Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
- (b) 7 units right and 2 units down — In the column vector $\binom{7}{−2}$, the top number gives the horizontal movement and the bottom number gives the vertical movement. A positive top number (7) means 7 units to the right, and a negative bottom number (−2) means 2 units down. The distractor '7 units left and 2 units up' reverses both signs, as if the vector were $\binom{−7}{2}$. The distractor '2 units right and 7 units down' swaps the horizontal and vertical numbers around. The distractor '7 units right and 2 units up' gets the horizontal movement correct but reverses the sign of the vertical movement.
- (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (a) A flat surface extending infinitely in two directions — Method: recall the precise geometric meaning of 'plane', versus 'line', 'point' and 'face'. Working: a plane is a flat, two-dimensional surface extending infinitely in every direction within it. Options: 'a straight line extending in one direction' describes a line, not a plane; 'a single fixed position with no size' describes a point; 'a flat, bounded face on a 3D shape' describes a face, a bounded piece of a plane, not the plane itself, which has no boundary. Answer: a flat surface extending infinitely in two directions.
- (a) 32 cm² — Area of a trapezium = 1/2 × (sum of parallel sides) × height = 1/2 × (5 + 11) × 4 = 1/2 × 16 × 4 = 32 cm². (64 cm² comes from forgetting to halve the product; 44 cm² comes from using only the longer parallel side, 11 × 4, instead of both parallel sides; 20 cm² comes from adding all three given lengths together, 5 + 11 + 4, instead of using the area formula.)
- (c) 21 cm — Method: the perimeter is the distance all the way round the edge, so every side is counted once and the three side lengths are added. Working: the two equal sides give 8 + 8 = 16 cm, and the third side adds 5 cm to that. Answer: the perimeter is 21 cm. The distractors: 16 cm comes from adding the two 8 cm sides and handing that total in before the third side has been included; 13 cm comes from adding one 8 cm side to the 5 cm side, as though the badge carried only the two different lengths printed on it rather than three sides; 24 cm comes from taking all three sides to be 8 cm and working out 3 × 8, which would be the perimeter only if the badge were equilateral.
- (c) 1/2 — Method: cos 60° comes from half of an equilateral triangle. Cut an equilateral triangle of side 2 down its middle: each half is right-angled, with hypotenuse 2, base 1 and height √3. Working: cosine is the adjacent side over the hypotenuse, the side alongside the 60° angle is the base of length 1, and the hypotenuse is 2, so cos 60° = 1 ÷ 2. Answer: cos 60° = 1/2. A candidate who assumes the cosine falls steadily from cos 0° = 1 to cos 90° = 0 puts 60° two thirds of the way along and writes 1/3; the cosine does not change at a constant rate. Reading the start of the cosine row gives cos 0° = 1, and reading its end gives cos 90° = 0.
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
- (c) 62° — Co-interior (allied) angles on parallel lines sum to 180°, so the co-interior angle is 180° − 118° = 62°. 118° comes from treating the angles as corresponding angles, which are equal, instead of co-interior angles, which sum to 180°. 59° comes from halving the given angle. 236° comes from doubling the given angle.
- (c) 24 — PQ lies along the x-axis with length 6, and PR lies along the y-axis with length 8, meeting at a right angle at P, so QR = √(6² + 8²) = √100 = 10. The perimeter is 6 + 8 + 10 = 24. "14" adds only the two shorter sides, PQ and PR, and leaves out the hypotenuse QR completely. "28" comes from finding QR incorrectly as 6 + 8 = 14 instead of using Pythagoras' theorem, then adding 6 + 8 + 14. "48" comes from multiplying the two shorter sides, 6 × 8, instead of finding and adding all three sides of the triangle.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (c) $\binom{4}{−3}$ — A positive top number moves a point to the right, and a negative bottom number moves it downwards, so $\binom{4}{−3}$ is right and down. $\binom{−4}{3}$ moves left and up — the opposite direction on both axes. $\binom{4}{3}$ moves right, like the key, but its positive bottom number moves it up, not down. $\binom{−4}{−3}$ moves down, like the key, but its negative top number moves it left, not right.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (b) SAS (two sides and the included angle) — PQ = ST and QR = TU are two pairs of matching sides, and the angle between them (angle Q and angle T) is 90° in both triangles — two sides and the angle between them are equal, so the triangles are congruent by SAS, using only the measurements given. RHS needs the hypotenuses to be known equal; here only the two legs are given, so you would first have to work out each hypotenuse by Pythagoras' theorem — extra working the question rules out. SSS has the same problem: the third side of each triangle is not given, only calculable. ASA needs two angles and the side between them, but here it is two sides and the angle between them that are given, not two angles.
Build your own mix at the worksheet builder.