Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) $\binom{4}{−3}$ — A positive top number moves a point to the right, and a negative bottom number moves it downwards, so $\binom{4}{−3}$ is right and down. $\binom{−4}{3}$ moves left and up — the opposite direction on both axes. $\binom{4}{3}$ moves right, like the key, but its positive bottom number moves it up, not down. $\binom{−4}{−3}$ moves down, like the key, but its negative top number moves it left, not right.
- (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
- (d) A rectangle — Method: to find the plan view, work out the outline traced when looking straight down onto the solid from directly above, not the outline shown in the angled sketch. Working: this solid has two identical flat round ends joined by one curved surface, and it is lying on its side rather than standing upright; viewed from above, the curved surface gives two straight edges running the full length of the solid, the width of the round ends apart, and each flat round end — seen edge-on from directly above — also becomes a straight edge of that same width, with no curve remaining. Four straight edges, with opposite sides equal and meeting at right angles, form a rectangle. Answer: a rectangle. The distractors: a circle comes from picturing the solid as if it were standing upright on one of its flat ends, giving the plan of an upright version instead of working out the plan of the solid as it actually lies. An oval comes from copying the foreshortened shape of a round end as it is drawn in the angled sketch, instead of working out the true shape seen from directly above, which has no such foreshortening. A rectangle with rounded ends comes from carrying the curve of the round ends over into the plan view, when in fact a flat round end viewed edge-on from directly above shows no curve at all, only a straight edge.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (d) (6, 8) — Method: add column vectors by adding the top numbers together and the bottom numbers together. Working: top numbers 5 + 1 = 6; bottom numbers 2 + 6 = 8. Answer: p + q = (6, 8). A candidate who subtracts instead of adds gets (4, −4). A candidate who swaps the top and bottom of the correct answer gets (8, 6). A candidate who only adds the top numbers and leaves the bottom number of p unchanged gets (6, 2).
- (a) 8 — Method: two capacities can only be divided once they are written in the same unit. Working: there are 1000 ml in 1 litre, so the bottle holds 2 × 1000 = 2000 ml. Then 2000 ÷ 250 = 8. Answer: 8 glasses. Using 1 litre = 10 000 ml gives 20 000 ÷ 250 = 80. Dividing the two numbers as they stand, 250 ÷ 2 = 125, ignores the units altogether. Converting the glass into litres with the wrong factor, as though 250 ml were 2.5 litres, gives 2 ÷ 2.5 = 0.8.
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
- (c) 5 hours — The distance from the origin to (7, 24) is √(7² + 24²) = √(49 + 576) = √625 = 25 km. Travelling at 5 km per hour, the time taken is 25 ÷ 5 = 5 hours. 25 hours mistakes the distance itself for the time, forgetting to divide by the speed. 125 hours comes from multiplying the distance by the speed, 25 × 5, instead of dividing. 0.2 hours comes from dividing the speed by the distance, 5 ÷ 25, the wrong way round.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
Build your own mix at the worksheet builder.