Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 12 cm — Area of a parallelogram = base × perpendicular height, so height = area ÷ base = 96 ÷ 8 = 12 cm. A student who adds the area and base instead of dividing gets 96 + 8 = 104 cm. A student who multiplies the area and base instead of dividing gets 96 × 8 = 768 cm. A student who uses the triangle area formula, area = 1/2 × base × height, instead of the parallelogram formula solves 96 = 1/2 × 8 × h and gets h = 24 cm.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (d) 0 — A vertex is a sharp corner point where edges meet. A cylinder has two curved, circular edges but no sharp corner points at all, so it has 0 vertices, making that the correct answer. '2' wrongly treats the two circular edges themselves as vertices, but an edge is not the same as a vertex. '4' overcounts by treating each circular edge as if it had two end-vertices, which does not apply to a continuous curved edge. '1' wrongly imagines the curved surface itself forming a single corner point, which it does not.
- (c) It is a parallelogram but not a rectangle — Method: match the given properties to the definition of each named quadrilateral. Working: having both pairs of opposite sides parallel and equal in length is exactly the definition of a parallelogram; since none of the angles are right angles, it cannot also be a rectangle, which needs four right angles. Options: 'must be a rectangle' wrongly assumes every parallelogram has right angles; 'must be a rhombus' wrongly assumes equal opposite sides means all four sides are equal, but only the opposite pairs are stated as equal here; 'trapezium' is wrong because a trapezium has exactly one pair of parallel sides, while this shape has two pairs, so it is a parallelogram and not a trapezium. Answer: it is a parallelogram but not a rectangle.
- (b) 62 — Method: co-interior (allied) angles between parallel lines add up to 180°. Working: 180 − 118 = 62. Answer: 62°. A candidate who treats co-interior angles as equal, like corresponding angles, gives 118. A candidate who uses 360° instead of 180°, working out 360 − 118, gets 242. A candidate who subtracts as if the angles were complementary, working out 118 − 90, gets 28.
- (a) A flat surface extending infinitely in two directions — Method: recall the precise geometric meaning of 'plane', versus 'line', 'point' and 'face'. Working: a plane is a flat, two-dimensional surface extending infinitely in every direction within it. Options: 'a straight line extending in one direction' describes a line, not a plane; 'a single fixed position with no size' describes a point; 'a flat, bounded face on a 3D shape' describes a face, a bounded piece of a plane, not the plane itself, which has no boundary. Answer: a flat surface extending infinitely in two directions.
- (d) (6, 8) — Method: add column vectors by adding the top numbers together and the bottom numbers together. Working: top numbers 5 + 1 = 6; bottom numbers 2 + 6 = 8. Answer: p + q = (6, 8). A candidate who subtracts instead of adds gets (4, −4). A candidate who swaps the top and bottom of the correct answer gets (8, 6). A candidate who only adds the top numbers and leaves the bottom number of p unchanged gets (6, 2).
- (d) 56.52 cm — Circumference = πd. Substitute d = 18: circumference = 3.14 × 18 = 56.52 cm.
- (a) 5/12 — A sector's area is always the same fraction of the circle as its angle is of the full 360° turn. Here that fraction is 150 out of 360, which simplifies (divide both numbers by 30) to 5/12. Treating a full turn as 180° instead of 360° gives 5/6. Confusing the 150° given with the 180° of a half turn gives 1/2. Working out the fraction OUTSIDE the sector instead of inside it gives 7/12.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) 6 cm — Method: the right angle is at A, so BC is the hypotenuse and AC is the side opposite the angle at B; sin B = opposite ÷ hypotenuse therefore gives AC ÷ BC = 3/5. Working: AC ÷ 10 = 3/5, so AC = 10 × 3 ÷ 5 = 6. Answer: 6 cm. The distractors: 8 cm is AB, the side next to the angle at B, which is what cos B = 4/5 produces — the right method used on the wrong side; 3 cm comes from reading the 3 in the ratio as a length and never scaling it up to the 10 cm hypotenuse; 30 cm comes from multiplying by 3 and forgetting to divide by 5.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (d) They are always equal to each other — Method: label the four angles a, b, c, d in order around the crossing point, then use the fact that neighbouring angles lie on a straight line. Working: a and b lie on a straight line, so a + b = 180°; b and c also lie on a straight line, so b + c = 180°. Both a and c are therefore 180° minus b, which forces a = c. Answer: a pair of vertically opposite angles is always equal to each other. The distractors: the claim that each is 90° holds only when the two lines happen to be perpendicular, so it is not always true; the claim that they add to 180° confuses the opposite pair with the neighbouring pair that lies along a straight line, and again holds only in the perpendicular case; the claim that they add to 360° uses the total of all four angles at the point rather than of the opposite pair.
- (c) ∠XYZ — The angle at a named vertex is written with that vertex's letter in the middle, flanked by its two neighbouring vertices. The angle at Y sits between X and Z, its neighbours in quadrilateral WXYZ, so it is written ∠XYZ. ∠WXY names the angle at X, since X is the middle letter, not Y. ∠YZW names the angle at Z, since Z is the middle letter. ∠ZWX names the angle at W, since W is the middle letter.
- (d) 80° — The four angles of any quadrilateral add up to 360°. Three of the angles add up to 100 + 85 + 95 = 280°, so the fourth angle is 360 − 280 = 80°. "70°" comes from using 350° as the total instead of 360°, an easy slip on the quadrilateral angle sum. "280°" comes from stopping at the sum of the three given angles and writing that total down as the answer, instead of subtracting it from 360°. "260°" comes from subtracting only the one angle 100° from 360°, instead of subtracting all three given angles.
Build your own mix at the worksheet builder.