difference of the x-coordinates, (7 − 1) ÷ 2 = 3, which measures half the distance instead of locating the point; (3.5, 3) comes from halving only the larger x-coordinate and leaving the smaller one out of the working; (4, 0) comes from averaging the x-coordinates correctly but then subtracting the y-coordinates, 3 − 3, rather than averaging them.
- (a) 28 cm — Method: the perimeter is the total distance round the outside, and a rhombus has four sides of equal length, so the perimeter is 4 × the side length. Working: 4 × 7 = 28. Answer: 28 cm. The distractors: 14 cm comes from 2 × 7, adding only one pair of sides and forgetting that a rhombus has two pairs; 49 cm comes from working out 7 × 7, which is the calculation for the area of a square rather than a distance round the outside; 11 cm comes from adding the side length to the number of sides, 7 + 4, instead of multiplying them.
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (b) 117 — Method: two angles meeting at a point on a straight line add up to 180°. Working: 180 − 63 = 117. Answer: 117°. A candidate who thinks the two angles on a straight line must be equal gives 63. A candidate who uses 90° instead of 180°, working out 90 − 63, gets 27. A candidate who uses 360° instead of 180°, working out 360 − 63, gets 297.
- (c) 38° — The interior angles of a hexagon sum to (6 − 2) × 180° = 720°. 130° + 142° + 125° + 150° + 135° = 682°. x = 720° − 682° = 38°. A student who uses 6 × 180° instead of (6 − 2) × 180°, forgetting to subtract the 2, gets 1080° − 682° = 398°. A student who mis-adds the five given angles as 680° instead of 682° gets x = 720° − 680° = 40°. A student who answers with one of the given angles instead of solving for x might write 142°.
- (d) Wrong - the given angle is not the included angle — Sides AB and BC meet at vertex B, so the included angle needed for SAS is angle B, not angle A — the information given is SSA. SSA does not prove congruence: with AB = 10 cm, BC = 7 cm and angle A = 40° there are two different triangles that fit, one with angle C ≈ 74.6° and one with angle C ≈ 105.4°, so Sam's triangles need not be the same shape and size at all. Sam is not correct just because two sides and an angle are equal, since the angle must be the one INCLUDED between those two sides. The condition is not ASA either, because ASA needs two angles, and only one angle is given here. It is also not true that nothing matches — the stated lengths and angle DO match between the two triangles; the problem is which angle was given, not whether the values agree.
Build your own mix at the worksheet builder.