Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) radius — The distance from the centre O to any point on the circle is the radius. The diameter is the distance right across the circle, through the centre, from one side to the other — twice the radius, not the same measurement. The circumference is the total distance around the circle, not from the centre. A chord is a line joining two points on the circle that does not have to pass through the centre at all.
- (a) arc — A curved part of a circle's circumference, between two points, is called an arc. A chord is the straight line joining those two points, not the curved part. A segment is the region enclosed between a chord and an arc, and a sector is the region enclosed between two radii and an arc — both segment and sector are regions, not curved lengths.
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (a) 106° — Angle AOC and angle AOD share the arm OA and together they make up the straight line CD, so they add up to 180°: angle AOD = 180° − 74° = 106°. 74° comes from treating AOC and AOD as vertically opposite angles, which are equal — but they are adjacent angles on a straight line, not vertically opposite. 16° comes from subtracting 74° from 90°, treating the angles as complementary. 148° comes from doubling 74° instead of subtracting it from 180°.
- (b) RHS - right angle, hypotenuse and one side equal — A right angle, the hypotenuse (13 cm) and one other side (5 cm) are equal in both triangles, so this is RHS. SAS would need the equal angle to be the one INCLUDED between the two equal sides, but the right angle at B is not between AB and the hypotenuse AC — it is opposite the hypotenuse instead, so SAS does not apply directly here. SSS needs all three sides, but only two sides are stated. ASA needs two angles, but only one angle (the right angle) is given.
- (a) 20 cm — The scale factor from the smaller flag to the larger flag is 5 ÷ 2 = 2.5, so the larger width is 8 × 2.5 = 20 cm. The distractor 3.2 cm comes from using the ratio the wrong way round, 8 × 2 ÷ 5 = 3.2. The distractor 11 cm comes from adding the difference between the ratio numbers (5 − 2 = 3) to the given width, 8 + 3 = 11. The distractor 40 cm comes from multiplying by 5 without dividing by 2 first, 8 × 5 = 40.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (d) Alternate angles are equal — The two 65° angles are on opposite sides of the line that crosses the parallel lines, in the shape of a Z, so they are alternate angles, and alternate angles between parallel lines are always equal. Corresponding angles are equal too, but they sit in matching positions at each crossing point, in the shape of an F — a different pair from the one shown here. Co-interior angles add up to 180°, not to each other's value, and they lie between the parallel lines on the same side, in the shape of a C. Angles on a straight line add up to 180°, but that rule is about two angles at a single point on one line, not about a pair of angles formed where a line crosses two parallel lines.
- (b) P, since OP = 5 and OQ = 6 — Using the distance formula, OP = √(3² + 4²) = √(9 + 16) = √25 = 5, and OQ = √(6² + 0²) = √36 = 6. Since 5 is less than 6, P is closer to the origin. Naming Q as closer, with OQ = 5 and OP = 6, has the two distances swapped around the wrong point. Naming P as closer but with OP = 6 and OQ = 5 also has the two values swapped, even though it names the right point. The distances are not equal, since 5 is not the same as 6, so P and Q are not equally distant from the origin.
- (b) £33.60 — The area of the parallelogram flower bed is base × height = 3.5 × 2 = 7 m². The cost is 7 × £4.80 = £33.60. £16.80 comes from using the triangle formula instead of the parallelogram formula: 3.5 × 2 = 7, and half of 7 is 3.5 m², then 3.5 × £4.80 = £16.80. £26.40 comes from adding the base and height, 3.5+2 = 5.5, instead of multiplying them, then multiplying by £4.80. £7.00 correctly finds the area, 7 m², but forgets to multiply it by the cost per m².
- (a) 5 — Method: add the two triangular end faces to the three rectangular side faces. Working: 2 triangular faces + 3 rectangular faces = 5 faces in total. A student who answers 6 has confused this with a cuboid's face count. A student who answers 9 has counted the edges instead of the faces. A student who answers 3 has only counted the rectangular faces and forgotten the two triangular ends. Answer: 5 faces.
- (a) (9, −5) — Method: multiply every part of q by 2, then subtract the matching part from p. Working: 2q = (−4, 6); p − 2q gives top 5 − (−4) = 9 and bottom 1 − 6 = −5. Answer: p − 2q = (9, −5). A candidate who forgets to double q first, working out p − q instead, gets (7, −2). A candidate who doubles p instead of q, working out 2p − q, gets (12, −1). A candidate who adds 2q instead of subtracting it gets (1, 7).
- (d) 310 — Method: since both turns are clockwise, add both angles to the starting bearing. Working: 245° + 50° = 295°; 295° + 15° = 310°. A student who answers 295 has only added the first turn and forgotten the second one. A student who answers 180 has subtracted both turns instead of adding them. A student who answers 320 has added the two turns as 75° instead of 65° by misreading the second turn. Answer: 310°.
- (a) 96 cm² — Method: a cube has six identical square faces, so the total surface area is six times the area of one face. Working: one face has area 4 × 4 = 16 cm², and 6 × 16 = 96. Answer: 96 cm². The distractors: 16 cm² is the area of a single face, from stopping before multiplying by the six faces; 64 cm³ comes from working out the volume, 4 × 4 × 4, which is a different measure and carries a different unit; 24 cm² comes from multiplying the six faces by the edge length, 6 × 4, instead of by the area of a face.
Build your own mix at the worksheet builder.