Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (c) Dodecagon — Deca- means 10, so Decagon names a 10-sided polygon, two sides short of this one, so it is wrong. Hendeca- means 11, one side short of 12, so Hendecagon is also wrong. Icosa- means 20, double the number of sides given here, so Icosagon is wrong too. Dodeca- means 12, so Dodecagon correctly names this polygon.
- (d) (1, −6) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate: (1, 6) → (1, −6). A pupil who reflects in the y-axis instead gets (−1, 6). A pupil who changes the sign of both coordinates gets (−1, −6). A pupil who forgets to change any sign leaves the point unmoved at (1, 6). The correct image is (1, −6).
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (a) 59° — Method: the three angles of a triangle add up to 180°, and in an isosceles triangle the two angles opposite the equal sides are equal, so take the known angle away from 180° and share what is left equally between the other two. Working: 180° − 62° = 118°, and 118° ÷ 2 = 59°. Answer: 59°. The distractors: 118° comes from taking 62° from 180° and stopping there, which gives the two angles together rather than one of them; 31° comes from halving the 62° that is given instead of halving what is left; 62° comes from assuming that all three angles of the triangle are equal to the one that is given.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
- (d) A rectangle — Method: to find the plan view, work out the outline traced when looking straight down onto the solid from directly above, not the outline shown in the angled sketch. Working: this solid has two identical flat round ends joined by one curved surface, and it is lying on its side rather than standing upright; viewed from above, the curved surface gives two straight edges running the full length of the solid, the width of the round ends apart, and each flat round end — seen edge-on from directly above — also becomes a straight edge of that same width, with no curve remaining. Four straight edges, with opposite sides equal and meeting at right angles, form a rectangle. Answer: a rectangle. The distractors: a circle comes from picturing the solid as if it were standing upright on one of its flat ends, giving the plan of an upright version instead of working out the plan of the solid as it actually lies. An oval comes from copying the foreshortened shape of a round end as it is drawn in the angled sketch, instead of working out the true shape seen from directly above, which has no such foreshortening. A rectangle with rounded ends comes from carrying the curve of the round ends over into the plan view, when in fact a flat round end viewed edge-on from directly above shows no curve at all, only a straight edge.
- (d) 10 — Method: the distance between two points is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal and vertical gaps, so work out both gaps first, handling the negative coordinates carefully, and then apply Pythagoras' theorem. Working: the horizontal gap is 5 − (−3) = 5 + 3 = 8 and the vertical gap is 4 − (−2) = 4 + 2 = 6. Then d² = 8² + 6² = 64 + 36 = 100, so d = √100 = 10. Answer: 10. The distractors: 14 comes from adding the two gaps, 8 + 6, instead of adding their squares and taking the root; 100 comes from stopping at the sum of the squares and never taking the square root; 50 comes from reaching 100 correctly and then halving it instead of taking its square root, a candidate who has read the last step as “halve” rather than “root”.
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (c) 21 cm — Method: the perimeter is the distance all the way round the edge, so every side is counted once and the three side lengths are added. Working: the two equal sides give 8 + 8 = 16 cm, and the third side adds 5 cm to that. Answer: the perimeter is 21 cm. The distractors: 16 cm comes from adding the two 8 cm sides and handing that total in before the third side has been included; 13 cm comes from adding one 8 cm side to the 5 cm side, as though the badge carried only the two different lengths printed on it rather than three sides; 24 cm comes from taking all three sides to be 8 cm and working out 3 × 8, which would be the perimeter only if the badge were equilateral.
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
- (d) 15 cm — Method: any two sides of a triangle must together be longer than the third, so the third side must be longer than the difference of the two given sides and shorter than their sum. Working: the difference is 20 − 8 = 12 cm and the sum is 20 + 8 = 28 cm, so the third side must be between 12 cm and 28 cm, and 15 cm lies inside that range. Answer: 15 cm. The distractors: 12 cm is exactly the difference, so the three lengths would lie flat along a straight line and never close into a triangle; 5 cm is shorter than the difference — 5 + 8 = 13 cm cannot reach across the 20 cm side — and is chosen by candidates who check no lower limit at all; 30 cm is longer than the sum of the other two, so those two sides could never meet, and it is chosen by candidates who check no upper limit.
- (c) 3π cm — Circumference = πd. With d = 3 cm, circumference = π × 3 = 3π cm. A student who uses the radius (1.5 cm) instead of the diameter in the formula gets 1.5π cm.
Build your own mix at the worksheet builder.