Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (c) It is a parallelogram but not a rectangle — Method: match the given properties to the definition of each named quadrilateral. Working: having both pairs of opposite sides parallel and equal in length is exactly the definition of a parallelogram; since none of the angles are right angles, it cannot also be a rectangle, which needs four right angles. Options: 'must be a rectangle' wrongly assumes every parallelogram has right angles; 'must be a rhombus' wrongly assumes equal opposite sides means all four sides are equal, but only the opposite pairs are stated as equal here; 'trapezium' is wrong because a trapezium has exactly one pair of parallel sides, while this shape has two pairs, so it is a parallelogram and not a trapezium. Answer: it is a parallelogram but not a rectangle.
- (c) 2 — A cylinder has 3 faces in total: 1 curved surface and 2 flat circular faces, the base and the lid. The label covers only the curved surface, leaving the base and the lid uncovered — that is 2 faces. A candidate who forgets one of the two flat faces answers 1. A candidate who mistakenly splits the curved surface into two separate uncovered faces and then adds the 2 flat faces answers 4. A candidate who assumes the label covers the whole tin answers 0. The number of faces not covered by the label is 2.
- (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
- (d) points the same distance from A as from B — The perpendicular bisector of AB is, by definition, the locus of every point equidistant from A and B — any point on it forms two congruent right-angled triangles with A and B, which is exactly the property the construction guarantees. "points as far from A as the length AB" describes a circle centred at A with radius AB, not a bisector. "the single point exactly halfway along AB" names only the midpoint, one point, not the whole locus the construction produces. "points twice as far from A as from B" describes a different curve entirely, not a straight line construction.
- (b) 360 cm² — Method: the total surface area is the square base plus the four triangular faces, and the height used for a triangular face is the slant height of 13 cm, not the vertical height of 12 cm. Working: the base is 10 × 10 = 100 cm²; one triangular face is (10 × 13) ÷ 2 = 65 cm², so four faces give 4 × 65 = 260 cm²; the total is 100 + 260 = 360. Answer: 360 cm². The distractors: 260 cm² comes from adding the four triangular faces and leaving out the base; 340 cm² comes from using the vertical height of 12 cm as the height of each triangle, 100 + 4 × 60; 620 cm² comes from working out each face as 10 × 13 without halving, 100 + 4 × 130.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (b) 12 cm — Method: the area of a rectangle is one side multiplied by the other, so when the area and one side are known the other side is found by reversing that multiplication — divide the area by the side that is known. Working: 96 ÷ 8 = 12. Answer: 12 cm. The distractors: 88 cm comes from 96 − 8, subtracting the known side as though the area had been made by adding the two sides together; 768 cm comes from 96 × 8, running the area rule forwards on the two numbers given instead of reversing it; 40 cm comes from reading the 96 as a perimeter — halving it to 48 and taking the 8 cm side away — which reverses the perimeter rule rather than the area rule.
- (d) a² + b² = c² — Pythagoras' theorem states that the square of the hypotenuse equals the sum of the squares of the other two sides, so a² + b² = c². "a + b = c" adds the sides directly without squaring them at all. "a² − b² = c²" subtracts the squares instead of adding them. "a² + b² = c" adds the squares correctly but forgets to square the hypotenuse on the other side of the equation.
- (b) 55° — Method: complementary angles are a pair that add up to 90°, so subtract the known angle from 90°. Working: 90 − 35 = 55. Answer: 55°. The distractors: 145° comes from subtracting from 180°, which is the rule for supplementary angles and not for complementary ones; 325° comes from subtracting from 360°, the total of the angles at a point; 90° is the total that the pair must make, written down in place of the missing angle.
- (b) 2 cm — Method: a diameter is made of two radii end to end, so going back from a diameter to a radius undoes that doubling, which gives radius = diameter ÷ 2. Working: the diameter is 4 cm, so the radius is 4 ÷ 2 = 2 cm. Answer: 2 cm. The distractors: 8 cm comes from multiplying by 2 instead of dividing by it, the relationship applied in the wrong direction; 1 cm comes from halving twice, once to reach the radius and then once more as though a second halving were called for; 0.5 cm comes from writing the division upside down as 2 ÷ 4 rather than 4 ÷ 2.
Build your own mix at the worksheet builder.