Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) Equal sides and equal interior angles — Method: recall the full definition of 'regular' as applied to a polygon. Working: a regular polygon must have both equal side lengths and equal interior angles at the same time. Options: 'all sides equal' alone describes an equilateral but not necessarily equiangular shape, such as a rhombus, which is not regular; 'all angles equal' alone describes an equiangular but not necessarily equilateral shape, such as a rectangle, which is not regular; 'at least one line of symmetry' is a much weaker condition that many irregular shapes also satisfy. Answer: equal sides and equal interior angles.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (d) 4 — Method: use the definition of a rectangle — a quadrilateral in which every interior angle is a right angle. Working: a quadrilateral has four interior angles, and in a rectangle all four of them measure 90°, which is consistent with the 360° angle sum because 4 × 90° = 360°. Answer: 4. The distractors: 2 comes from applying the rule that opposite angles are equal and concluding that only one pair of corners is square; 1 comes from thinking that a single square corner is enough to make a shape a rectangle; 0 comes from confusing a rectangle with a general parallelogram, which has no right angles unless it is a rectangle.
- (a) 60° — Method: the three angles of a triangle add up to 180°, so add the two known angles and subtract the total from 180°. Working: 50 + 70 = 120, then 180 − 120 = 60. Answer: 60°. The distractors: 120° is the sum of the two known angles, given as the answer instead of being subtracted from 180°; 110° comes from subtracting only the 70° angle from 180° and forgetting the 50° one; 240° comes from subtracting the sum from 360°, using the angles at a point rather than the angle sum of a triangle.
- (a) 62° — Angle KPQ and angle MQP are co-interior (allied) angles between parallel lines, so they add up to 180°: angle MQP = 180° − 118° = 62°. 118° comes from treating the angles as equal, as if this were a corresponding or alternate angle pair, instead of using the co-interior rule. 90° comes from wrongly assuming the crossing line meets JK and LM at right angles. 59° comes from halving 118° instead of subtracting it from 180°.
- (c) 1 — Method: the instruction states that a curved surface counts as a face, so count the surfaces of the sphere on that basis. Working: a sphere has exactly one continuous curved surface and no flat surfaces at all. A student who answers 0 has ignored the instruction and refused to count the curved surface. A student who answers 2 has confused the sphere with a cylinder, which has two flat circular faces. A student who answers 3 has imagined extra hidden surfaces that do not exist. Answer: 1 face.
- (d) 21 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 15 ÷ 5 = 3. QR = BC × scale factor = 7 × 3 = 21 cm. A student who divides BC by the scale factor instead of multiplying gets 7 ÷ 3 = 2.33 cm. A student who multiplies BC by AB instead of by the scale factor gets 7 × 5 = 35 cm.
- (a) segment — A chord cuts a circle into two regions, and each of these regions is called a segment. A sector is a different region, bounded by two radii and an arc, not by a chord. An arc is a curved part of the circumference, a length, not a region. A radius is a straight line from the centre to the edge, also a length, not a region.
- (c) 1/2 — Method: cos 60° comes from half of an equilateral triangle. Cut an equilateral triangle of side 2 down its middle: each half is right-angled, with hypotenuse 2, base 1 and height √3. Working: cosine is the adjacent side over the hypotenuse, the side alongside the 60° angle is the base of length 1, and the hypotenuse is 2, so cos 60° = 1 ÷ 2. Answer: cos 60° = 1/2. A candidate who assumes the cosine falls steadily from cos 0° = 1 to cos 90° = 0 puts 60° two thirds of the way along and writes 1/3; the cosine does not change at a constant rate. Reading the start of the cosine row gives cos 0° = 1, and reading its end gives cos 90° = 0.
- (c) 38° — The interior angles of a hexagon sum to (6 − 2) × 180° = 720°. 130° + 142° + 125° + 150° + 135° = 682°. x = 720° − 682° = 38°. A student who uses 6 × 180° instead of (6 − 2) × 180°, forgetting to subtract the 2, gets 1080° − 682° = 398°. A student who mis-adds the five given angles as 680° instead of 682° gets x = 720° − 680° = 40°. A student who answers with one of the given angles instead of solving for x might write 142°.
- (c) RHS — Method: check which basic congruence condition matches the facts given — a right angle, the hypotenuse, and one other side, in both triangles. Working: both triangles have a right angle (at M and Q), the hypotenuse is given for both (LN = PR = 15 cm), and one other side is given for both (LM = PQ = 9 cm) — this is exactly Right angle, Hypotenuse, Side. Options: SAS would need the given angle to sit between the two given sides, but the right angle at M is not between LM and LN, since LN is the hypotenuse, opposite the right angle; SSS would need three sides given in each triangle, but only two sides are known here; ASA would need two angles and the side between them, but only one angle is given. Answer: RHS.
- (d) 71° — Alternate angles between parallel lines are equal. Since angle HMN and angle MNK are alternate angles, angle MNK = angle HMN = 71°.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (a) 2 — Method: recall that the diagonals of a rhombus are always lines of symmetry, whatever its angles are. Working: a rhombus (all sides equal) always has its two diagonals as lines of symmetry, giving 2 lines of symmetry, whether or not the angles are 90°. Options: 0 wrongly assumes a non-square rhombus has no symmetry at all; 4 comes from the number of lines of symmetry a square has, mistaking this rhombus for a square; 1 comes from treating the rhombus like a kite, which has only one diagonal as a line of symmetry. Answer: 2.
Build your own mix at the worksheet builder.