Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) $\binom{-6}{10}$ — Translating twice by the same vector doubles both components: 2 × $\binom{-3}{5}$ = $\binom{-6}{10}$. $\binom{-3}{5}$ forgets to double the vector at all, giving only one translation's worth. $\binom{-9}{15}$ trebles the vector instead of doubling it. $\binom{-6}{5}$ doubles only the top number and forgets to double the bottom number.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (b) £33.60 — The area of the parallelogram flower bed is base × height = 3.5 × 2 = 7 m². The cost is 7 × £4.80 = £33.60. £16.80 comes from using the triangle formula instead of the parallelogram formula: 3.5 × 2 = 7, and half of 7 is 3.5 m², then 3.5 × £4.80 = £16.80. £26.40 comes from adding the base and height, 3.5+2 = 5.5, instead of multiplying them, then multiplying by £4.80. £7.00 correctly finds the area, 7 m², but forgets to multiply it by the cost per m².
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (a) (−1, 1) — Translating by $\binom{−2}{3}$ subtracts 2 from every x-coordinate and adds 3 to every y-coordinate. This gives image vertices (−1, 4), (3, 4), (3, 7) and (−1, 7). The point (−1, 1) is not one of these: it has the correct new x-coordinate (1 − 2 = −1) but keeps the original y-coordinate (1) instead of adding 3, as if only the horizontal part of the vector had been applied.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (c) 13 — Area of the trapezium = 1/2 × (8 + 12) × 5 = 1/2 × 100 = 50 m². Number of bags = 50 ÷ 4 = 12.5, which rounds up to 13 bags since seed is sold only in whole bags. A student who mistakenly uses 2 m² of coverage per bag instead of 4 m² finds 50 ÷ 2 = 25 bags.
- (a) 12 cm — Area of a parallelogram = base × perpendicular height, so height = area ÷ base = 96 ÷ 8 = 12 cm. A student who adds the area and base instead of dividing gets 96 + 8 = 104 cm. A student who multiplies the area and base instead of dividing gets 96 × 8 = 768 cm. A student who uses the triangle area formula, area = 1/2 × base × height, instead of the parallelogram formula solves 96 = 1/2 × 8 × h and gets h = 24 cm.
- (b) 4 — A triangular prism has 5 faces in total: 2 triangular ends and 3 rectangular faces. One rectangular face is the groundsheet, lying on the ground, so the other 5 − 1 = 4 faces are above the ground. A candidate who forgets one of the triangular ends when counting the remaining faces answers 3. A candidate who forgets to subtract the groundsheet at all answers 5. A candidate who only counts the two sloped rectangular faces, forgetting the two triangular ends, answers 2. The number of faces above the ground is 4.
- (d) The angle between a tangent and a radius is 90° — OP is the radius drawn to the point of contact P, and a circle theorem states that a tangent always meets that radius at a right angle, so angle OPQ = 90°. A tangent is not parallel to the radius it touches — at the point of contact it is perpendicular to that radius, not parallel to it. A tangent does not pass through the centre — a straight line through the centre that also touches the circle at one point would have to be a diameter, which is a different line entirely. The angle-in-a-semicircle theorem needs a triangle drawn inside the circle with a diameter as its longest side; there is no such triangle here, just a tangent and a radius.
- (b) 2 cm — Method: a diameter is made of two radii end to end, so going back from a diameter to a radius undoes that doubling, which gives radius = diameter ÷ 2. Working: the diameter is 4 cm, so the radius is 4 ÷ 2 = 2 cm. Answer: 2 cm. The distractors: 8 cm comes from multiplying by 2 instead of dividing by it, the relationship applied in the wrong direction; 1 cm comes from halving twice, once to reach the radius and then once more as though a second halving were called for; 0.5 cm comes from writing the division upside down as 2 ÷ 4 rather than 4 ÷ 2.
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (b) Triangle — Method: the front elevation is the outline you see looking straight at the solid's front face. Working: this solid's front face is one of its two identical triangular ends, so looking directly at the front shows exactly that triangular outline. Answer: triangle. The distractors: rectangle comes from picturing the side view instead of the front view — looking along the ridge of the prism, the sloping roof faces project as a rectangle. Trapezium comes from misreading the two sloping roof faces as if together they formed a single four-sided shape. Pentagon comes from tracing round the outline of the whole sketch as it is drawn on the page, which is a five-sided shape, instead of drawing only the view seen looking straight at the front of the solid.
- (c) SSA — Method: recall the four basic congruence criteria for triangles and compare them with each option. Working: the four basic conditions are SSS, SAS, ASA and RHS. SSA (two sides and a non-included angle) is not one of them, because knowing two sides and an angle that is not between them does not always fix a unique triangle. Options: SSS, ASA and RHS are each genuine congruence conditions, so none of them is the correct answer to 'which is NOT'. Answer: SSA.
Build your own mix at the worksheet builder.