Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
- (b) (12, −8) — Method: to multiply a column vector by a number, multiply every part of the vector by that number. Working: top number 4 × 3 = 12; bottom number 4 × (−2) = −8. Answer: 4a = (12, −8). A candidate who adds 4 to each part instead of multiplying gets (7, 2). A candidate who multiplies only the top number by 4 and leaves the bottom number unchanged gets (12, −2). A candidate who multiplies only the bottom number by 4 and leaves the top number unchanged gets (3, −8).
- (c) The midpoint of AB — M is a single point lying exactly halfway along the straight line AB, so 'the midpoint of AB' correctly describes it. 'The vertex of AB' is wrong because a vertex is a corner point where two edges or lines meet, which does not apply to a point on a single straight line. 'A perpendicular of AB' is wrong because perpendicular describes two lines meeting at right angles, not a single point. 'A plane of AB' is wrong because a plane is a flat two-dimensional surface, not a point.
- (c) 2π cm — Method: the circumference of a circle is 2πr, where r is the radius, or equivalently πd, where d is the diameter. Working: r = 1, so the circumference is 2 × π × 1 = 2π cm. Answer: 2π cm. The distractors: π cm comes from using the formula πd but substituting the radius in place of the diameter; 4π cm comes from doubling twice — changing the radius into the diameter of 2 cm and then putting that diameter into 2πr as though it were a radius; π cm² is the area of this circle, π × 1², and comes from reaching for the area formula when a distance round the outside was asked for, which is why it carries a squared unit.
- (d) 50 — The angles in any triangle add up to 180°, so x = 180 − 90 − 40 = 50. "90" comes from subtracting only the 90° angle from 180° and forgetting to also subtract the 40°. "130" comes from adding 90° and 40° together instead of subtracting them from 180°. "45" comes from halving the 90° angle instead of using the angle sum of the triangle at all.
- (c) AB ∥ CD only; EF not confirmed — By convention, lines marked with the same number of arrows are parallel to each other, but lines marked with a different number of arrows belong to a different, unrelated family of parallel lines. AB and CD both have a single arrow, so AB is parallel to CD. EF has a double arrow, showing it is not part of the same family as AB and CD; it may be parallel to some other line marked with a double arrow, but nothing here confirms it is parallel to AB or CD, so 'AB ∥ CD only; EF not confirmed' is correct. 'AB, CD and EF are all parallel' and 'EF is parallel to AB' both wrongly treat every arrow mark as showing the same relationship. 'None of the lines are parallel' wrongly assumes a different arrow count rules out any parallel relationship at all, when it actually just signals a different pairing.
- (d) Equilateral — Method: triangles are named by their sides — three equal sides, exactly two equal sides, or no equal sides — or by their angles. Working: the triangle described has three equal sides, which is the equilateral case, and each of its angles is 60°. Answer: equilateral. The distractors: isosceles is the name for a triangle with exactly two equal sides, and is chosen by candidates who remember only that it is the 'equal sides' word; scalene is the name for a triangle whose sides are all different, so it is the opposite of what is described; right-angled classifies a triangle by an angle of 90° rather than by its sides, and is chosen by candidates who recall that the angles of this triangle are all equal and take 'equal angles' to mean 'right angles'.
- (c) 52° — When two straight lines cross, the angles opposite each other at the crossing point are vertically opposite and are equal. Ray OQ is opposite ray OP and ray OS is opposite ray OR, so angle QOS is vertically opposite angle POR. Therefore angle QOS = 52°.
- (b) 2 cm — Method: a diameter is made of two radii end to end, so going back from a diameter to a radius undoes that doubling, which gives radius = diameter ÷ 2. Working: the diameter is 4 cm, so the radius is 4 ÷ 2 = 2 cm. Answer: 2 cm. The distractors: 8 cm comes from multiplying by 2 instead of dividing by it, the relationship applied in the wrong direction; 1 cm comes from halving twice, once to reach the radius and then once more as though a second halving were called for; 0.5 cm comes from writing the division upside down as 2 ÷ 4 rather than 4 ÷ 2.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (d) Base angles of an isosceles triangle are equal — DE = DF, so triangle DEF is isosceles with DE and DF as the two equal sides. The base angles opposite those equal sides, angle E and angle F, are therefore equal to each other. Angle F = 58°. A student who instead quotes 'Angles in a triangle sum to 180°' has picked a true fact about triangles, but that fact finds a missing angle from the other two — it does not explain why two angles are equal to each other. A student who quotes 'Angles on a straight line sum to 180°' has confused this with a straight-line angle fact, but no straight line of angles is described in this triangle.
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
- (a) a cone — A cone, viewed from directly above, shows its circular base as a circle; viewed from the front, its curved surface narrows to a point at the apex, giving a triangle outline — so a circle plan with a triangle elevation identifies a cone. "a cylinder" has a circular plan too, but its front elevation is a rectangle, not a triangle, since its sides run straight up rather than narrowing to a point. "a sphere" gives a circle from every direction, plan and every elevation alike, not a triangle from the front. "a square-based pyramid" gives a triangle from the front, but its plan view is a square, not a circle.
Build your own mix at the worksheet builder.