Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (a) 105° — The interior angles of a pentagon add up to (5 − 2) × 180° = 540°. Subtracting the three known angles, 540 − 100 − 110 − 120 = 210°, and this 210° is shared equally between the two angles marked x°, so each one is 210 ÷ 2 = 105°. 210° stops one step early, giving the total of the two unknown angles instead of one of them. 108° is the interior angle of a regular pentagon, which does not apply here since this pentagon's angles are not all equal. 55° comes from halving one of the given angles, 110°, instead of halving the remaining total.
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (c) 13 cm — Method: the two given sides meet at the right angle, so they are the shorter pair and the hypotenuse comes from Pythagoras' theorem, a² + b² = c². Working: c² = 5² + 12² = 25 + 144 = 169, so c = √169 = 13. Answer: 13 cm. The distractors: 17 cm comes from adding the two sides, 5 + 12, rather than adding their squares; 60 cm comes from multiplying them, 5 × 12, which is twice the area of the triangle and not a length; 7 cm comes from subtracting, 12 − 5, as though the hypotenuse were the difference of the two shorter sides.
- (c) $\binom{-6}{5}$ — Method: to undo a translation, travel the same journey backwards. A move of 6 to the right is undone by a move of 6 to the left, and a move of 5 down is undone by a move of 5 up, so both numbers change sign. Working: the top number 6 becomes −6 and the bottom number −5 becomes 5. Check by combining the two: 6 − 6 = 0 across and −5 + 5 = 0 up, so the shape finishes where it started. Answer: $\binom{-6}{5}$. Reversing only the horizontal movement gives $\binom{-6}{-5}$ and reversing only the vertical movement gives $\binom{6}{5}$, and each of those leaves the shape displaced. Swapping the two entries instead of changing their signs gives $\binom{-5}{6}$.
- (a) 32 cm² — Area of a trapezium = 1/2 × (sum of parallel sides) × height = 1/2 × (5 + 11) × 4 = 1/2 × 16 × 4 = 32 cm². (64 cm² comes from forgetting to halve the product; 44 cm² comes from using only the longer parallel side, 11 × 4, instead of both parallel sides; 20 cm² comes from adding all three given lengths together, 5 + 11 + 4, instead of using the area formula.)
- (a) 70° — Method: the three angles of a triangle add up to 180°, so take the known corner away from 180° to find what is left for the other two corners, then share that remainder equally because those two corners are equal. Working: 180 − 40 = 140, and the two equal corners share that 140° between them, so 140 ÷ 2 = 70. Answer: 70°. The distractors: 140° comes from stopping after 180 − 40 and offering the combined total of the two equal corners as though it were the size of one of them; 20° comes from halving the 40° corner that was given instead of halving the 140° that the other two corners have to share; 50° comes from 90 − 40, using the two acute angles of a right-angled triangle as the fixed total rather than the 180° angle sum of the whole triangle.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (a) 20 cm — The scale factor from the smaller flag to the larger flag is 5 ÷ 2 = 2.5, so the larger width is 8 × 2.5 = 20 cm. The distractor 3.2 cm comes from using the ratio the wrong way round, 8 × 2 ÷ 5 = 3.2. The distractor 11 cm comes from adding the difference between the ratio numbers (5 − 2 = 3) to the given width, 8 + 3 = 11. The distractor 40 cm comes from multiplying by 5 without dividing by 2 first, 8 × 5 = 40.
- (b) £5.00 — Perimeter of the kite = 25 + 25 + 40 + 40 = 130 cm = 1.3 m. The frame is sold only in whole metres, so 2 m must be bought. Cost = 2 × £2.50 = £5.00. A student who buys the exact 1.3 m instead of rounding up to whole metres gets 1.3 × £2.50 = £3.25. A student who never converts the perimeter from centimetres to metres and costs 130 × £2.50 gets £325.00.9 m, which rounds up to 3 whole metres, costing 3 × £2.50 = £7.50.
- (a) segment — A chord cuts a circle into two regions, and each of these regions is called a segment. A sector is a different region, bounded by two radii and an arc, not by a chord. An arc is a curved part of the circumference, a length, not a region. A radius is a straight line from the centre to the edge, also a length, not a region.
- (c) 3200 — Method: to change cubic metres to litres, multiply by 1000. Working: 3.2 × 1000 = 3200. Answer: 3200 litres. A candidate who multiplies by 100 instead of 1000 gets 320. A candidate who multiplies by 10000 instead of 1000 gets 32000. A candidate who does not convert at all gives 3.2.
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (d) A prism — A prism has two identical, parallel polygon faces (its cross-section) joined by flat rectangular side faces, so the same cross-sectional shape runs all the way along its length — this description matches a prism. A pyramid instead narrows from one polygon base up to a single point (the apex), so it does not have two identical parallel faces. A cone has one curved surface and a single circular base narrowing to a point — no flat rectangular sides at all. A cylinder has two identical circular faces, but they are joined by a curved surface, not by flat rectangles.
Build your own mix at the worksheet builder.