Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 65° — Method: a line that divides an angle into two equal parts gives each part half of the original angle, so halve 130°. Working: 130 ÷ 2 = 65. Answer: 65°. The distractors: 130° is the whole of angle ABC, written down without halving it; 50° comes from working out 180 − 130, using the angles on a straight line instead of dividing the angle in two; 32.5° comes from dividing by 4 instead of by 2, as though the line split the angle into four equal parts.
- (b) Right angle, equal hypotenuse, one more side — RHS requires a right angle in each triangle, equal hypotenuses, and one further pair of equal sides, so 'right angle, equal hypotenuse, one more side' is correct. 'Right angle, hypotenuse, one more angle' is wrong because it asks for an extra equal angle instead of an extra equal side, which RHS does not check. 'Two sides and the angle between them' describes SAS, not RHS, so it is wrong. 'Right angle and all three sides equal' describes SSS with an extra right-angle condition, asking for more information than RHS actually needs, so it is wrong.
- (b) 55° — Method: complementary angles are a pair that add up to 90°, so subtract the known angle from 90°. Working: 90 − 35 = 55. Answer: 55°. The distractors: 145° comes from subtracting from 180°, which is the rule for supplementary angles and not for complementary ones; 325° comes from subtracting from 360°, the total of the angles at a point; 90° is the total that the pair must make, written down in place of the missing angle.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (d) XP is the shortest distance from X to the line — The perpendicular from a point to a line always gives the shortest possible distance to that line — joining X to any other point on the line forms the hypotenuse of a right-angled triangle with XP as one of the shorter sides, and a hypotenuse is always longer than either of the other two sides. So XP is shorter than the distance to every other point on the line. "XP is the longest distance from X to the line" reverses this relationship. "XP equals every other distance from X to the line" would only be true if X were equidistant from every point on the line, which is impossible for a point and a straight line. "XP cannot be compared without knowing the line's length" is false — the shortest-distance fact holds whatever the line's length, since only the local right angle matters.
- (d) √3/2 — cos 30° is one of the exact values you must know: cos 30° = √3/2. The value 1/2 is the exact value of sin 30° (and of cos 60°), not cos 30°. The value √2/2 is the exact value of cos 45° (and of sin 45°). The value 1 is the exact value of cos 0°.
- (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
- (b) (12, −9) — Two enlargements one after the other combine into a single scale factor: 1.5 × 2 = 3. Multiplying a vector by a scalar means multiplying both the top number and the bottom number by it: top = 4 × 3 = 12, bottom = −3 × 3 = −9, giving (12, −9). A candidate who adds the scale factor to each number instead of multiplying gets (4 + 3, −3 + 3) = (7, 0). A candidate who multiplies the top number but leaves the bottom number unchanged gets (12, −3). A candidate who multiplies the bottom number but leaves the top number unchanged gets (4, −9). The correct column vector for the poster is (12, −9).
- (d) £50 — Area = 1/2 × (3.5 + 6.5) × 4 = 1/2 × 10 × 4 = 20 m². Cost = 20 × £2.50 = £50. (£100 comes from forgetting to halve the trapezium area, giving 40 m² instead of 20 m²; £65 comes from using only the longer parallel side, 6.5 × 4 = 26 m², instead of the trapezium formula; £35 comes from adding all three given lengths, 3.5 + 6.5 + 4, and treating that total as the area in square metres.)
- (a) 20 cm — The scale factor from the smaller flag to the larger flag is 5 ÷ 2 = 2.5, so the larger width is 8 × 2.5 = 20 cm. The distractor 3.2 cm comes from using the ratio the wrong way round, 8 × 2 ÷ 5 = 3.2. The distractor 11 cm comes from adding the difference between the ratio numbers (5 − 2 = 3) to the given width, 8 + 3 = 11. The distractor 40 cm comes from multiplying by 5 without dividing by 2 first, 8 × 5 = 40.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (b) $\binom{8}{3}$ — The column vector is (end − start) in each coordinate: (9 − 1, 4 − 1) = (8, 3), written as $\binom{8}{3}$. $\binom{3}{8}$ swaps the horizontal and vertical components. $\binom{10}{5}$ comes from adding the coordinates instead of subtracting them. $\binom{−8}{−3}$ comes from working out start minus end instead of end minus start.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
Build your own mix at the worksheet builder.