Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) base angles of an isosceles triangle are equal — Because AB = AC, triangle ABC is isosceles, and the base angles of an isosceles triangle — the two angles opposite the equal sides — are always equal, which is why angle C equals angle B, 70°. Angles in a triangle adding up to 180° is a true fact about the triangle as a whole, but it is not the reason two specific angles are equal to each other. Corresponding angles are equal is a fact about parallel lines cut by a transversal, which does not apply inside a single triangle like this. Vertically opposite angles are equal is a fact about two lines crossing, not about a triangle's base angles.
- (c) 1/4 — A full turn at the centre of a circle is 360°, so a sector's fraction of the circle is its angle divided by 360°: 90 ÷ 360 = 1/4. 1/2 would be the fraction for a sector with an angle of 180°, not 90°. 3/4 is the fraction of the rest of the circle, the major sector left over from the 270° that is not part of this sector. 1/8 would be the fraction for a sector with an angle of 45°, half of 90°.
- (c) Radius — Method: recall that a sector is formed using two straight lines drawn from the centre out to the circle's edge. Working: each straight edge of a sector runs from the centre of the circle to a point on the circumference. A student who answers chord has confused a straight edge from the centre with one joining two points on the circumference. A student who answers diameter has wrongly assumed the two straight edges must form a single full diameter. A student who answers arc has named the curved edge instead of the straight edges. Answer: radius (radii).
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (b) It is the longest of the three chords — Method: in any circle the length of a chord is decided by how far the chord lies from the centre, because a chord passing nearer the centre cuts further across the circle. Working: the chord through O lies at a distance of zero from the centre, and no chord can lie closer than that, so no chord of the circle can be longer than it; a chord through the centre is a diameter. The other two chords lie at some distance greater than zero, so each of them falls short of that maximum. Answer: It is the longest of the three chords. The distractors: It is the shortest of the three chords comes from reversing the rule and picturing a chord near the centre as a short line tucked inside; It is the same length as the other two chords comes from carrying the fact that all radii of a circle are equal across to chords, which are not all equal; It is half the length of each of the other two chords comes from confusing a chord through the centre with a radius, which really is half a diameter.
- (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.
- (c) 1 — Method: a right angle measures 90°, the three angles of any triangle add up to 180°, and a right-angled triangle is defined as a triangle that contains a right angle. Working: taking one right angle out of the total leaves 180° − 90° = 90° to be shared between the other two angles, so both of those must be acute; a second right angle would use the whole of that remaining 90° and leave nothing at all for the third angle, which is impossible. The definition therefore fixes the count at exactly one. Answer: 1. The distractors: 2 comes from counting the two sides that form the right angle instead of counting the angles themselves; 3 comes from reading the name as a description of the whole triangle, so that all three of its angles are taken to be right angles, which would need an angle sum of 3 × 90° = 270°; 0 comes from over-applying the angle sum — a candidate who works out that 90° + 90° = 180° leaves nothing for a third angle can conclude from that alone that no triangle may contain a right angle at all.
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (a) 8 — A cylinder has two flat circular faces (the top and the base) and one curved surface, so only its 2 flat faces are wrapped. A cuboid has 6 faces and all of them are flat, so all 6 are wrapped. Adding these: 2 + 6 = 8, so 8 is correct. 9 comes from wrongly counting the cylinder's curved surface as a flat face. 6 comes from counting only the cuboid and forgetting the cylinder's two flat circular faces. 3 comes from counting only the cylinder and including its curved surface in that total.
- (d) Yes, since 3² + 4² = 5² — AB is horizontal with length 5 − 1 = 4, BC is vertical with length 4 − 1 = 3, and CA = √(4² + 3²) = √25 = 5. Since the two shorter sides satisfy 3² + 4² = 5², the triangle is right-angled, with the right angle at B. "No, since 3 + 4 ≠ 5" wrongly tests Pythagoras' theorem by adding the sides instead of squaring them first. "No, since AB, BC and CA are not all equal" confuses a right-angled triangle with an equilateral one — a triangle does not need equal sides to have a right angle. "Yes, since 4² + 5² = 3²" reaches the correct conclusion but puts the longest side, 5, on the wrong side of the equation, as if it were one of the two shorter sides instead of the hypotenuse.
- (c) ∠XYZ — The angle at a named vertex is written with that vertex's letter in the middle, flanked by its two neighbouring vertices. The angle at Y sits between X and Z, its neighbours in quadrilateral WXYZ, so it is written ∠XYZ. ∠WXY names the angle at X, since X is the middle letter, not Y. ∠YZW names the angle at Z, since Z is the middle letter. ∠ZWX names the angle at W, since W is the middle letter.
- (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
- (a) (5, 2) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate, so (5, −2) maps to (5, 2). (−5, −2) changes the sign of the x-coordinate instead, which is what happens when reflecting in the y-axis. (−5, 2) changes the sign of both coordinates, which is the result of a rotation of 180° about the origin, not a reflection in the x-axis. (2, 5) comes from dropping the minus sign and then swapping the two numbers round, so neither coordinate has actually been reflected.
- (d) A prism — A prism has two identical, parallel polygon faces (its cross-section) joined by flat rectangular side faces, so the same cross-sectional shape runs all the way along its length — this description matches a prism. A pyramid instead narrows from one polygon base up to a single point (the apex), so it does not have two identical parallel faces. A cone has one curved surface and a single circular base narrowing to a point — no flat rectangular sides at all. A cylinder has two identical circular faces, but they are joined by a curved surface, not by flat rectangles.
- (b) Cuboid — not necessarily a cube — A solid with 6 faces, 12 edges and 8 vertices in which every face is a rectangle is a cuboid, but nothing here confirms that all the edges are the same length, so the box could be a cube or a non-cube cuboid; the most that can be concluded is that it is a cuboid, making 'Cuboid — not necessarily a cube' correct. 'Cube — only a cube fits this' is wrong because a cube is just one particular cuboid; a general cuboid with different length, width and height has exactly the same face, edge and vertex counts and rectangular faces. 'Triangular prism' is wrong because a triangular prism has 5 faces, 9 edges and 6 vertices, and two of its faces are triangles, so it matches neither the counts nor the face shape. 'Not enough information' is wrong because rectangular faces with these counts do pin the solid down to the cuboid family, even though they cannot pin down a cube specifically.
Build your own mix at the worksheet builder.