Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (c) It is a parallelogram but not a rectangle — Method: match the given properties to the definition of each named quadrilateral. Working: having both pairs of opposite sides parallel and equal in length is exactly the definition of a parallelogram; since none of the angles are right angles, it cannot also be a rectangle, which needs four right angles. Options: 'must be a rectangle' wrongly assumes every parallelogram has right angles; 'must be a rhombus' wrongly assumes equal opposite sides means all four sides are equal, but only the opposite pairs are stated as equal here; 'trapezium' is wrong because a trapezium has exactly one pair of parallel sides, while this shape has two pairs, so it is a parallelogram and not a trapezium. Answer: it is a parallelogram but not a rectangle.
- (a) 5 — Looking straight down on a row of 5 cubes standing side by side, each cube contributes exactly one square to the view from above, since the cubes do not overlap and none is hidden behind another — so the plan shows 5 squares in a row. "1" comes from treating the whole row as a single block instead of counting each cube. "10" comes from doubling the count, perhaps by also counting a front elevation's squares alongside the plan's. "25" comes from squaring the number of cubes (5 × 5) instead of counting them.
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (a) 33 — Method: total crates = (number of floor positions that actually have crates on them) × (the stack height). Working: there are 4 × 3 = 12 floor positions in the whole arrangement, but one corner position is left empty, leaving 11 filled positions; each filled position is stacked 3 crates high, so 11 × 3 = 33. Answer: 33. The distractors: 36 comes from forgetting to remove the empty corner and using all 12 positions (12 × 3). 35 comes from removing only one crate for the empty corner instead of the full stack of 3 (36 − 1). 11 comes from counting the filled floor positions and stopping there, forgetting that each one carries a stack 3 crates high.
- (a) SSA - not sufficient to prove congruence — The angle given, angle A, is not the angle between sides AB and BC — it is not the included angle — so this data is SSA (side, side, angle), which is not sufficient to prove congruence on its own; two triangles can share this SSA information without being congruent. SAS is wrong because the given angle is not the one included between the two given sides. ASA is wrong because only one angle (A) is given, not two. AAS is wrong for the same reason — only one angle is given, not two.
- (b) bisect the angle between the two lines — The points equidistant from two straight lines that meet lie on the angle bisector of the angle between them — every point on a bisector is the same perpendicular distance from each line, which is exactly what the angle bisector construction produces. "construct the perpendicular bisector of the two lines" confuses the bisector of a line SEGMENT between two points with the bisector of an ANGLE between two lines — a different construction for a different kind of equidistance. "construct a perpendicular from the crossing point" only gives one new line at 90° to one of the originals, not the points equidistant from both. "draw a circle centred at the crossing point" gives points a fixed distance from the crossing point, not points equidistant from the two lines.
- (d) SAS — Method: a congruence condition is named by the parts that are given equal and the order in which they sit round the triangle, so count the sides and the angles first. Working: AB = DE and AC = DF are two pairs of equal sides, and the equal angle at A and D lies between AB and AC, so the given parts read side, included angle, side. Answer: SAS. The distractors: SSS needs three pairs of equal sides, and the third pair, BC and EF, is not given — it follows from the proof rather than being part of it; ASA reads the two equal sides as two equal angles, swapping which facts are which; RHS applies only when the triangles contain a right angle and the equal pair includes the hypotenuse, and nothing here says the angle at A is 90°.
- (c) 13 cm — Method: the two given sides meet at the right angle, so they are the shorter pair and the hypotenuse comes from Pythagoras' theorem, a² + b² = c². Working: c² = 5² + 12² = 25 + 144 = 169, so c = √169 = 13. Answer: 13 cm. The distractors: 17 cm comes from adding the two sides, 5 + 12, rather than adding their squares; 60 cm comes from multiplying them, 5 × 12, which is twice the area of the triangle and not a length; 7 cm comes from subtracting, 12 − 5, as though the hypotenuse were the difference of the two shorter sides.
- (c) 18 — Rearranging F + V − E = 2 gives E = F + V − 2. Substitute F = 8 and V = 12: 8 + 12 − 2 = 18 edges. Choosing 20 comes from adding the faces and vertices but forgetting to subtract the 2 (8 + 12 = 20). Choosing 22 comes from adding the 2 instead of subtracting it (8 + 12 + 2 = 22). Choosing 16 comes from subtracting 2 twice by mistake (8 + 12 − 2 − 2 = 16).
- (c) 21 cm — Method: the perimeter is the distance all the way round the edge, so every side is counted once and the three side lengths are added. Working: the two equal sides give 8 + 8 = 16 cm, and the third side adds 5 cm to that. Answer: the perimeter is 21 cm. The distractors: 16 cm comes from adding the two 8 cm sides and handing that total in before the third side has been included; 13 cm comes from adding one 8 cm side to the 5 cm side, as though the badge carried only the two different lengths printed on it rather than three sides; 24 cm comes from taking all three sides to be 8 cm and working out 3 × 8, which would be the perimeter only if the badge were equilateral.
- (d) 2π cm — The arc is a fraction of the whole circumference. The fraction is 72 ÷ 360 = 1/5 of the circle, and the full circumference is 2 × π × 5 = 10π cm. So the arc length is 1/5 × 10π = 2π cm. Taking the whole circumference and forgetting the fraction gives 10π cm. Using 72 ÷ 180 instead of 72 ÷ 360 gives 4π cm. Treating the 5 cm as a diameter instead of a radius gives π cm.
- (d) (−4, −3) — Reflecting in the y-axis keeps the y-coordinate the same and changes the sign of the x-coordinate, so (4, −3) maps to (−4, −3). "(4, 3)" changes the sign of the y-coordinate instead, which is what happens when reflecting in the x-axis. "(−4, 3)" changes the sign of both coordinates, which is the result of a rotation of 180° about the origin, not a reflection in the y-axis. "(3, −4)" swaps the two coordinates around instead of reflecting either of them.
- (d) 1 — An isosceles trapezium has one line of symmetry, running through the midpoints of the two parallel sides. 0 would be true for a scalene trapezium, whose non-parallel sides are unequal, but this trapezium's non-parallel sides are equal, so it is symmetrical. 2 is the number of lines of symmetry of a rectangle, not a trapezium. 4 comes from wrongly applying the 'number of sides equals number of lines of symmetry' rule, which only holds for REGULAR polygons — a trapezium is not regular.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
Build your own mix at the worksheet builder.