Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (c) 21 cm — Method: the perimeter is the distance all the way round the edge, so every side is counted once and the three side lengths are added. Working: the two equal sides give 8 + 8 = 16 cm, and the third side adds 5 cm to that. Answer: the perimeter is 21 cm. The distractors: 16 cm comes from adding the two 8 cm sides and handing that total in before the third side has been included; 13 cm comes from adding one 8 cm side to the 5 cm side, as though the badge carried only the two different lengths printed on it rather than three sides; 24 cm comes from taking all three sides to be 8 cm and working out 3 × 8, which would be the perimeter only if the badge were equilateral.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (b) circumference — The distance all the way around the outside edge of a circle is called the circumference. The diameter is a straight line across the circle through the centre, so it is a length through the circle, not around it. The radius is a straight line from the centre to the edge, again a length across, not around. The area is the amount of surface inside the circle, a region, not a length at all.
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (a) Draw equal arcs from X and Y, meeting below line l. — After the first arc marks two points X and Y on line l, compasses are opened to a new radius and arcs of equal radius are drawn centred at X and at Y, so that they meet on the opposite side of l from P; joining P to that meeting point gives the perpendicular. (Joining X and Y with a straight line only retraces part of line l itself, since X and Y both already lie on it; drawing an arc centred at P through only one of X or Y repeats part of the first step instead of moving on; drawing a circle through X, Y and P does not locate the new point needed to complete the perpendicular.)
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (d) A prism — A prism has two identical, parallel polygon faces (its cross-section) joined by flat rectangular side faces, so the same cross-sectional shape runs all the way along its length — this description matches a prism. A pyramid instead narrows from one polygon base up to a single point (the apex), so it does not have two identical parallel faces. A cone has one curved surface and a single circular base narrowing to a point — no flat rectangular sides at all. A cylinder has two identical circular faces, but they are joined by a curved surface, not by flat rectangles.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (d) 4 — Method: a plane of symmetry must pass through the apex and cut the base along one of the base's own lines of symmetry. Working: a square has 4 lines of symmetry (2 through opposite edge midpoints, 2 through opposite corners), and each of these, combined with the apex, gives one plane of symmetry of the pyramid. A student who answers 2 has only found the planes through the edge midpoints, or only the ones through the corners, and missed the other pair. A student who answers 8 has doubled the correct count, perhaps confusing it with a different solid. A student who answers 1 has only spotted the one obvious front-to-back plane. Answer: 4.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (a) $\binom{-5}{-4}$ — Method: one translation followed by another is a single translation, and the two vectors are added: top to top, bottom to bottom. Working: across, 4 − 9 = −5; up, −7 + 3 = −4. Answer: $\binom{-5}{-4}$. Subtracting the second vector instead of adding it gives 13 on top and −7 − 3 = −10 underneath. Adding the top numbers correctly but subtracting the bottom ones gives −10 underneath with −5 on top. Adding 4 and 9 as though both were positive and then keeping the minus sign of the larger gives −13 on top.
- (a) 30° — Method: the exterior angles of any convex polygon add up to 360°, and in a regular polygon they are all equal, so divide 360° by the number of sides. Working: 360 ÷ 12 = 30. Answer: 30°. The distractors: 150° is the interior angle, 180 − 30, which answers for the wrong angle at the vertex; 15° comes from dividing 180 by 12, using the angles on a straight line instead of the full turn; 36° comes from dividing 360 by 12 − 2 = 10, carrying the subtraction of 2 out of the interior angle sum formula into a calculation that does not need it.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
Build your own mix at the worksheet builder.