Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides.
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (c) 90° — A tangent to a circle always meets the radius drawn to the point of contact at a right angle, so the angle between the tangent and the radius at P is 90°. 180° confuses the tangent with the diameter through P, as if the radius continued in a straight line into the tangent. 45° halves the true angle by mistake. 60° comes from confusing this fact with the angle of an equilateral triangle.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
- (c) I is the same distance from all three sides. — The angle bisector from A is the locus of points equidistant from sides AB and AC, and the angle bisector from B is the locus of points equidistant from sides AB and BC. Point I lies on both bisectors, so I is equidistant from AB and AC, and also equidistant from AB and BC — meaning I is the same distance from all three sides. (Being the same distance from all three vertices instead describes the circumcentre, found from the perpendicular bisectors of the sides, not the angle bisectors; I being the midpoint of AB confuses the angle bisector construction with the perpendicular bisector of a side; I lying on side AC is wrong because the angle bisectors meet inside the triangle, not on one of its sides.)
- (a) a cone — A cone, viewed from directly above, shows its circular base as a circle; viewed from the front, its curved surface narrows to a point at the apex, giving a triangle outline — so a circle plan with a triangle elevation identifies a cone. "a cylinder" has a circular plan too, but its front elevation is a rectangle, not a triangle, since its sides run straight up rather than narrowing to a point. "a sphere" gives a circle from every direction, plan and every elevation alike, not a triangle from the front. "a square-based pyramid" gives a triangle from the front, but its plan view is a square, not a circle.
- (b) 47 — Method: angles on a straight line add up to 180°. Working: 180 − 38 − 95 = 47. Answer: x = 47. A candidate who uses 360° instead of 180° gets 227. A candidate who subtracts only one of the two given angles from 180° gets 142. A candidate who adds the two given angles instead of subtracting them from 180° gets 133.
- (b) Its diagonals cross at right angles — In a rhombus, the diagonals always bisect each other at right angles, because a rhombus is a parallelogram with all four sides equal. Its diagonals are not always equal in length — that is a property of a rectangle, and only holds for a rhombus in the special case where it is also a square. It does not always have four right angles — again, that is only true when the rhombus is also a square. Its order of rotational symmetry is generally 2, not 4; order 4 only happens when the rhombus is a square.
- (a) 20 cm — The scale factor from the smaller flag to the larger flag is 5 ÷ 2 = 2.5, so the larger width is 8 × 2.5 = 20 cm. The distractor 3.2 cm comes from using the ratio the wrong way round, 8 × 2 ÷ 5 = 3.2. The distractor 11 cm comes from adding the difference between the ratio numbers (5 − 2 = 3) to the given width, 8 + 3 = 11. The distractor 40 cm comes from multiplying by 5 without dividing by 2 first, 8 × 5 = 40.
- (b) an arc of the same radius, centred at B — The perpendicular bisector construction needs two arcs of equal radius, one centred at each end of the segment — after the arc from A, the next step is an arc of exactly the same radius from B, so the two arcs cross at two points; the line through those two crossing points is the perpendicular bisector. "an arc of the same radius, centred at the midpoint of AB" is not possible yet, since the midpoint is only found once both arcs are drawn — it is the RESULT of the construction, not a step in it. "a smaller arc, centred at A again" gives two different-sized arcs from the same point, which never cross to give the bisector. "a straight line joining the ends of the first arc" only connects points on one arc, and locates nothing.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (a) 31.4 — Method: first find the circumference of one turn using π × diameter, then multiply by the number of turns. Working: circumference = 3.14 × 0.5 = 1.57 m; total distance = 1.57 × 20 = 31.4 m. A student who answers 15.7 has mistakenly halved the diameter again before multiplying, using 0.25 m instead of 0.5 m. A student who answers 3.14 has simply written down π itself, without completing the circumference or multiplying by the number of turns. A student who answers 62.8 has mistakenly doubled the diameter to 1 m before multiplying, treating the given length as a radius. Answer: 31.4 m.
Build your own mix at the worksheet builder.