Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) Square — Method: two conditions are being asked for at once, so test each shape against both — the two diagonals must always be the same length as each other, and they must always meet at 90°. Working: in a rectangle the diagonals are equal but they meet at 90° only in the special case where the rectangle is also a rhombus; in a rhombus the diagonals do meet at 90° but they are of different lengths unless the rhombus is also a rectangle; the shape that satisfies both conditions for every example of it is the one that is both, and its diagonals are equal and perpendicular. Answer: the square. The distractors: the rectangle is where a candidate stops who tests only the equal-length condition and never checks the angle at the crossing; the rhombus is where a candidate stops who tests only the right-angle condition and never checks the two lengths; the parallelogram is chosen by a candidate who remembers that the diagonals of a parallelogram bisect each other and treats bisecting each other as being equal to each other, which is a different property.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (a) 180 cm³ — Method: the volume of a right prism is the area of its cross-section multiplied by its length, and the area of a triangle is half the base multiplied by the perpendicular height. Working: the cross-section has area (6 × 5) ÷ 2 = 15 cm², and 15 × 12 = 180. Answer: 180 cm³. The distractors: 360 cm³ comes from taking the cross-section as 6 × 5 = 30 and never halving it, which measures the rectangle around the triangular face rather than the face itself; 66 cm³ comes from adding the base and the perpendicular height and halving, (6 + 5) ÷ 2 = 5.5, which is the trapezium rule used where the triangle rule is needed, and then multiplying by the 12 cm length; 15 cm³ comes from working out the triangular cross-section correctly and stopping there, so the 12 cm length is never used and an area is handed in as a volume.
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (c) (5, 1) — Moving right increases the x-coordinate, and moving down decreases the y-coordinate, so (2, 5) becomes (2 + 3, 5 − 4) = (5, 1). (5, 9) comes from adding 4 to the y-coordinate instead of subtracting, as if the point moved up rather than down. (−1, 1) comes from subtracting 3 from the x-coordinate instead of adding, as if the point moved left rather than right. (2, 1) keeps the x-coordinate unchanged and only applies the vertical move, forgetting the horizontal move altogether.
- (c) minor segment — A chord splits a circle into two segments; the smaller of the two is called the minor segment and the larger one the major segment. "major segment" names the larger region, the opposite of what is asked for. "sector" is a different region altogether, enclosed by two radii and an arc, not by a chord. "arc" is a curved length along the circumference, not an enclosed region at all.
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (c) 15/17 — Method: cos θ = adjacent ÷ hypotenuse, so find the hypotenuse with Pythagoras' theorem first and then decide which short side is next to θ. Working: the hypotenuse is √(8² + 15²) = √(64 + 225) = √289 = 17 cm. The angle θ is opposite the 8 cm side, so the side next to it is the 15 cm side, and cos θ = 15 ÷ 17. Answer: 15/17. The distractors: 8/17 is sin θ, opposite over hypotenuse, used in place of the cosine; 8/15 is tan θ, opposite over adjacent; 17/15 comes from writing the cosine ratio upside down, as hypotenuse over adjacent.
- (d) 21 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 15 ÷ 5 = 3. QR = BC × scale factor = 7 × 3 = 21 cm. A student who divides BC by the scale factor instead of multiplying gets 7 ÷ 3 = 2.33 cm. A student who multiplies BC by AB instead of by the scale factor gets 7 × 5 = 35 cm.
- (c) I is the same distance from all three sides. — The angle bisector from A is the locus of points equidistant from sides AB and AC, and the angle bisector from B is the locus of points equidistant from sides AB and BC. Point I lies on both bisectors, so I is equidistant from AB and AC, and also equidistant from AB and BC — meaning I is the same distance from all three sides. (Being the same distance from all three vertices instead describes the circumcentre, found from the perpendicular bisectors of the sides, not the angle bisectors; I being the midpoint of AB confuses the angle bisector construction with the perpendicular bisector of a side; I lying on side AC is wrong because the angle bisectors meet inside the triangle, not on one of its sides.)
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
- (c) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (a) 18 — PQ lies along the x-axis with length 9, and PR lies along the y-axis with length 4, and these two sides meet at right angles at P, so they can be used as the base and height of the triangle. Area = 1/2 × base × height = 1/2 × 9 × 4 = 18. 36 comes from multiplying the base and height but forgetting to halve the result. 13 comes from adding the two lengths, 9 + 4, instead of multiplying them. 26 comes from the perimeter-style calculation 2 × (9 + 4) instead of the triangle area formula.
Build your own mix at the worksheet builder.