Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 5√3 m — The cable, the pole and the ground form a right-angled triangle: the ground distance (5 m) is adjacent to the 60° angle, and the height of the pole is opposite it, so height = 5 × tan 60° = 5 × √3 = 5√3 m. 5√3/2 m comes from using sin 60° = √3/2 instead of tan 60°. 5/√3 m comes from using tan 30° = 1/√3, the reciprocal-angle value, instead of tan 60°. 10√3 m comes from doubling the correct height by mistake.
- (d) RHS — Both triangles have a right angle, their hypotenuses are equal, and one further pair of sides (AB and DE) are equal, exactly the RHS condition, so RHS is correct. SAS needs two sides and the angle between them; here the right angle at B is not between the hypotenuse and AB, so this is not a valid SAS setup, making SAS wrong. SSS needs three pairs of equal sides, but only two sides are given here, so SSS is wrong. ASA needs two angles and the side between them, but only one angle, the right angle, is given, so ASA is wrong.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (a) 33 — Method: total crates = (number of floor positions that actually have crates on them) × (the stack height). Working: there are 4 × 3 = 12 floor positions in the whole arrangement, but one corner position is left empty, leaving 11 filled positions; each filled position is stacked 3 crates high, so 11 × 3 = 33. Answer: 33. The distractors: 36 comes from forgetting to remove the empty corner and using all 12 positions (12 × 3). 35 comes from removing only one crate for the empty corner instead of the full stack of 3 (36 − 1). 11 comes from counting the filled floor positions and stopping there, forgetting that each one carries a stack 3 crates high.
- (a) 110° — Method: in a parallelogram the two angles at the ends of one side are co-interior angles between a pair of parallel sides, so they add up to 180°. Working: angle A + angle B = 180°, so angle B = 180° − 70° = 110°. Answer: 110°. The distractors: 70° comes from applying the rule for opposite angles of a parallelogram, which are equal, to two angles that are next to each other instead; 20° comes from treating the two angles as complementary and working out 90° − 70°; 290° comes from using the 360° angle sum of a quadrilateral and taking away only the one angle that is given, 360° − 70°.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (b) (3, −1) — Method: find the distance from the point to the mirror line, then place the image the same distance on the other side of the line. Working: B is 5 − 2 = 3 units above the line y = 2, so its image is 3 units below the line, at y = 2 − 3 = −1, giving (3, −1); the x-coordinate does not change, since the mirror line is horizontal. Options: (3, −5) comes from reflecting in the x-axis (y = 0) instead of the line y = 2; (−3, 5) comes from reflecting in the y-axis instead of a horizontal line; (3, −4) comes from doubling the distance from the line instead of reflecting it, giving 2 − 2×3 = −4. Answer: (3, −1).
- (c) 18 — Rearranging F + V − E = 2 gives E = F + V − 2. Substitute F = 8 and V = 12: 8 + 12 − 2 = 18 edges. Choosing 20 comes from adding the faces and vertices but forgetting to subtract the 2 (8 + 12 = 20). Choosing 22 comes from adding the 2 instead of subtracting it (8 + 12 + 2 = 22). Choosing 16 comes from subtracting 2 twice by mistake (8 + 12 − 2 − 2 = 16).
- (b) 4 — The scale factor is the distance from the centre to the image, divided by the distance from the centre to the object: (5 − 1) ÷ (2 − 1) = 4 ÷ 1 = 4. (2.5 comes from dividing the raw y-coordinates, 5 ÷ 2, without first subtracting the centre's coordinate; 3 comes from subtracting the two distances instead of dividing them; 0.25 comes from dividing the distances the wrong way round.)
- (b) 7 units right and 2 units down — In the column vector $\binom{7}{−2}$, the top number gives the horizontal movement and the bottom number gives the vertical movement. A positive top number (7) means 7 units to the right, and a negative bottom number (−2) means 2 units down. The distractor '7 units left and 2 units up' reverses both signs, as if the vector were $\binom{−7}{2}$. The distractor '2 units right and 7 units down' swaps the horizontal and vertical numbers around. The distractor '7 units right and 2 units up' gets the horizontal movement correct but reverses the sign of the vertical movement.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (a) Square-based pyramid — A solid with one square base and four triangular faces meeting at a single apex above the base is a square-based pyramid. A triangular prism has two triangular faces and three rectangular faces, not a square base with four triangles, so that is a different solid. A cube has six square faces, and a cuboid has six rectangular faces — neither has any triangular faces at all. The solid described is a square-based pyramid.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (d) 10 — Method: the distance between two points is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal and vertical gaps, so work out both gaps first, handling the negative coordinates carefully, and then apply Pythagoras' theorem. Working: the horizontal gap is 5 − (−3) = 5 + 3 = 8 and the vertical gap is 4 − (−2) = 4 + 2 = 6. Then d² = 8² + 6² = 64 + 36 = 100, so d = √100 = 10. Answer: 10. The distractors: 14 comes from adding the two gaps, 8 + 6, instead of adding their squares and taking the root; 100 comes from stopping at the sum of the squares and never taking the square root; 50 comes from reaching 100 correctly and then halving it instead of taking its square root, a candidate who has read the last step as “halve” rather than “root”.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
Build your own mix at the worksheet builder.