Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (a) 110° — Method: in a parallelogram the two angles at the ends of one side are co-interior angles between a pair of parallel sides, so they add up to 180°. Working: angle A + angle B = 180°, so angle B = 180° − 70° = 110°. Answer: 110°. The distractors: 70° comes from applying the rule for opposite angles of a parallelogram, which are equal, to two angles that are next to each other instead; 20° comes from treating the two angles as complementary and working out 90° − 70°; 290° comes from using the 360° angle sum of a quadrilateral and taking away only the one angle that is given, 360° − 70°.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (b) 12 cm — Method: the area of a rectangle is one side multiplied by the other, so when the area and one side are known the other side is found by reversing that multiplication — divide the area by the side that is known. Working: 96 ÷ 8 = 12. Answer: 12 cm. The distractors: 88 cm comes from 96 − 8, subtracting the known side as though the area had been made by adding the two sides together; 768 cm comes from 96 × 8, running the area rule forwards on the two numbers given instead of reversing it; 40 cm comes from reading the 96 as a perimeter — halving it to 48 and taking the 8 cm side away — which reverses the perimeter rule rather than the area rule.
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
- (b) 4 — A triangular prism has 5 faces in total: 2 triangular ends and 3 rectangular faces. One rectangular face is the groundsheet, lying on the ground, so the other 5 − 1 = 4 faces are above the ground. A candidate who forgets one of the triangular ends when counting the remaining faces answers 3. A candidate who forgets to subtract the groundsheet at all answers 5. A candidate who only counts the two sloped rectangular faces, forgetting the two triangular ends, answers 2. The number of faces above the ground is 4.
- (d) 80° — The four angles of any quadrilateral add up to 360°. Three of the angles add up to 100 + 85 + 95 = 280°, so the fourth angle is 360 − 280 = 80°. "70°" comes from using 350° as the total instead of 360°, an easy slip on the quadrilateral angle sum. "280°" comes from stopping at the sum of the three given angles and writing that total down as the answer, instead of subtracting it from 360°. "260°" comes from subtracting only the one angle 100° from 360°, instead of subtracting all three given angles.
- (d) Alternate angles are equal — The two 65° angles are on opposite sides of the line that crosses the parallel lines, in the shape of a Z, so they are alternate angles, and alternate angles between parallel lines are always equal. Corresponding angles are equal too, but they sit in matching positions at each crossing point, in the shape of an F — a different pair from the one shown here. Co-interior angles add up to 180°, not to each other's value, and they lie between the parallel lines on the same side, in the shape of a C. Angles on a straight line add up to 180°, but that rule is about two angles at a single point on one line, not about a pair of angles formed where a line crosses two parallel lines.
- (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
- (b) (3, 5) — Method: add the top number of the vector to the x-coordinate and the bottom number to the y-coordinate. Working: adding −3 to the x-coordinate is 6 − 3 = 3, and adding 4 to the y-coordinate is 1 + 4 = 5. Answer: the image of P is (3, 5). Subtracting the vector instead of adding it reverses the translation and gives (9, −3). Adding the top number but subtracting the bottom one, on the assumption that the lower entry always means downwards, gives (3, −3); the minus sign in a vector has already recorded the direction. Reading the two numbers the wrong way round, so that the shape moves 4 across and 3 down, gives (10, −2).
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) The arcs only meet exactly on AB, not above or below it. — With a radius of exactly half of AB, the arc centred at A and the arc centred at B each reach precisely to the midpoint of AB, so they meet only at that one point, on the line AB itself — there are no two intersection points above and below the line to join, so the perpendicular bisector cannot be drawn. (The claim that this radius is always too short to draw any arc is wrong, since a radius equal to half of AB is a perfectly valid, positive length for a compass arc; the claim that the radius must equal the full length of AB is wrong — a longer radius than half of AB would also work, it does not have to equal AB exactly; the claim that the arcs would not cross line AB at all is wrong, since they do cross it — that is exactly the problem, they meet only on it.)
- (b) (12, −9) — Two enlargements one after the other combine into a single scale factor: 1.5 × 2 = 3. Multiplying a vector by a scalar means multiplying both the top number and the bottom number by it: top = 4 × 3 = 12, bottom = −3 × 3 = −9, giving (12, −9). A candidate who adds the scale factor to each number instead of multiplying gets (4 + 3, −3 + 3) = (7, 0). A candidate who multiplies the top number but leaves the bottom number unchanged gets (12, −3). A candidate who multiplies the bottom number but leaves the top number unchanged gets (4, −9). The correct column vector for the poster is (12, −9).
- (d) (1, −6) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate: (1, 6) → (1, −6). A pupil who reflects in the y-axis instead gets (−1, 6). A pupil who changes the sign of both coordinates gets (−1, −6). A pupil who forgets to change any sign leaves the point unmoved at (1, 6). The correct image is (1, −6).
Build your own mix at the worksheet builder.