Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 2 cm — Method: a diameter is made of two radii end to end, so going back from a diameter to a radius undoes that doubling, which gives radius = diameter ÷ 2. Working: the diameter is 4 cm, so the radius is 4 ÷ 2 = 2 cm. Answer: 2 cm. The distractors: 8 cm comes from multiplying by 2 instead of dividing by it, the relationship applied in the wrong direction; 1 cm comes from halving twice, once to reach the radius and then once more as though a second halving were called for; 0.5 cm comes from writing the division upside down as 2 ÷ 4 rather than 4 ÷ 2.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (a) (2, 6) — Adding the vector to the point gives the new position: (5 + (−3), 2 + 4) = (2, 6). '(8, 6)' comes from adding 3 instead of subtracting it, treating the top number as positive. '(9, −1)' comes from swapping the two components of the vector before adding them. '(2, 2)' applies the horizontal movement correctly but forgets to add the vertical movement.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (c) 6 — A cuboid has six flat faces: a top, a bottom and four sides. Count each flat surface once: top, bottom, front, back, left, right — six faces in total, so the answer is 6. Choosing 8 counts the vertices (corners) instead of the faces. Choosing 12 counts the edges instead of the faces. Choosing 4 counts only the four side faces and forgets the top and the bottom.
- (a) A square's diagonals are equal in length — A square has two pairs of parallel sides, four equal sides, and diagonals that are equal in length and cross at right angles. This tile's diagonals are not equal, so it is a rhombus that is not a square.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (a) 5 — For any regular polygon, the order of rotational symmetry is always equal to the number of sides, which is also equal to the number of lines of symmetry. Since this polygon has 5 lines of symmetry, it has 5 sides, so its order of rotational symmetry is 5. 4 comes from subtracting one from the number of sides by mistake. 6 comes from adding one to the number of sides by mistake. 10 comes from doubling the number of lines of symmetry instead of using it directly.
- (a) Triangular-based pyramid (tetrahedron) — A solid with 4 triangular faces, 4 vertices and 6 edges is a triangular-based pyramid, also called a tetrahedron. A triangular prism also has triangular faces, but it has 2 triangular faces plus 3 rectangular faces, 6 vertices and 9 edges — the extra rectangular faces and edges rule it out here. A square-based pyramid has 5 faces (one square, four triangles), 5 vertices and 8 edges, which does not match. A cube has 6 faces, 8 vertices and 12 edges, all much higher than the numbers given. The solid described is a triangular-based pyramid.
- (d) 10 — Method: the distance between two points is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal and vertical gaps, so work out both gaps first, handling the negative coordinates carefully, and then apply Pythagoras' theorem. Working: the horizontal gap is 5 − (−3) = 5 + 3 = 8 and the vertical gap is 4 − (−2) = 4 + 2 = 6. Then d² = 8² + 6² = 64 + 36 = 100, so d = √100 = 10. Answer: 10. The distractors: 14 comes from adding the two gaps, 8 + 6, instead of adding their squares and taking the root; 100 comes from stopping at the sum of the squares and never taking the square root; 50 comes from reaching 100 correctly and then halving it instead of taking its square root, a candidate who has read the last step as “halve” rather than “root”.
- (a) 8π cm — Circumference = 2πr. Substitute r = 4: circumference = 2 × π × 4 = 8π cm. Using r in place of 2r (halving the formula) gives 4π cm. Using the area formula πr² in place of the circumference formula gives π × 4² = 16π cm. Multiplying 2 × 4 without including π at all gives 8 cm.
- (a) SSA - not sufficient to prove congruence — The angle given, angle A, is not the angle between sides AB and BC — it is not the included angle — so this data is SSA (side, side, angle), which is not sufficient to prove congruence on its own; two triangles can share this SSA information without being congruent. SAS is wrong because the given angle is not the one included between the two given sides. ASA is wrong because only one angle (A) is given, not two. AAS is wrong for the same reason — only one angle is given, not two.
- (d) 1 — At 45° the right-angled isosceles triangle has both shorter sides equal, so tan 45° = opposite ÷ adjacent = 1 ÷ 1 = 1. 0 is the value of tan 0° (mixing up the two angles). √3 is the value of tan 60°. √3/3 (equivalent to 1/√3) is the value of tan 30°.
- (b) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides. A parallelogram has two pairs of parallel sides, not one, so it does not fit the definition. A kite has no parallel sides at all. A rhombus, like a parallelogram, has two pairs of parallel sides. The correct name is trapezium.
- (a) the lens-shaped region where the two circles overlap — The region within 30 km of the ship is a circle of radius 30 km around the ship; the region within 20 km of the lighthouse is a circle of radius 20 km around the lighthouse. Since 30 + 20 = 50 km is more than the 40 km between them, and 30 − 20 = 10 km is less than 40 km, the two circles genuinely overlap, in a lens-shaped region where both conditions hold at once. "the whole smaller circle, since it fits inside the larger one" would only be true if the 40 km distance between the centres were small enough for one circle to swallow the other, which it is not here. "no overlap — 30 km and 20 km don't add to 40 km" wrongly assumes the two radii must add up to exactly the distance between the centres for an overlap to exist; any total greater than that distance is enough. "a straight strip, exactly halfway between the two" confuses this with an equidistant locus, which is a different problem from the one asked here.
Build your own mix at the worksheet builder.