Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 90° — A tangent to a circle always meets the radius drawn to the point of contact at a right angle, so the angle between the tangent and the radius at P is 90°. 180° confuses the tangent with the diameter through P, as if the radius continued in a straight line into the tangent. 45° halves the true angle by mistake. 60° comes from confusing this fact with the angle of an equilateral triangle.
- (b) 340 — The real length of the path is 8.5 × 2000 = 17000 cm, which converts to 170 m by dividing by 100. The cyclist rides the path there and back, so the total distance is 170 × 2 = 340 m. A candidate who forgets the return journey gives only the one-way distance, 170 m. A candidate who halves the one-way distance instead of doubling it, reading “there and back” as splitting the journey, gets 85 m. A candidate who doubles the scale factor to 4000 by mistake, getting a one-way length of 340 m, and then doubles that for the return journey, gets 680 m. The total distance the cyclist travels is 340 m.
- (d) An obtuse angle — Method: compare the angle with the two markers that separate the angle names, a right angle at 90° and a straight line at 180°. Working: 108° is greater than 90° and smaller than 180°, so it lies between the right angle and the straight line. Answer: an obtuse angle. The distractors: an acute angle is one below 90°, and is chosen by a candidate who checks only that 108° is less than 180°; a reflex angle is one above 180°, and is chosen by a candidate who checks only that 108° is more than 90° and then takes the largest category; a right angle is exactly 90°, and is chosen by reading 108° as near enough to 90° instead of comparing it properly.
- (c) 5 cm — Diameter = circumference ÷ π, so 31.4 ÷ 3.14 = 10 cm, and the radius is half the diameter, so 10 ÷ 2 = 5 cm. 10 cm is the diameter itself, given as the radius by forgetting the final halving step. 15.7 cm comes from halving the circumference, 31.4 ÷ 2 = 15.7, and stopping there, treating half the circumference as the radius without ever dividing by π. 2.5 cm comes from halving the correct radius again, effectively dividing by 2 twice instead of once.
- (d) (6, 8) — Method: add column vectors by adding the top numbers together and the bottom numbers together. Working: top numbers 5 + 1 = 6; bottom numbers 2 + 6 = 8. Answer: p + q = (6, 8). A candidate who subtracts instead of adds gets (4, −4). A candidate who swaps the top and bottom of the correct answer gets (8, 6). A candidate who only adds the top numbers and leaves the bottom number of p unchanged gets (6, 2).
- (d) Similar, by SAS — Method: read off whether the given sides are equal or only in the same ratio, and where the given angle sits. Sides in proportion point to similarity; sides equal in length would be needed for congruence. Working: AB ÷ DE = AC ÷ DF gives two pairs of corresponding sides in the same ratio, and the equal angle at A and D lies between AB and AC in the first triangle and between DE and DF in the second, so it is the included angle. Two pairs of sides in proportion with the included angle equal is the SAS condition for similarity. Answer: similar, by SAS. The distractors: 'Similar, by AA' quotes a condition that needs two pairs of equal angles, while only one pair is given here; 'Congruent, by SAS' reads AB ÷ DE = AC ÷ DF as AB = DE and AC = DF, turning a statement about proportion into one about equal lengths; 'Congruent, by SSS' makes that same misreading and adds an assumption that the third pair of sides is equal too, which nothing in the question says.
- (c) ∠XYZ — The angle at a named vertex is written with that vertex's letter in the middle, flanked by its two neighbouring vertices. The angle at Y sits between X and Z, its neighbours in quadrilateral WXYZ, so it is written ∠XYZ. ∠WXY names the angle at X, since X is the middle letter, not Y. ∠YZW names the angle at Z, since Z is the middle letter. ∠ZWX names the angle at W, since W is the middle letter.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (d) 56.52 cm — Circumference = πd. Substitute d = 18: circumference = 3.14 × 18 = 56.52 cm.
- (a) 70° — Method: the three angles of a triangle add up to 180°, so take the known corner away from 180° to find what is left for the other two corners, then share that remainder equally because those two corners are equal. Working: 180 − 40 = 140, and the two equal corners share that 140° between them, so 140 ÷ 2 = 70. Answer: 70°. The distractors: 140° comes from stopping after 180 − 40 and offering the combined total of the two equal corners as though it were the size of one of them; 20° comes from halving the 40° corner that was given instead of halving the 140° that the other two corners have to share; 50° comes from 90 − 40, using the two acute angles of a right-angled triangle as the fixed total rather than the 180° angle sum of the whole triangle.
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (c) RHS — Method: check which basic congruence condition matches the facts given — a right angle, the hypotenuse, and one other side, in both triangles. Working: both triangles have a right angle (at M and Q), the hypotenuse is given for both (LN = PR = 15 cm), and one other side is given for both (LM = PQ = 9 cm) — this is exactly Right angle, Hypotenuse, Side. Options: SAS would need the given angle to sit between the two given sides, but the right angle at M is not between LM and LN, since LN is the hypotenuse, opposite the right angle; SSS would need three sides given in each triangle, but only two sides are known here; ASA would need two angles and the side between them, but only one angle is given. Answer: RHS.
- (a) 65° — Method: a line that divides an angle into two equal parts gives each part half of the original angle, so halve 130°. Working: 130 ÷ 2 = 65. Answer: 65°. The distractors: 130° is the whole of angle ABC, written down without halving it; 50° comes from working out 180 − 130, using the angles on a straight line instead of dividing the angle in two; 32.5° comes from dividing by 4 instead of by 2, as though the line split the angle into four equal parts.
- (b) 68° — Method: two properties are needed. Angle A and angle D are co-interior angles between the parallel sides AB and DC, so they add up to 180°; and because the trapezium is isosceles, the two angles on the side AB are equal, so angle B = angle A. Working: angle A = 180° − 112° = 68°, and angle B = angle A = 68°. Answer: 68°. The distractors: 112° comes from assuming that angles B and D are equal, which is the property of a parallelogram, not of a trapezium; 90° comes from assuming that the angles on the other parallel side must be right angles; 248° comes from using the 360° angle sum of a quadrilateral and taking away only the one angle that is given.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
Build your own mix at the worksheet builder.