Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 300 cm³ — Method: the volume of a cuboid is length × width × height. Working: 2 × 10 = 20, then 20 × 15 = 300. Answer: 300 cm³. The distractors: 27 cm³ comes from adding the three edges, 2 + 10 + 15, instead of multiplying them; 400 cm² comes from working out the surface area, 2 × (2 × 10 + 2 × 15 + 10 × 15) = 400, which answers a different question and carries a different unit; 150 cm³ comes from multiplying 10 × 15 and leaving the 2 cm edge out of the calculation altogether.
- (d) 88° — Method: the three angles add up to 180°, and here it is the two equal base angles that are known, so take both of them away from 180°. Working: the two base angles come to 2 × 46° = 92°, and 180° − 92° = 88°. Answer: 88°. The distractors: 134° comes from subtracting only one base angle, 180° − 46°, and forgetting that there are two of them; 92° comes from doubling the base angle and stopping there, which is the two base angles together rather than the apex; 46° comes from assuming that all three angles of the triangle are equal to the one that is given.
- (c) AB ∥ CD only; EF not confirmed — By convention, lines marked with the same number of arrows are parallel to each other, but lines marked with a different number of arrows belong to a different, unrelated family of parallel lines. AB and CD both have a single arrow, so AB is parallel to CD. EF has a double arrow, showing it is not part of the same family as AB and CD; it may be parallel to some other line marked with a double arrow, but nothing here confirms it is parallel to AB or CD, so 'AB ∥ CD only; EF not confirmed' is correct. 'AB, CD and EF are all parallel' and 'EF is parallel to AB' both wrongly treat every arrow mark as showing the same relationship. 'None of the lines are parallel' wrongly assumes a different arrow count rules out any parallel relationship at all, when it actually just signals a different pairing.
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (a) 2 — Method: recall that the diagonals of a rhombus are always lines of symmetry, whatever its angles are. Working: a rhombus (all sides equal) always has its two diagonals as lines of symmetry, giving 2 lines of symmetry, whether or not the angles are 90°. Options: 0 wrongly assumes a non-square rhombus has no symmetry at all; 4 comes from the number of lines of symmetry a square has, mistaking this rhombus for a square; 1 comes from treating the rhombus like a kite, which has only one diagonal as a line of symmetry. Answer: 2.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (b) P, since OP = 5 and OQ = 6 — Using the distance formula, OP = √(3² + 4²) = √(9 + 16) = √25 = 5, and OQ = √(6² + 0²) = √36 = 6. Since 5 is less than 6, P is closer to the origin. Naming Q as closer, with OQ = 5 and OP = 6, has the two distances swapped around the wrong point. Naming P as closer but with OP = 6 and OQ = 5 also has the two values swapped, even though it names the right point. The distances are not equal, since 5 is not the same as 6, so P and Q are not equally distant from the origin.
- (a) 6 left, 2 up — In a column vector $\binom{x}{y}$, the top number gives the horizontal movement (negative means left) and the bottom number gives the vertical movement (positive means up), so $\binom{-6}{2}$ means 6 units left and 2 units up. '6 right, 2 up' ignores the negative sign on the top number. '2 left, 6 up' swaps the top and bottom numbers. '6 left, 2 down' ignores the positive sign on the bottom number.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (a) 6 cm — Method: a diameter runs right across a circle through its centre, so it is made of two radii laid end to end, which gives diameter = 2 × radius. Working: the radius is 3 cm, so the diameter is 2 × 3 = 6 cm. Answer: 6 cm. The distractors: 1.5 cm comes from dividing by 2 instead of multiplying by it, which is the relationship applied in the wrong direction; 3 cm comes from copying the radius straight down, treating the two words as names for the same measurement; 5 cm comes from adding 2 to the radius instead of multiplying the radius by 2.
- (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (a) (2, 6) — To translate by the vector (−3, 4), add −3 to the x-coordinate and add 4 to the y-coordinate: (5 − 3, 2 + 4) = (2, 6). A pupil who adds 3 instead of subtracting for the x-coordinate gets (8, 6). A pupil who swaps the x- and y-components of the vector gets (5 + 4, 2 − 3) = (9, −1). A pupil who subtracts both components instead of adding the y-component gets (5 − 3, 2 − 4) = (2, −2). The correct image is (2, 6).
- (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
Build your own mix at the worksheet builder.