Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) angle B = angle E — AB and BC meet at vertex B, so the angle INCLUDED between them is angle B; making angle B = angle E completes SAS. Angle A sits between AB and AC, not between AB and BC, so it is not the included angle needed for SAS here. Angle C sits between BC and CA, not between AB and BC, so it is not included either. AC = DF would give a third pair of equal sides, which proves congruence by SSS instead of SAS.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (b) (5, 1) — First scale a by 2: 2a = (2×3, 2×(−2)) = (6, −4). Then add b component by component: (6+(−1), −4+5) = (5, 1). (2, 3) is a + b without doubling a first. (4, 6) doubles both a and b instead of only a. (7, −9) subtracts b from 2a instead of adding it.
- (a) 2 — A cone has one flat face — the circular base — and one curved surface, which is counted as a single face. That gives a total of 2 faces. A candidate who forgets the circular base and counts only the curved surface answers 1. A candidate who mistakenly splits the curved surface into two faces answers 3. A candidate who thinks a cone has no flat faces at all answers 0. The correct number of faces is 2.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
- (a) Triangular-based pyramid (tetrahedron) — A solid with 4 triangular faces, 4 vertices and 6 edges is a triangular-based pyramid, also called a tetrahedron. A triangular prism also has triangular faces, but it has 2 triangular faces plus 3 rectangular faces, 6 vertices and 9 edges — the extra rectangular faces and edges rule it out here. A square-based pyramid has 5 faces (one square, four triangles), 5 vertices and 8 edges, which does not match. A cube has 6 faces, 8 vertices and 12 edges, all much higher than the numbers given. The solid described is a triangular-based pyramid.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (d) 56.52 cm — Circumference = πd. Substitute d = 18: circumference = 3.14 × 18 = 56.52 cm.
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (c) Square — Because the cut is parallel to the square base, it produces a shape that is similar to the base — the same shape, scaled down — so it is also a square, with four equal sides, smaller than the base. A candidate who looks at the sloped triangular faces instead of at the horizontal cut answers triangle. A candidate who pictures a slanted cut, which would shorten one pair of sides, answers trapezium, but a cut parallel to the base scales all four sides by the same amount. A candidate who counts an extra side, perhaps including an edge of the base, answers pentagon. The cross-section is a square.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (a) Parallel, since both gradients are 2 — Gradient of line 1 = (5 − 1) ÷ (2 − 0) = 4 ÷ 2 = 2. Gradient of line 2 = (6 − 2) ÷ (5 − 3) = 4 ÷ 2 = 2. The two gradients are equal, so the lines are parallel. "Not parallel, since the gradients are 2 and 4" uses 4 for line 2, which comes from dividing the change in y, 4, by 1 rather than by the change in x, 5 − 3 = 2. "Not parallel, since the two lines cross the y-axis at different points" confuses parallel lines with the same line repeated — parallel lines are distinct lines, and where a line crosses the y-axis has no effect on its gradient. "Parallel, since both lines pass through positive coordinates" reaches the right conclusion for the wrong reason: lines are parallel because their gradients are equal, not because the coordinates given happen to be positive.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
Build your own mix at the worksheet builder.